In the bus system, the register which places its content on the bus lines is determined by: O A. The values of selection lines of MUX. O B. The load input, which is active. The INR input, which is active. O D. None of the choices.

Q: The following two transfers are allowed at the same time in the bus system of basic computer: O A.…

A: To find which two registers are allowed at the same time in the bus system of basic computer .

Q: In the bus system, the register which receives data from the bus lines is determined by:   A. The…

A: In the bus system, the register which receives data from the bus lines is determined by:

Q: Q2/ A- Sum of series of 10 numbers stored at memory location 0100H:0500H and then store result in…

A: Note - answering  first question according to our guidelines     Algorithm – Move 00 to register…

Q: Q2/ A- Sum of series of 10 numbers stored at memory location 0100H:0500H and then store result in…

A: Move 00 to register B immediately for carry Load the data of memory [0500] into H immediately Move…

Q: The addressable mit in memory must equal the width of the bus. Select one: O True O False

A: Definition: Addressable Unit: In this the word endianness will be used for referring the sub…

Q: O/M* = 0 for an I/O write bus operation.  True  False

A: Step 1:-   Introduction:-   IO/M' this is a pin which is used in 8085 microprocessor. In 8085…

Q: State the differences between write bus cycle in memory in and read in Input/Output.

A: State the differences between write bus cycle in memory in and read in Input/Output.

Q: arbitration type of control pins are needed in a microprocessor to regulate traffic on the bus, in…

A: Required:   Bus arbitration type of control pins are needed in a microprocessor to regulate traffic…

Q: Which one of the following is not a valid line of the control bus? ) MRDC - memory read control MWTC…

A: Here, There are many control lines or signals in the control bus.

Q: digital computer has a common bus system for 16 registers of 32 bits each. The bus is constructed…

A: As per our guidelines we are supposed to answer only three subparts kindly repost other parts as a…

Q: Should we use an asynchronous or a synchronous bus to link the CPU to the memory? Which is better…

A: Given: Should we use an asynchronous or a synchronous bus to link the CPU to the memory? Which is…

Q: QUESTION 21 Give the maximum hex value that can be brought into the CPU at a time for a 20-bit data…

A: Answer :           Given                  8086 has a 20- bit address bus…

Q: A- How many clock states are in a read bus cycle that has no wait states? What would be the duration…

A: Solution: Note: As per bartleby we can answer only one question at a time

Q: On our board ROM is activated by [choose all that apply]: a) ROMWR b) Data bus c) IOWR d) ROMRD…

A: ROM is the Read-only Memory. This memory is used to run the system operating system with the help of…

Q: Should we connect the CPU to memory through an asynchronous or synchronous bus? Provide a…

A: Synchronous bus are timed, and directions are executed uniquely at the clock ticks. Each gadget is…

Q: necessary pins: One Bus Cycle T +T, T CLK- Address- Valid Address ss/Data- Address Data written to…

A:

Q: If the max value of the counter is Ox00394391 and the bus clock frequency is 24 MHz, what is the…

A: Below is the answer with calculation:

Q: Should we use an asynchronous or synchronous bus to link the CPU to the memory? Explain how you came…

A: A bus is a shared communication link it uses one set of wires to connect multiple subsystems

Q: o you prefer a synchronous or an asynchronous bus for the utilizatio

A: NOTE: ACCORDING TO COMPANY POLICY WE CAN SOLVE ONLY 1 QUESTION. YOU CAN RESUBMIT THE QUESTION AGAIN…

Q: Q3: A digital computer has a common bus system for 8 registers of 16-bit each. The bus is…

A: a) ⦁ There should be three selection lines in each multiplexer.⦁ A common bus for 8 registers of 16…

Q: Q3: A digital computer has a common bus system for 8 registers of 16-bit each. The bus is…

A: Actually, every common bus system for 8 registers. Registers are used to stores the data.

Q: Suppose a computer system has a common bus system for 8 registers of 16 bits each. The bus is…

A: A Multiplexer is a device that allows one of several analog or digital input signals which are to be…

Q: Do you prefer a synchronous or asynchronous bus for CPU and memory utilizatio

A: NOTE: ACCORDING TO COMPANY POLICY WE CAN SOLVE ONLY 1 QUESTION. YOU CAN RESUBMIT THE QUESTION AGAIN…

Q: When we want to place the content of PC onto the bus, what will be the value of selection inputs…

A: Given question has asked to find the value of selection input s2 s1 s0 in two scenario: When we…

Q: When connecting the CPU to memory, should we use an asynchronous bus or a synchronous one? Give an…

A: A bus  is a shared communication link and it uses set of wires to connect multiple subsystems.…

Q: The data and the address are shared on the same bus in the 8085 Select one: O True O Enlnn Foloo

A: Given To know that data bus and address bus shared on same bus in 8085.

