In 'reverse polarity' of arc welding O A. Electrode is connected to + and most of the heat is generated at the electrode O B. Electrode is connected to - and most of the heat is generated at the workpiece O C. Work piece is connected to + and most of the heat is generated at the workpiece D. Work piece/is iconnected to-jandimost of the heat is generated at the workpiece Windows hu JlclJI Jäil

In 'reverse polarity' of arc welding O A. Electrode is connected to + and most of the heat is generated at the electrode O B. Electrode is connected to - and most of the heat is generated at the workpiece O C. Work piece is connected to + and most of the heat is generated at the workpiece D. Work piece/is iconnected to-jandimost of the heat is generated at the workpiece Windows hu JlclJI Jäil

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter10: Gas Metal Arc Welding Equipment, Setup, And Operation

Section: Chapter Questions

Problem 4R: In short-circuiting transfer, what type of current alloys the liquid metal at the electrode tip to...

See similar textbooks

Similar questions

Why is SMA welding current referred to as constant current?
Which SMA welding electrodes are commonly used to weld on sheet metal fabrications?
What holds the molten ball of tungsten in place at the tip of the electrode during DCEP welding?
1)a) Why is automation of the covered electrode arc source difficult?b) what properties is a metal with good resistance welding ability expected to have?c) Why is the heat transfer factor higher in arc welding processes with the consumed electrode than the methods used with the non-consumed electrode?d) Why is it important to weld thin and long instead of thick and short?e) why is it important that the source root is designed to be forced to press, not pull? 2) there is a characteristic liquid penetration error on a large piece of steel poured in the sand mold. The surface of the piece consists of a mixture of sand and metal.a) Explain at least 3 of the steps that can be taken to correct this error.b) what other types of casting errors may possibly occur in each of these steps? Explain 3) grain structure formed in part after casting;a) Describe by drawing a figure.b) what problems can this grain structure pose? Please explain. How can these problems be cured?4) explain two of the…
26 Q3. Draw the electric arc welding setup and explain its working principle.
a) explain the principles of Gas Metal Arc Welding (GMAW) b) explain three (3) modes of metal transfer for GMAW
In GTAW the welding cable is connected to the tungsten electrode through a water-cooled copper contact tube, as shown in picture below. Why is the tube positioned near the lower end of the electrode instead of the top?
What is the function of flux in submerged arc welding?a) To completely cover the welded zone b) To prevent oxidation of joint c) To prevent spattering of molten metal d) All of the Mentioned5. submerged is
State three engineering assumptions to calculate kinematics and dynamic properties of themixture of air-welding fume
a). Explain the three types of flames produced in the gas welding process. b). Explain the soft soldering process.
a) Why is good eye protection far more important when arc welding rather than gas welding? b) Explain the two dangers that occur from arc welding in confined spaces.
Explain the resistance welding process giving the equipment, parameters controlled and its advantages.