Answered: In a parallel RLC circuit, the quality…

Engineering

Electrical Engineering

In a parallel RLC circuit, the quality factor at a resonance is given by

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 4RQ: A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant...

See similar textbooks

Related questions

Q: 9- In AM DSB/SC, the carrier is suppressed in order to: a) simplify the receiver design b) reduce…

A: Given Multiple choice questions based on modulation techniques. Please find the below attachment…

Q: The magnetizing equivalent circuit of transformer can be found by open circuit test O True O False

A: Open circuit test is conducted in the presence of rated flux in the transformer core. In order to…

Q: The 96 prismatic lithium-ion battery cells were manufactured in Korea and the Scottish firm Axeon…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Find the current density when the magnetic flux density is equal to 50 μ unit and the differential…

Q: For the system in Fig. 14.87, find the sinusoidal expression for the unknown voltage v if ein 60…

A: In the given questions, we need to calculate voltage Va. Va can be calculate by converting the…

Q: 17. According to the Len's Law, the direction of the magnetic field induced by a current always have…

A: Given that

Q: A non alternating periodic waveform has shown in figure. Find its form factor. ↑ 1A 0.5 A 10 20 40…

A: Given graph is:-

Q: The transmissivity of transparent material 15 mm thick to normally incident light is 0.80. If the…

Q: e a short note on production and consumption pattern of primary energy in India.

A: production pattern of primary energy in India : In India most of the primary energy about 75 % to…

Q: homework A Junction FET has Y = 50, when VGS =0 what Vos at point where ID becomes DS Constant ?

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A Certain JFET VGS(off) 1

A: FET ( field-effect transistor)-This has three terminals source gate and drain. It is a current…

Q: 3) "JK" type flip flops with asynchronous counter counting as-1-2-3-4-5-6-1-2-3-4-..." Design and…

A: Asynchronous counter having sequence of 1-2-3-4-5-6-1-2-3-4.... Using JK flipflops.

Q: 22. Calculate the charge stored on a 3 - pF capacitor with 20 V across it. a. 0.150 pC b. 0.06 nC C.…

Q: A dc separate excited generator operate at speed = 1500 R.P.M at a certain excitation gives a…

Q: Find even and odd X (+) = sin(t) + Sin(t)• Cost) + sinA) + cos(t)

A: Given A signal ,we need to determine the even and odd signal. Please find the below attachment for…

Q: 36. The induced emf in a material opposes the flux produc a. Faraday's Law b. Ampere's Law C.…

A: In this question we will write about law for induced voltage....

Q: The value of the equivalent resistance in the circuit shown in: Figure is R1=90 O 21 O 15.14 O 0.095…

Q: ra FET, graph is drawn by taking voltage VGs in X axis and drain current in Y s, if the value of X…

Q: Evaluate the following complex numbers: (a) [(5 + j2)(−1 + j4) − 5/60°]* 10 + j5 + 3/40° (b) +…

A: (a) The given expression is, z=(5+j2)(-1+j4)-5∠600* On converting all the terms into a rectangular…

Q: Consider the block diagram of a machine-tool control system D(s) R(s) K s+1 Y(s) Compute the minimal…

A: Given Block diagram of control system. We need to determine the k value such that steady state…

Q: Provide the zero and pole, that is available for the circuit. Calculate the frequency fo

A: For the given series RLC circuit we need to calculate the value of resonance frequency, poles and…

Q: For the circuit shown: 1. Find the value of "Rc" that makes the circuit in resonance. 2. Calculate…

A: Given data : Voltage(VT)=10∠0°VResistance(RL)=8ΩInductance(XL)=j6ΩCapacitance(XC)=-j5Ω

Q: 24. A ceramic capacitor has an effective plate area of 4 cm² separated by 0.1 mm of ceramic of…

Q: 1. Create and simplify the mechanical rotational system within the armature (dc shunt generator)…

A: A shunt generator is a type of dc generator in which the field winding is connected in parallel with…

Q: Q1) A) What is bus? How many ways to construct bus system. (explain with example for one type)

Q: A 20 μF capacitor is series connected with a variable inductor and a 10V, 160 cycles source. Given…

Q: Equivalent electrical parameter of MMF in electric circuits. a. Voltage b. Resistance c.…

A: In this question we will write equivalent electrical parameter of MMF in electric circuits...

Q: A three-phase A-connected generator has an internal impedance of of 9 + 190m2/p. Whe he load is…

A: Solution- Given, Zin =Z03=9+j903×10-3 ohmZin = 3+j30×10-3 ohm ∆ connected load,ZL…

Q: for the electron Find the momentum of the crystal for the electron if you know that its wavelength…

A: The wavelength of the electron is, λ=1.2×10-10 m Using the De Broglie's relation, the wavelength is…

Q: Q1) Choose the Correct answer: 1- For the circuit shown below, if Zo is equal to 750. The value of…

A: Note: Since the given questions are not interlinked to each other hence according to the guidelines…

Q: potentiometer is R1 E 5 ΚΩ 120 V (0 - 120) V (0-10) V O (0-60) V O (0-20)V (0 - 80)V None of the…

A: This question belongs to electrical instrumentation and measurement . It is based on the concept of…

Q: 15. Which of the following is TRUE? a. A conductor has a large amount of energy gap between…

Q: 6. A Thevenin de equivalent circuit always consists of an equivalent.. a. AC voltage source b.…

A: Network theorems are very useful in analysis of various circuits.

