Answered: In an RLC circuit, if the Neper…

In an RLC circuit, if the Neper frequency is 50000, L = 10 mH, and R = 1000, the resonant frequency would be: O A. None of the other choices are correct O B. 10000 O C. 20000 O D. 50000 O E. 100000

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 4RQ: A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant...

See similar textbooks

Related questions

Q: plz solve it within 30-40 mins I'll give you multiple upvote hand written

A: Here the concept related to the system stability is discussed.

Q: Find the input resistance, voltage gain, current gain, and power gain for the amplifier in Figure…

A: Calculation of input resistance, Voltage gain, current gain and power gain for the following…

Q: Three important parts of an electric motor are marked A, B and C in the diagram shown below. Choose…

A: In this question electric motor are marked A, B and C in the diagram . We write the name of parts…

Q: 5. Using inverters, OR gates, and AND gates, construct a combinatorial circuit that produces the…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: For the root locus shown below, the break in point is -25 -20 -15 -10 O-18 O -10+9i -10 10

Q: system produced, 3 poles in the left-half plane, 4 in the jw-axis and 0 in the right-half plane. The…

A: We need to select correct option for given system

Q: A type of cumulatively-compounded dc generator where the full-load terminal voltage is the same as…

A: Correct option is (b) flat. To understand this first understand what is cumulative compound dc…

Q: If f(t) = t is the input to the system H(s) = 1/(s+100), the output of the system would be: O A.…

Q: The generator shown in Fig. 1 is rewired as a self-excited shunt DC generator and Radj adjusted to…

A: Here we discuss the concept of DC shunt motor.

Q: Using Thevenin's theorem, Find the Current in 10 ohm Resistor in Figure below? Using Electronic…

A: Using Thevenin's theorem, find current in 10 ohm resistor

Q: If the load of wye connected transformer are: IA = 10 cis(-30ᴼ) IB = 12 cis (215ᴼ) IC = 15 cis…

A: In this question we will find positive sequence components and phase b current with given data. ..

Q: PROBLEM NUMBER TWO: For a negative unity feedback system with the given forward transfer function,…

Q: Problem 21: Design a RC low-pass filter to have a cutoff frequency of 500 Hz using a resistor of 1.2…

A: cut-off frequency is the break frequency and corner frequency and it is define the boundary…

Q: Determine the closed-loop gain of the ideal OP-AMP circuit given with the following parameters: R1 =…

A: We need to find out closed loop gain for given circuit

Q: D The graph in Figure 1 shows the current-voltage characteristics of a certain light bulb. Two light…

A: Given:

Q: A LED which bright

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is…

Q: 10-ohm resistor and 10 H inductor are connected in series across a source of 12 V. If the current is…

Q: If 30% of a number is 12.6, find the number ★ 38 42 40 46

A: Given data, 30% of a number is 12.6

Q: Propose and draw a circuit of a resistive current divider in half

A: Question 1 is answered in step 2 Questions 2 is answered in step 3

Q: Q1: For the circuit shown in figure. Derive the stability factors S(Ico), S(VBE) and S(ß). RB +Vcc…

Q: Solve for Ic of Figure 42. 3.2 m/ 3.2 UA 4MA 4UA 12 V www -% = 6V --3-80 20130 1B = 40 μA Reference…

Q: A :) Given the following model in SIMULINK : Write the equation of relationship between output to…

A: The output to the input relationship can be obtained by reducing the network using block diagram…

Q: Investigate the faulty motor shown below to determine why doesn't the motor work?

A: A DC motor is a Electric device which converts the electrical energy into physical motion. The…

Q: dy dªy day + 8. d²y +21 dt4 cts dt 2 + 18 - 10x dt WHERE Y(T) IS THE OUTPUT AND X(T) IS THE INPUT.…

Q: For the F(x) function shown in the figure, find P(0≤x≤0.5) F(x) 1 1 2 O 0.4999 0.5000 O 0.5999 O…

Q: B)-A DC generator has Ra=0.12, Rs=0.502, VT-250V, I₁=100 find Ea= and copper losses

A: In this question we need to find a induced emf and copper loss in generator

Q: 10. A linear system has the transfer function given by W H(w) = w² + 15w+5 Find the power spectral…

A: We need to find out psd of output

Q: Which one of the following descriptions is true? Increasing the n-type dopant concentration will…

A: The objective is to determine the correct option.

Q: A 132 kV circuit breaker interrupts the fault current flowing into a symmetrical three-phase to each…

A: Given A 132 kV circuit breaker interrupts the fault current flowing into a symmetrical three-phase…

Q: The closed-loop transfer function of a negative unity feedback system is given by

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: 270V 50 Hz 2002 VO Figure A2 The delay firing angle of the AC controller in Figure A2 is set at 65°.…

Q: Find the Branch currents and Vx. 10V wwwww + + Vx 192 492 www 2A 1.5Vx www 202

A: Given circuit :

Q: Use Nodal Analysis Find the 15.0 M 30c35 tv current i in the circuit below 2H jj, 44i 30.5H 1 F

A: given here a circuit and asked to find the value of i in the given circuit by using nodal analysis.

