in the crout befox-3 Vots R-50R-30 Find in Amps Give your answer to 3 decimal places
Q: In a three phase (50Hz) full converter, the ripple frequency in output voltage?
A: Given: A three-phase full converter frequency, f = 50 Hz.
Q: Hoow did the r13 equate to sq root of 0.5? when it shouldve been 0.2?
A: It is given that:
Q: 5. Using delta/star transformation determine the current through the galvanometer in the Wheatstone…
A: Wheatstone bridge:
Q: Imaginary Axis (seconds) 2 O Root Locus -1 -2 Real Axis (seconds) 1. The order of the system is 2.…
A: Since you have asked multiple questions in a single request, we will be answering only the first…
Q: I 10 ww 100 V 10 www un 10 10 Fig. 2.59 un 10 3- h 50 V 3. Apply loop current method to find loop…
A:
Q: Qy(6) for the circuit in figure Q4 (6) () Calculate I₁, I₂, V₁ and V₂ i) determine the dissipated 3A…
A:
Q: (a) For the circuit shown in Figure 3.1, determine the currents ls and l the resistance R. (1) (ii)…
A: “Since you have posted multiple questions with multiple sub parts,we will provide the solution only…
Q: Solve for the current flowing through the 8 resistor in the following figure. ΖΩ 4Ω SV | isa 8 Ω 3V
A: We need to find out the current through given resistor for given circuit .
Q: 2) Solve the problem below using the Step By Step Method and Sketch by Hand a PLOT of the results:…
A: In this question We need to determine the current i(t) as shown the circuit. We know Inductor act…
Q: loku u 10кл озу O 15.21128 2017 291 t vo 6A (1 200123V Figure 2 (a) alayhon doame long laban la NOW…
A:
Q: of 1080 MHz. The antenna is connected by coaxial cable with inductance, L-02 An antenna with…
A: Introduction: Antenna: An antenna is a device used to transmit or receive signals, usually in the…
Q: = Figure Q2 shows the exact equivalent circuit of a 50 Hz, 30 kVA, 2200 V/250 V single- phase…
A:
Q: The simplest equation which implements the K-map shown below is: c c AB 0 0 AB 1 1 AB 1 1 AB 0 1
A: Given K-map- To Find- The simplest equtaion.
Q: + F/E) RI 3/2 T3 C₂ M -т Ji(1) -ww m find 1(S); Jols); 13/5) V(S) v(s) K(57
A:
Q: 1. Find the ammeter current in Fig. by using loop analysis.
A:
Q: 24. (a) An electrical load requires a sinusoidal voltage v(t), as shown in Fig. 24(a)(i), to…
A: 24. a Given Data: Waveforms of, The sinusoidal signal v(t) A Bipolar square signal v^(t) To Find:…
Q: (2) Consider the following circuit with a source voltage Vs and resistances Rlimiting R=1.0 km2. The…
A: I have written this solution as handwritten solution. Hope you find the perfect solution.
Q: Briefly describe the following: a. Configurable logic blocks b. "Synthesis" process in FPGA c.…
A: From question d), Differentiate between reg and wire in verilog. There are Simple difference…
Q: 1. The control in flashlight circuit is a relay. True False
A: Introduction: Relay: An electrical relay is a device that switches or controls electrical circuits.…
Q: 1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive…
A:
Q: 8. In the figure at the left is shown part of the circuit that is used to model the cell membrane of…
A: The given circuit is shown below. Both the resistors are identical and R1=R2=R. All the batteries…
Q: 1) For the series-parallel combination circuit shown below in Figure-1, use circuit reduction…
A:
Q: A long shunt generator running at 1000 RPM supplies 20 kW at a terminal voltage of 220 V. The…
A:
Q: The source voltage , in the circuit in figure equals 40 V Figure 20 www 200 354 10 40 www 4011 800…
A:
Q: In the circuit given below, R= 23 Q. Determine ₁ and 2. 10 V 10 Q2 ww www. 10 Q www. R 3 A The value…
A: Given: A network, with R=23Ω. To find: The value of v1 and v2.