Q: * The 0.6 m rod of a metal elongates 0.67 mm on heating from 35 to 90 C. Determine the value of the…

A: We need to find out the coefficient for length

Q: For a Baudrate of 100 bauds/sec for a 4PSK signal, the bitrate is _bps. Select one: O a. None O b.…

A: Baud rate is defined as no. of bits transferred per second.

Q: Question 25 Determine the resonant frequency of an RLC series circuit with 150 resistor, 20μF…

Q: A single phase 220/6 Volt, 50 Hz transformer has a rated primary current = 0.5 A. its maximum…

Q: 11. Find the magnetic flux density when a flux is equal to 28 x 108 Maxwell is enclosed in an area…

A: We need to find out magnetic field

Q: The open circuit characteristics of dc machines is the relation between. O Torque and speed at…

A: The open circuit characteristics of dc machines is the relation between.

Q: Instructions Transform the following Boolean expression into a Logic Diagram and convert into NOR…

A: given here a boolean expression and asked to draw the logic diagram and NOR gate implementation

Q: A conductor has a conductance of 70μS is used to supply a load. Find its equivalent resistance.…

A: Q.21) ans (d) 14.3 K ohm Since conductance is defined as reciprocal of resistance . R = 1/G

Q: Please solve asap my deadline is very close

Q: (1-a) Build a half-wave rectifier circuit with a single diode to perform the charging function.…

Q: Illustrate the working of differential pressure transmitter with neat diagram.

A: An electrically insulating fill fluid (often a liquid silicone compound) transfers motion from the…

Q: 14. Find f(t) of the following F(s) = 20s² + 141s +315 s(s² + 10s +21)

A: In this question we will find f (t) with the help of inverse laplace transform....

Q: Given the following second order circuit, find the initial conditions for the dynamic elements i (0)…

A: We need to find out inductor current and voltage across capacitor for given circuit .

Q: Consider a band-limited CT signal xc(t). It is properly sampled, being spaced T seconds apart, and…

A: Consider a band-limited continuous-time signal xc(t). It is properly sampled, being spaced T seconds…

Q: and b) Draw the S.F.G and obtain the transfer functions R₁ using Mason's gain formula. R₁(s) G₁ H₁ 2…

Q: 41. Let J = 10y²z a¸ − 2x²y a₂ + 2x²z α₂; and find the total current crossing the surface x = 3, 2 ≤…

Q: (a) The typical starting current for induction motor (i.e., at s=1) is five to eight times of the…

A: Induction motor:- It is a AC motor that runs at lower speed than synchronous speed so it is also…

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

100%

Select the letter of the correct answer from the given problem.

*Kindly provide a CLEAR and COMPLETE solution* (Answer should be typewritten)

*Please answer it ASAP

Question 44
In a parallel RLC circuit, the quality factor at a resonance is given by
O 1/R[V(L/C)]
O 1/R[V(C/L)]
R√(C/L)
O RV(L/C)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

746. (NEW) Some linear system has a transfer function 9(s+2)/(s+4). Determine the Bode plot gain (dB) and phase at 9.00 rad/sec.
A coil of inductance 0.20H and resistance 60[1] is connected in parallel with a 20μF capacitor across a 20V, variable frequency supply. Calculate (a) the resonant frequency, (b) the dynamic resistance, (c) the current at resonance and (d) the circuit Q-factor at resonance.
A coil of resistance 10.05 ohms and inductance 400 mH is connected in series with a 0.396µF capacitor. Determine (a) the resonant frequency, (b) the resonant Q-factor, (c) the bandwidth and the lower and upper half power frequencies.
Plot the bode diagram for the following transfer function and obtain gain margin and phase margin. G(s) = 10/s(1+0.4s)(1+0.1s)
70) A coil of resistance 25 Ω and inductance 150mH is connected in parallel with a 10 μF capacitor across a 60V, variable frequency supply. Calculate (a) the resonant frequency, (b) the dynamic resistance, (c) the current at resonance, (d) the Q-factor at resonance.
G(S) =100(s+10)/s(s+5)(s+20) 3. Construct the bode Plot of the system using the semilog paper provided.4. Determine the Gain margin and phase margin of G(jw)5. Using the Bode diagram determine if system is stable.
A coil of inductance 0.20H and resistance 60 ohm is connected in parallel with a 20μF capacitor across a 20V, variable frequency supply. Calculate (a) the resonant frequency, (b) the dynamic resistance, (c) the current at resonance and (d) the circuit Q-factor at resonance.
A transfer function is given by H( f )= 100 1+j( f/1000 ) Sketch the asymptotic magnitude and phase Bode plots to scale.
For the two circuits below, find the following: Resonant frequency ω0 (krad/s) Bandwidth (rad/s) Quality Factor Q
A parallel combination of R, L, and C Where R=12 kilo ohms, L= 45 mH, and C= 2 microfarad is connected in series with a 4 kiloohm-resistor and a voltage source of 80 V. The resonant frequency is and the quality factor is?
Sketch the Bode plot for the given function. G(s) = K/ S(S+3)(S+6) Determine the value of (i) Gain cross over frequency (ii) Phase cross over frequency (iii) Gain margin (iv) Phase margin (v) Value of k for stability
Dear Tutor please help me out in this question, your efforts will be appreciated A system is represented by a transfer function as follows: G (s) = 10( s + 3 ) / s(s + 2)(s2 + s + 2) a. Get the frequency response of the above system. b. Sketch Bode diagram of the system above. c. Using the obtained Bode diagram, determine the stability