Q: A 3 phase, overhead transmission line has a total series impedance per phase of 200 ohms and a total…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 2) A 30-0 resistor, a 15-0 inductive reactance, and a 12- capacitive reactance are connected in…

A: As per the guidelines of Bartley we supposed to answer first three subpart only for solution of…

Q: an+bu[-n- c] ↔ ³²2-¹, ROC: 2 < 1-32'

Q: Given an Ideal OP-AMP with the following parameters: R1 = 680 2, R2 = 100 92, R3 = 1802, Rf = 2.7…

Q: Show that.. F} = X(P) == X(²x 1070 10시

A: We need to prove time scaling property of Fourier transform

Q: 4. A) Reduce the given circuit to the fewest possible components thru series/parallel combinations…

A: The reduced circuit can be obtained by considering the parallel and series connected elements. The…

Q: 3-phase, overhead transmission line has a total series impedance per phase of 200 ohms and a total…

A: In this question , we will find sending end line voltage and current by Rigorous method........

Q: 4. Write, in the spaces provided, the control, or controls, that perform each of the following…

A: 4). The control which is used to perform the below given functions is explained in below steps. a)…

Q: The transfer function of a plant is: Go(s) = s+a where a and b are arbitrary constants and a,b > 0.…

Q: An analog-to-digital 16-bit binary input. The input analog voltage range is 0 to 21 V. What is the…

A: In this question we will find quantization level step size for analog to digital converter....

Q: simplify the boolean function E0 = AD’+B’C’D’+B’CD+BCD’+A’BC’D

Q: B) For the electrical circuit shown below, obtain the transfer function V1(s) 11(s)

A: It is given that:

Q: 1. Calculate the voltage Vs in the circuit below. R₁ Vs 3ΚΩ E 12V O I 8mA

A: Given circuit:

Q: Redraw the network given for the ac response with the re model inserted between the appropriate…

Q: f(t) X2 (t) y Hiokgh que WISONS WIN T 2 Ns/ml

A: Given mechanical system shown

Q: Please find Fourier Series coefficient for the figure given below. -3/2 -5/2 4/2 -V2 5/2 Your…

A: Calculation of Fourier series coefficient of given figure below : We know,Fourier series…

Q: A JFET shown in the circuit has the following V(GS(off))= -8V and IDSS= 16 mA. (a) Plot the Q point…

A: Junction-Gate Field-Effect Transistor: JFETs is the three-terminal semiconductor devices. This is…

Question

In an RLC circuit, if the Neper frequency is 50000, L = 10 mH, and R = 10000, the resonant frequency would
be:
O A. None of the other choices are correct
B. 10000
O C. 20000
O D. 50000
O E. 100000

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in a plant. A series resonant circuit is to be used to produce a high voltage at a frequency of 400 Hz. The inductor has an inductance of 15 mH and a wire resistance of 2 . How much capacitance should be connected in series with the inductor to produce a resonant circuit? The voltage supplied to the circuit is 240 V at 400 Hz. What is the minimum voltage rating of the capacitor?
An ac source of voltage amplitude 100 V and variable frequency f drives an RLC series circuit with R = 10 Ω , L = 2.0 mH , and C = 25μF. (a) Plot the current through the resistor as a function of the frequency f. (b) Use the plotto determine the resonant frequency of the circuit.
An AC voltage of fixed amplitude is applied across a series RLC circuit. The components are such that the current at half the res-onant frequency is half the current at resonance. Show that the current at twice the resonant frequency is also half the current at resonance.
A series R L C circuit has the following parameters: R = 10 Ω, L = 10 mH and C = 100 nF. Find the linear resonant frequency f0 and the angular resonant frequency ω0.
A series RLC circuit consists of a 10Ω resistor in series with L = 10µH and C = 100µF. Determine a new value of L for which the resonant frequency is one-half the original value.
A series RLC circuit has the following parameters: R=40 ohms L=2.5 mH C=0.1 uF find out the impedance at resonance and the series resonant frequency.
A series R-L-C circuit has the following parameter values, R= 10 ohm, L= 0.01 H, C= 100 mF. The Q factor of tge circuit at resonance is _______
The inductance coil in a series resonant circuit is 0.2 H and the resistance coil is 50 Q. What is the capacitance value in the circuit that causes resonance at a frequency of 150 KHz? The source produces an emf of 100 V r.m.s.
Determine the resonant frequency fr and the magnitude of the impedance |Z| for the circuit below at that frequency. What is the voltage amplitude VL across the inductor at resonance? Data: C1 = 5.0 μF, C2 = 25 μF, L = 50. mH, R = 200 Ω, and Vp = 10. V. fr = kHz |Z| = Ω VL = %
The following data are given for a three-branch parallel circuit: V = 12 V, R = 82 kΩ, L = 15 mH, and C = 390 pF. Determine the values specified at the resonant frequency. d. IL = ______________e. IC = ______________f. IR = ______________
The phase angle of a series RLC circuit, with C = 75 µF and L = 25 mH at 1200 / π[Hz] is 30 degrees lag.Determine the frequency (f) for which the phase angle is 45 degrees atadvancement.
A series RLC circuit consists of a resistance of 430 ohm, inductance of 42 mH and a capacitance of 15.5 micro F. Find: (i) the resonance frequency (ii) Q factor of the circuit at resonance