Q: 4. For the circuit below use a combination of Ohm's Law, KCL and KVL in order to compute the…
A:
Q: Compute the power factor of a two-terminal element with admittance Y = (1/4radical3 - j1/4), S…
A:
Q: For the given system, determine (a) the complex power supplied by the source, (b) the power factor…
A: In this question We need to determine the complex power, power factor and source voltage. We know…
Q: Note: Suppose any suitable values that are not given to you. Given two time domain signals; x(t) and…
A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…
Q: Problem 2 Find the Nth order differential equation that relates the output y(t) (current through R4)…
A:
Q: For a very long time, Vin=+10V At t = 0 seconds, Vin is instantly switched to -10V. The NMOSFET has…
A: The question deals with an NMOSFET circuit. Given, Vin switched from 10 V to -10 V. NMOSFET has…
Q: (c) A circuit connected to a practical source is shown in Figure 4.1. Determine (1) the voltage V₁…
A:
Q: Draw digital circuit for the following equation by using AND, OR & Not gate: g=a'b'c + abc' + (ab)
A:
Q: Calculate the time constant for the RC circuit shown here. 1200 120 50 V 800 200µF
A: Given RC circuit:
Q: If the Applied Voltage of a DC Shunt motor is halved with the load torque doubled, the armature…
A:
Q: path function of 0.1? 8. Figure 9.30 shows an electrical circuit and its block diagram…
A:
Q: 10k ww 50 mV 10k
A:
Q: Find the Norton equivalent current IN that drives R4 when E=14 V, R1=2, R2=12, R3-24 and R4=6. E a…
A: The given circuit diagram is shown below,
Q: A 3-phase, star-connected alternator is rated at 1600 KVA, 13500 V. the armature effective…
A:
Q: Find the no load line voltage of a wye connected 3-phase, 6pole alternator which runs at 1200 rpm…
A:
Q: If a 1.4 μF capacitor, charged to 4.0 V, is discharged in a time of 50 ms, what is the average power…
A: it is asked to find the average power provided in capacitor from its capacitance, charged voltage,…
Q: SOV www 15 ww R₁ Fig. 2.179 11. State and explain Thevenin's theorem. For the circuit shown in Fig.…
A:
Q: Assuming the processor frequency is 20 MHz, find the lowest square wave frequency that can be…
A: Here is solution of given question
Q: Consider the following circuit and determine the following: a) The type of the circuit b) Draw the…
A: answer: given that input voltage to primary is 50 V rms turns ratios is Np : Ns = 4:2 = 2:1 Vs -…
Q: + 10 V +15 V- Fig. 2.37 Applying Kirchhoff's voltage law, find V, and V₂ in Fig. 2.37. A + 12₂ B…
A: it is asked to find the voltages V1 , V2 in given circuit using Kirchhoff's Voltage law
Q: Problem #3 For the mechanical system that given by the equation d²y(t) dt² m ++b dy(t) dt + ky(t) =…
A:
Q: An inverting amplifier is to be designed with a gain of 10 and an input impedance of 20k ohms. What…
A:
Q: What is the magnitude of the electric force in (N) acts on a +2nC charge enters a region of a…
A: Given data, Charge is given q=2 nC. Electric field E=3-4j×109 N/C.
Q: If the differential voltage gain and the common mode voltage gain of a differential Amplifier are 48…
A: We need to find out the comman mode rejection ratio.
Q: Buses are conductive routes in a microprocessor's circuitry. Consequently, there is potential for…
A: We need to tell about buses which are used in microprocessor and we need to differentiate the data…
Step by step
Solved in 2 steps with 1 images
- An R-L series circuit contains two resistors and two inductors. The resistors dissipate powers of 96 watts and 125 watts. The inductors have reactive powers of 100 VARs and 78 VARs. What is the power factor?7. The resistor in an R-L series circuit has a voltage drop of 53 V, and the inductor has a voltage drop of 28 V. What is the applied voltage of the circuit?Determine the output voltage in V WHEN R1= 8kiloohms , r3= 7kohm ,r5=13kohm r7= 120kohms reference voltage of 2.5V and input volatge Vi=2.592V
- What is the V0(t)This is a second order LTI system subject review question, therefore it is not graded. 1.) Find the value of the R1 (Resistor) with the given values of R1= 80 ohms C=2uF and C1=2uF and cut off frequency of 1 kHz. 2.) Solve for the Final Output Voltage. Upon using multisim probe, the answer should be around 330mV.16kv-4wire circuit has 150 amps on A at zero degrees, 160 on at 120 degrees and 170 amps on at 240 degrees all at unity power factor. what is the current on the neutral? do not included any symbols or letter to represent amperes after your calculated
- Determine the operating point values of current Ic(=Icq), voltage Vce(=Vecq), Vce(cutoff) and Ic(sat) in the circuit below. The current gain ß for the resistor is 180. Vcc = 16, Rb = 330 kΩ, Rb = 330 kΩ, Rc = 1100 Ω and Re = 550 Ω.What is the output voltage will be visible for the circuit on below? (R1 = R2 = R3 = R4 = R, Rf = R5 = 2R, V1 = V2 = 2V, V3 = V4 = 1V)Hello. The answers I got for this are pf distortion = .83 and pf total of 0.7. I'm not sure I did it right though and I was hoping to compare answers and see how you go through this. Thank you.
- A high voltage engineer cascades 6 stages of a voltage doubler circuit to analyze effectiveness of doing so. Each capacitor in the circuit is 15 nF, of the input Asupply is 100 kv at Frequency 100 Hz. . so this voltages not enough with one moudle.So How much moudle can be in cascades fashion if the load current is 1 mA.I1 is the current source on the far right and is 0.0052 amps.Do all for Given equcation I will upvote