In a dc machine 4 pole lap winding is used. The number of parallel paths are?

Q: Determine the value of vx as labeled in the circuit of Fig. 3.61. 500 mA 2 Ω 2.3 V 7.3 Ω | FIGURE…

A:

Q: Define fan-in and fan-out of a gate.

A:

Q: 14. Calculate the output voltage, V, in the circuit of Fig. 10.73. V₁ = 0.1 V 20 ΚΩ 400 k www 20 kn…

A: Given data:  The circuit diagram is shown below,

Q: a frequency of 1.5 kHz the open circuit impedance of a length of transmission line is 800∠−50◦ and…

A: We need to find out the characteristics impedance of given line .

Q: RT 6. Find the total resistance of the following circuit R₁60 R₂90 R, 60 R720 R, on 6

A: Given circuit:

Q: 4. The two wattmeter readings for a three-phase balanced load are 175 W and -35 W. Knowing that the…

A: Given, In power measurement using two wattmeter method in a three phase balanced load, the readings…

Q: How to convert 11.2 + j23.66 Magnitude with angle form?

A:

Q: The variable AC voltage available from the power module is a (A) single-phase (B) 2-phase balance…

A: Variable ac voltage is the output of a variac transformer. To meet the load requirements various…

Q: A short shunt compound generator has an armature, shunt field, and series field resistances of 0.05…

A:

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistance to be used is…

A:

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistance to be used is…

A: This is a circuit of RC phase shift oscillator. The detailed solution is given in the next step.

Q: 5. If a current transformer has an RCF of 1.0028 and a PACF of0.9955, the value of TCF is A. 0.9972.…

A: This is a problem of instrumentation. The solution is given in the next step.

Q: 3. Determine I₁, I2 and 13 using mesh analysis. Show complete solution using either substitution.…

A:

Q: Low Pass Filter

A: 1. Low Pass Filter (LPF) :  Eliminates the high frequency.components present in the input analog…

Q: Design fixed-bias configuration circuit. Voc-12 V, B-100, Zi-1.1 k2, I-244 and Av=-280.

A:

Q: Calculate the missing values in the table. Round all values to the nearest whole number when…

A: We need to find out number of turns and voltage for given transformer . We know transformer ratio ,…

Q: Question In an instrument transformer of 500 turn burden on secondary side Zs = 10, on the secondary…

A: Given- No. of turns N=500, Burden- Zs=1 Ω, Frequency f=50 Hz, To Find- The core flux in the CT.

Q: B: A three phase transmission line with 65 km long, 50 Hz. Each phase has a conductor of 0.83 cm as…

A:

Q: Questions to be answered in your Brightspace Discussion: Part a: The number of transistors per IC in…

A: According to the question,

Q: Q- A single-phase half-controlled rectifier is driving a separately excited dc motor. The dc motor…

A: Given- Back emf constant = 0.5 V/rpm , Armature current (I) = 5A , firing angle α =30°.   To find -…

Q: Determine the inverse z-transform of the following: (a) (b) (c) Xa(z) X₂(z) = Xc(z) - 1 1-z-¹ 1+z=2…

A: Given : Xaz = 1-z-11-16z-1-13z-2Xbz = 1+z-21+0.8z-1+0.64z-2Xcz = 1+z-11-0.75z-1+0.125z-2 Find :…

Q: Design the phase shift oscillator to oscillate at f=22.5kHz. the minimum resistance to be used is…

A:

Q: Q1 + 1 v v=0 v = 10e-5000 kV, 20 If the voltage and the current at the terminals of the element…

A: In this question we need to find a power and energy of the given element at t=1ms

Q: With neat sketch explain working of van de Graff generator      Note : strictly no copy paste…

A: It is asked to sketch and explain the working of Van de Graaff generator.

