In the context of DHCP what is the purpose of an IP helper address? a. The gateway for the computers in the segment b. Used to map private addresses in public ones for the purpose of accessing the outside c. Allows routers to forward DHCP requests to the segment where the server can be found d. It is a temporary IP address used by end-devices to issue requests to the DHCP server

In the context of DHCP what is the purpose of an IP helper address? a. The gateway for the computers in the segment b. Used to map private addresses in public ones for the purpose of accessing the outside c. Allows routers to forward DHCP requests to the segment where the server can be found d. It is a temporary IP address used by end-devices to issue requests to the DHCP server

A+ Guide To It Technical Support

10th Edition

ISBN:9780357108291

Author:ANDREWS, Jean.

Publisher:ANDREWS, Jean.

Chapter7: Setting Up A Local Network

Section: Chapter Questions

Problem 5TC

See similar textbooks

Similar questions

In packet tracer application, which of the following is used to view the last command applied in CLI? Up Arrow Right Arrow Ctrl-C Left Arrow What is the IEEE specification for Spanning Tree Protocol? 803.1 803.ud 802.1d 802.9
You are troubleshooting an issue and you think that it is a problem with the DHCP server configuration. Client get an IP address, they can ping IP addresses on the same network and on the internet, but they cannot pull up webpages. What is a likely cause of misconfiguration on the DHCP server? a.) incorrect ntp server b.) incorrect dns server c.) incorrect gateway d.) incorrect subnet mask
To prevent a DHCP server from leasing an IPv4 address that has been manually configured on a computer on the network, you can configure a DHCP server to send one or more ping requests to an IPv4 address before leasing it. a. True b. False ?
When a service provided by a host on your network must always come from the same server, that host will need a static IP address. Whenever you have to hand-assign an IP address, what method should you use? and what the heck led to this happening?
We use what from the results of ipconfig to map an adapter index to a network subnet IP address? Group of answer choices The IP address The interface name Link-local address The network mask
The command below illustrates the configuration of the static route. Router(config)# ip route network-address subnet-mask {ip-address | exit-intf [ip-address]} [distance] What is the function of the parameter distance in the given command? a. To assign bandwidth b. To assign matric value c. To assign AD value d. To assign protocol value
When a fresh IP configuration is required, DHCP clients issue a DHCPREQUEST packet.Is this true or false?
When you run a scan on your computer, you see a session with a host at the IP address 208.85.40.44:443. What protocol is in use for this particular session?
When a service provided by a host on your network must always come from the same server, that host will need a static IP address. When assigning an IP address manually, which method should be used? how did we get to this point?