Q: Register Bus AC BUS 4 PC BUS 2 IR BUS  5 MAR BUS  7 MBR BUS 7 which the above register…

A: AC register connected with BUS 4 PC register connected with BUS 2 IR register connected with BUS 5…

Q: Bus arbitration type of control pins are needed in a microprocessor to regulate traffic on the bus,…

A: Given that: Bus arbitration type of control pins are needed in a microprocessor to regulate traffic…

Q: A common bus in a computer connects 16 source registers (each register is 32 bits) and one memory…

A: Given: What is the minimum number of multiplexers required? _____ What is the minimum number of…

Q: A common bus in a computer connects 16 source registers (each register is 32 bits) and one memory…

A: Since this is a multiple question as per guidelines we are allowed to solve only part 1 repost part…

Q: A common bus in a computer connects 16 source registers (each register is 32 bits) and one memory…

A: Given: What is the minimum number of multiplexers required? _____ What is the minimum number of…

Q: If the CLK input to the 8086/8088 is 4 MHz, how long is one bus cycle? How much time is allowed for…

A: 1 Machine cycle = 4 T states                           = 4 Clock Pulse Frequency = 4 MHZ -> 1…

Q: The addressable mit in memory must equal the width of the bus.

A: The size or width of a bus is how many bits it carries in parallel whereas Addressable units are the…

Q: Distinguish between a write bus cycle in memory and a read bus cycle in Input/Output

A: Explain the distinctions between a write bus cycle in memory and a read bus cycle in Input/Output.

Q: In a memory map for a microcontroller, which information would generally be the least likely to find…

A: the base address of each section of the match

Q: When the ROM sends data to the microprocessor, which of these conditions are true? a. Both (RD)' and…

A: Given that when the ROM sends data to the microprocessor, which of these conditions are true?   a.…

Q: What Direction Does Data Flow On A READ Bus Cycle?

A: Find:- In what direction data flow in a READ Bus cycle

Q: The idle state is one clock period long, is inserted in the the bus cycle, while the wait state…

A: Lets see the solution.

Q: Do you prefer a synchronous or asynchronous bus for CPU and memory utilization? a bus that keeps…

A: GIVEN: Do you prefer a synchronous or asynchronous bus for CPU and memory utilization? a bus that…

Q: Do you prefer a synchronous or asynchronous bus for CPU and memory utilization? a bus that keeps…

A: Introduction: A bus is a collection of cables that link one or more subsystems within a single…

Q: Buses use either synchronous timing or asynchronous timing. With synchronous timing, the occurrence…

A: Busesuse either synchronous timing or asynchronous timing.With synchronous timing, the occurrence…

Q: What is the difference between an asynchronous and synchronous bus?

A: Given:

Q: Q5\ Draw The Typical Memory Package Pins and Signals For two types of processors ( 8-Mbit EPROM and…

A: Answer is given below .

Q: B) List the types of the input/output of 8086. Write program to input data from two byte-wide input…

A: Below i have answered:

Q: Find the memory location addressed by the microprocessor, when operated in the real mode, for the…

A: Calculations can be done by converting hexadecimal to binary as shown below : a)  Address =…

Q: Give THREE (3) examples of different types of input/output devices that connect to the I/O bus via…

A: A bus is basically collection of wires vie which transfer of data takes place from one sources in…

Q: (B) If you have four registers, the size of each one is 8-Bits, and we want to design a simple Bus-…

A: Given:

Q: (B) If you have four registers, the size of each one is 8-Bits, and we want to design a simple Bus-…

A: If you have four registers, the size of each one is 8-Bits, and we want to design a simple…

Q: After every interrupt ISR is a. executed b. stopped c. interpreted d. compiled

A: Required:   After every interrupt ISR is a. executed b. stopped c. interpreted d.…

Q: IBM developed a bus standard for their line of computers ‘PC AT’ called _____ . a. IB bus

A: Answer