Q: Question 4 Evaluate the following Inverse Laplace transforms. 1 C-₁ (₁²2+3x+2)

A: Given: L-11s2+3s+2

Q: In an experiment to determine the breakdown strength of 2 types of a transformer oil using standard…

A: Given, The observation of two different types of oils is shown below,

Q: 1. What is an electric field line? What are equipotential surfaces? Are they necessarily physical…

A: 1).  Electric field line: An electric field line is an imaginary line or curve drawn through a…

Q: Determine all the mesh currents using mesh analysis. Show complete solution using either elimination…

A: This is a problem of mesh analysis. The detailed solution is given in the next step.

Q: A 3-core cable (3-Øline) transfer 33 kV and 50 Hz, If the conductor-earth capacitance (Ce) is 0.23…

A: Given data, Capacitance Ce=0.23 μF Current Ic=22.26 A

Q: 5. What is the sine wave equation for the following time and frequency domains? time domain y = ?…

A: Given: Graph

Q: A homeowner consumes 800 kWh in January. Determine the electricity bill ____ for the month using the…

A: In this question we need to find the electricity bill for the given load

Q: G(s) s? + s + 2 + (s + 1)3 S =

A:

Q: For the circuit shown, v1 = -3 V, v2 = 6V, determine the value of the current i V1 692 V2 $₁0

A: Given data, Circuit diagram is given as,

Q: Find Vx. 60 V O 8 V Δαν Ο τον την + 5A ww 8 Ω Μ 4 Ω 10 Ω 2Ω +

A:

Q: These are laminated steel core containing current-carrying copper wires; and in general if it is the…

A: Given: These are laminated steel core containing current-carrying copper wires; and in general if it…

Q: B: A three phase transmission line with 65 km long, 50 Hz. Each phase has a conductor of 0.83 cm as…

A: Given: Line Length = 65kmfrequency (f) = 50 HzConductor Diameter (D) = 0.83 cmConductor Radius (r) =…

Q: 3. 20 so 15≤ 305 V₂ = ? 6 12 Find V₁ = ? no 20 10 -5V

A: Given:  Find: V6 = ?

Q: λ A lossless transmission line having 50 characteristic impedance and length is 4 short-circuited at…

A: Given- Characteristics impedance= 50 ohm Length of lossless transmission line = λ4 Source voltage =…

Q: 3. The open loop transfer function of a unity feedback system is given by G(s) = k (s+2)(s+3)…

A: Q.3 : The open loop transfer function of a unity feedback system is given by : Gs=ks+2s+3…

Q: * The voltage Vout in the circuit shown is

A: Given data, Circuit diagram is given as,

Q: 1. Consider the circuit below. Using operator notation for derivatives, write down a matrix equation…

A: The circuit is given as Apply KCL at node a,is-i1-i2=0    ...1Apply KCL at node b,i2+i4-i5=0…

Q: The figure shows a 4 to 1 MUX to be used to implement the sum S of a 1-bit full adder with input…

A: Solution !!

Q: 2.14 Calculate the value of/ in the circuit in Fig. P2.14. 9V 402 C 492 +- -3V 201 2018

A: Circuit is given as:

Q: Find the zeros state response

A:

Q: Q2 1 20 If the current at the terminals of the element shown above is defined as: i = 0, i =…

A: In this question we need to find the expression of charge accumulating and charger at 1ms

Q: 6. Build the following circuit and take a picture of it. Disconnect the power source. What did the…

A: Since you have posted multiple questions, we will solve the first question for you. If you require…

Q: 2 A Triac control of a three-phase, 30 kW, 400 V, 50 Hz, six-pole, star- connected squirrel-cage…

A: NOTE: “Since you have asked multiple question, we will solve the first question for you. If you want…

Q: Electrical Engineering Find the resultant capacitance Ceq - 6 pF 0μF HH [Select] 6 μF 6pF 6 μF 6 µF…

A:

Q: Q2: A three-phase Transmission line with 1,956 cm diameter conductor, the corona takes place if the…

A:

Q: From the circuit below, Calculate A. Frequency of Oscillation B. Period of Oscillation

A: The circuit diagram is shown below,

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.