In performing a test, a sound source and a number of receivers are setup. Core sampling Electrical resistivity Rock hardness Seismic refraction
Q: 9. The performance of a flow device is
A: To find : Performance of a flow device can be expressed as.
Q: 6. Theodolite is an instrument used for measurement of ro(a) Both horizontal and vertical angles (b)…
A: Brief concept introduction- Theodolite- It is a surveying instrument. It has a rotating telescope…
Q: The flowrate in a water channel is sometimes determined by use of a device called a Venturi flume.…
A:
Q: A stadia rod held at a distant point B is sighted by a theodolite set up at point A. The upper and…
A: Given Upper stadia hair reading, S1 = 1.400m Lower stadia hair reading, S2 = 0.800m Stadia interval…
Q: In seismic exploration, acoustic waves are launched downward from the surface and reflected sound…
A:
Q: A calibration test of a 15-mm diameter circular sharp-edged orifice in a vertical side of a large…
A: Given Dia of orifice, d = 15mm = 0.015m Weight of water = 760 N Time, t = 60 seconds Height of water…
Q: Figure shows a conical vessel having its outlet at A to which a U-tube manometer is connected. Find…
A: Given:- U tube manometer Ht of conical vessel = 2.5m Base of conical vessel = 2m To find:-…
Q: Problem 8: Derive equations for the displacement response of an undamped SDF system to a pulse shown…
A:
Q: 6. Which among these devices are the best suited for the measurement of high pressure liquids with…
A: Device best suited for the measurement of high pressure liquids with high accuracy.
Q: A sound wave is observed to travel through a liquid with a speed of 1620 m/s. The specific gravity…
A: Answer We are given Velocity of sound wave C = 1620 m/s Specific gravity of fluid = 1.5…
Q: Discuss the effects of not dropping the hammer in a standard Proctor test from a height of 305 mm.…
A: Calculate the compaction energy y=using the equation:
Q: 1.Explain the remote sensing exploration of crude oil
A:
Q: An open, clean glass tube, having a diameter of 3.6 mm, is inserted vertically into a dish of…
A:
Q: A concentric cylinder viscometer may be formed by rotating the inner member of a pair of closely…
A:
Q: An open, clean glass tube, having a diameter of 4.1 mm, is inserted vertically into a dish of…
A: Given data Diameter of tube (d) = 4.1 mm Fluid = mercury Temperature (T) = 20°C
Q: The right limb of a simple U-tube manometer containing mercury is open to the atmosphere while the…
A: Given: Specific gravity of fluid, S1 = 0.9 Centre of pipe = 12 cm = 0.12 m Difference in mercury…
Q: This instrument is called a penetrometer.
A: penetrometer is used to find strength of material.
Q: 6 mm/s 5mm dam 5 m dam needle piston Fig. 5-A
A: To find the average speed of blood-
Q: A noise meter located at a distance of 30 m from a point source recorded 74 dB. The reading at a…
A: given- sound recorded by noise meter at location 1-L1=74 dBdistance of noise meter 1 from the point…
Q: Q1 A gravitational settling chamber is to be installed in a factory to remove particulate matter. As…
A:
Q: An open, clean glass tube, having a diameter of 2.2 mm, is inserted vertically into a dish of…
A:
Q: To damp oscillations, the pointer of a galvanometer is fixed to a circular disk which turns in a…
A: Given data, ω= 0.30 rad/s Viscosity of oil = 8x10^-3 Pa-s Disc diameter = 75 mm Oil gap = 0.5mm…
Q: An open, clean glass tube, having a diameter of 2.8 mm, is inserted vertically into a dish of…
A:
Q: An open, clean glass tube, having a diameter of 4.6 mm, is inserted vertically into a dish of…
A: Given, D = 4.6 mm or 0.0046 m
Q: Moving to anoi stion 44 A calibration test of a 15-mm diameter circular sharp-edged orifice in a…
A: H=6.5m D=15mm
Q: In water bottle rockets, the more water you put in, the more powerful it would be. Select one: True…
A: The more water we put in bottle rocket,the more propellant it will have, and the higher the rocket…
Q: Define vibrating wire piezometer.
A: Vibrating wire piezometers are used to regulate the pressure of pore water in soils.
