In a laboratory test of an aquifer material a fully saturated sample of volume 5 liters was taken and its initial weight of 105 N was recorded. When allowed to drain completely it recorded a weight of 97 N. The sample was then crushed dried and then weighed. A weight of 93 N was recorded at this stage. Calculate the specific yield and relative density of the solids.

In a laboratory test of an aquifer material a fully saturated sample of volume 5 liters was taken and its initial weight of 105 N was recorded. When allowed to drain completely it recorded a weight of 97 N. The sample was then crushed dried and then weighed. A weight of 93 N was recorded at this stage. Calculate the specific yield and relative density of the solids.

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter6: Hydraulic Conductivity

Section: Chapter Questions

Problem 6.12P

See similar textbooks

Similar questions

The hydraulic conductivity of an aquifer is 0.005 cm/sec, the hydraulic gradient is 0.02, and the porosity is 0.2. What is the specific discharge, q, in this aquifer? use Darcy's law q=Ki Calculate the velocity at which dissolved salt could move through this aquifer. Assume the aquifer is 5 meters thick (b). What it is its transmissivity? Transmissivity T = Kb aquifer thickness. What is the discharge per unit of distance perpendicular to the groundwater flow? (bq). Use the equation given in the problem statement discharge per unit width = bq .
A 1.4-m3 sample of moist soil weighs 2600 kg. The water content is 14%. Assume ρs=2.70 Mg/m3. Fill in the phase diagram below (see image).
6. A mining process discharges a silty water into a clean brook at the rate of 5 cubic meters per minute. The silt content is 200 200 mg/L. What is the concentration in the brook during the rainy season (the brook flows at 50 cubic meters/min), and during a severe dry spell (the brook flows at 5 cubic meter/min)?
In a permeability test with constant load in the laboratory, the following are given: L = 250 mm and H = 105 cm². If the value of k is 0.014 cm/s and a flow rate of 120 cm³/s must be maintained through the soil, what is the difference in charge, h, across the sample? determine also the percolation rate under the test conditions.
The following data relate to a pump-out test: Diameter of well = 24 cm; Thickness of confined aquifer = 27 m; Radius of circle of influence = 333 m; Draw down during the test = 4.5 m; Discharge = 0.9 m^3/s.What is the permeability of the aquifer in mm/s?
In a constant head permeability test a sample 10 cm long was tested in a permeameter with an inside diameter of 6 cm. Under a head of 60 cm, a discharge of 140 cu.cm. was collected in 40 seconds. Compute the coefficient of permeability.
A limestone core sample is saturated 100% with water. Calculate the absolute permeability of the core sample if the water is flowing at 4.15 cubic centimetres per second. The length of the core sample is 13.61 centimetres and its diameters if 7.13 centimetres. The pressure differential across the core sample is 25 atmospheric pressure and the water viscosity is 1.1 centipoises. Explain a method of how the permeability of this reservoir can be improved.
An experiment was conducted to determine the hydraulic conductivity of an artesian (i.e., pressured confined aquifer). The piezometric heads at two points 150 m apart were found to be 60 m and 56 m above a datum (reference level). A tracer injected into the first piezometer was observed after 20 hours in the second well. A test on porosity of a sample of the aquifer shows that α = 24%. a) What are the Darcy velocity (q) and seepage velocity (v) of groundwater flow. b) What is the conductivity of the aquifer?
Calculate the carbonate and non-carbonate hardness of the given water sample.
A well in an unconfined aquifer is pumped at the rate of 50 L/s ( 800 gal/min.). The thickness of the aquifer is 30 m. and the elevation of the phreatic surface is 25 m. above the underlying aquiclude at an observation of well 20 m away from the well and 34.6 m above at a well 50 m. away. What is the value of K for this aquifer?
Hydrometeorology (Ground Water) Recuperation Test A recuperation test was carried out on a 1-meter diameter clay open well. Calculate the yield in m3/hr of the said well at a specific point in time when the depression head is 0.8 m. Show your solution
The hydraulic conductivity of a homogeneous sandy/gravelly aquifer is 3 x 10-2 cm/sec. The hydraulic gradient (groundwater surface slope) of the phreatic (water table) aquifer is 0.009 and the aquifer's effective porosity is 0.28. Calculate the following : The average velocity of dissolved salt (travels at same speed as groundwater). Enter your answer in meters/year, to the nearest whole meter/year.