In determining the bending stress, what conclusion can be drawn if the neutral axis is an axis of symmetric of the cross-section? A The maximum tensile and compression bending stresses are equal in magnitude and occur at the section of the largest bending moment. B The maximum tensile and compression bending stresses are equal in magnitude and occur at the section of the smallest bending moment. The maximum tensile and compressive bending stresses may occur in different sections. None of the choices D

In determining the bending stress, what conclusion can be drawn if the neutral axis is an axis of symmetric of the cross-section? A The maximum tensile and compression bending stresses are equal in magnitude and occur at the section of the largest bending moment. B The maximum tensile and compression bending stresses are equal in magnitude and occur at the section of the smallest bending moment. The maximum tensile and compressive bending stresses may occur in different sections. None of the choices D

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine normal stresses at A and B. Are these point of maximum and minimum normal stresses? If not where are they located and what their values.
NO. 3 Given the beam shown with computed reactions and a cross section. Determine the maximum tensile stress of the section.
A beam has a diameter of 300 mm with length = 4 m. The engineer decided to replace the circular section with a square section because the circular beam is equal to the strength to the square section having a similar area. a.) Determine the dimensions of the square beamb.)If the allowable shearing stress is 2 Mpa and the allowable bending stress is 16 Mpa, determine the maximum uniform load.
THE BEAMS SHOWN IN FIGURES (a) AND (b) HAS THE FOLLOWING PROPERTIES. f’c =30 MPa, fy=400 MPa AND IS SUBJECTED TO A POSITIVE BENDING MOMENT Mu=140KN-m. ANSWER THE FOLLOWING.1. DRAW THE INTERNAL STRESS AND STRAIN DIAGRAM OF BEAM CONSIDERING THAT THE DEPTH OF THE STRESS BLOCK IS GREATER THAN THE THICKNESS OF THE FLANGE.
The principal stresses are incorrect but the maximum shear stress is correct. What are the two correct values for the principal stresses?
The lap joint is connected by three 20-mm diameter rivets. Assuming that the axial load P= 50 kN is distributed among the three rivets, find the shear stress in each rivet. the bearing stress between the plate and a rivet. the maximum average tensile stress in each plate. Express your answer in MPa
If the bending stress at section 2 =20 MPa. What are the bending stresses at sections 1, 3, and4
A simply supported wood beam with overhang is subjected to uniformly distributed load q. * Inserted Photo * The beam has a rectangular cross section with width b = 200 mm and height h = 250 mm.Determine the maximum permissible value q if the allowable bending stress is ?all = 11.2 MPa, and the allowable shear stress is ?all = 1.50 MPa. (Enter the magnitude in kN/m.)
Determine bending stress formula
Compute for the adjusted reference compressive stress with modifications, ( Fc* ) in MPa
Given the beam shown with computed reactions and a cross section. Determine the maximum compressive stress of the section.
Given the beam shown with computed reactions and a cross section. Determine the maximum compressive and tensile stress of the section