Q: An open, clean glass tube, having a diameter of 3.2 mm, is inserted vertically into a dish of…
A:
Q: A clean tube of diameter 2.5 mm is immersed in a liquid with a coefficient of surface tension equal…
A: The diameter of the tube is d=2.5 mm. The coefficient of surface tension is σ=0.40 N/m. The angle is…
Q: the most common used infiltrometer (A) single ring B double ring (c) tube-type infiltrometer (D…
A: Of the given options, the most common used infiltrometer has to be found out
Q: 3. Consider the following scenario: A civil engineering stadent measures the resistivity of a…
A:
Q: QUESTION 15 The centerline ground concentration of a VOC downwind from a smokestack at a x= 2 km is…
A: Gaussean plume model is used. Cx, y, z=QU12πσyσze-y22σy2e-z22σz2 Q = Rate of emission from the…
Q: 9.The below figure shows an inclined U-tube mercury manometer. The vertical end of the
A: According to given data The correct option is - Option-C= 75
Q: EXAMPLE 2 A body of 12 mm diameter is tested and the following results are noted. gauge length…
A: poisson's ratio= 0.0125young's modulus = 176838.826 N/mm2explanation is given in below step
Q: A two-liquid double column manometer with enlarged ends is used to measure a high precision pressure…
A:
Q: Lacking on mercury, an improvised barometer uses a liquid that weighs 0.735 times that of mercury.…
A:
Q: omparatively ..... pressures.
A: Manometers are devices in which columns of a suitable liquid are used to measure the difference in…
Q: A closed tank is filled with oil and water with the given situation as shown in the figure. An…
A:
Q: Calculate the error in the staff reading on a staff at a distance of 100mm due to out of the center…
A:
Q: Describe the LIGO detector's components.
A: There are different types of detectors used for different purposes. The LIGO type of detector is…
Q: Liquids A, B and C, in the containers shown, have SG of 0.60, 1.00 and 1.60 respectively. At what…
A:
Q: .A stadia rod held at a distant point B is sighted by a theodolite set up at point A. The upper and…
A: Using stadia interval formula
Q: Question 3: A lab test was used to identify the headloss coefficient of a confusor k'e where: h =…
A:
Q: An application demands that sinusoidal pressure variation of 250 Hz be measured with nO more than 2%…
A: A dimensionless metric that describes how a system's oscillations decay after a disturbance is said…
Q: The height of a theodolite held at hill A is 1.2 m, hill C is between hill A and B. The elevation of…
A:
Q: Following observations were made to determine sensitivity of two bubble tubes A and B. Find which is…
A:
Q: Twa vessels are connected to a differential manometer using mercury, the cornecting tubing being…
A: Given:- Two vessels are connected to a differential manometer using mercury, the connecting tubing…
Q: U-tube manometer is connected to a conical vessel as shown in figure. Manometer shows a reading of…
A: We have to determine the value of reading on the manometer when vessel filled with water.
Step by step
Solved in 2 steps
- Reflection on Clash detection by NavisworksThe dilution method of stream gauging is ideally suited for measuring discharges in A large alluvial river Flood flow in a mountain stream Steady flow in a small turbulent stream A stretch of a river having heavy industrial pollution loadsWhen does the penetrometer classified as a static cone penetrometer?
- B and C were observed from point A where the instrument was set up at a height of 1.25m. Point B and C were ahead of point A. Below shows the data recorded as observed for points B and C. a. find stadia constant b. find the slope distance between the telescope at point A and rod reasiny at point B. c. find the difference in elevation between between B and C.Explain Types of Cone Penetrometer Equipment.Find the dB gain for a whisper increasing from 10^−11 watts/cm^2 to 10^−10 watts/cm^2.
- A tacheometer with a stadia constant of 0.30m, and stadia interval factor of 100, was set up on the line between two points A and B. The following hair readings were observed. *Inserted Photo* If the instrument height is 1.43m and it is set up on a point with elevation 14.72 m, determine the elevation of A.Survey The stadia readings with a horizontal sight on a vertical staff held 40 m away from a tacheometer were 1.385 m and 1.780 m. The focal length of the object glass was 25 cm. The distance between object glass and trunnion axis of the tacheometer was 12 cm. Solve for the stadia interval.If an EDM instrument has a stated accuracy of +-(2mm+3ppm) what error can be expected in a measured distance of 1259.67 feet ?