In the figure shown, the 8-ft-diameter cylinder, 3 feet long weighs 550 lbs and rests on the bottom of a tank that is 3 feet long. Water and oil are poured into the left-and right-hand of the tank to depths 2 feet and 4 feet, respectively. Determine, the magnitudes of the horizontal and vertical components of the force that will keep the cylinder touching the tank at A. Ans: FH =749 lb > Fy = 2,134 lbs r 4 ft 2 ft 4 ft A Water Oil =0 75

In the figure shown, the 8-ft-diameter cylinder, 3 feet long weighs 550 lbs and rests on the bottom of a tank that is 3 feet long. Water and oil are poured into the left-and right-hand of the tank to depths 2 feet and 4 feet, respectively. Determine, the magnitudes of the horizontal and vertical components of the force that will keep the cylinder touching the tank at A. Ans: FH =749 lb > Fy = 2,134 lbs r 4 ft 2 ft 4 ft A Water Oil =0 75

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

In figure 3 compute the pressure head difference between m and n, in feet of fluid A, when: A. Fluid A is gasoline (sp gr 0.715), the gage liquid is mercury, and z = 47.77 in B. Fluid A is oil (sp gr 0.908), the gage liquid is water, and z = 27.77 in C. Fluid A is sea water (w = 64.0), the gage liquid has a specific gravity of 2.95, and z = 57.77
The wooden block (mass m = 0.5358 kg) is released from rest at A by a compressed spring (compressed length 0.6 m, undeformed length 1 m, spring constant k = 150 N/m). The block is allowed to slide through the rough horizontal surface (A to B), then along the smooth circular ramp (B to C, central angle θ = 47.2°, until the block is released after point C. Calculate the speed of the block at points B and C. Also, what is the magnitude of the normal force exerted to the block just before the block leaves the ramp? Neglect the geometry of the block.NOTE: Use Work-Energy Method to solve for the speeds; use Force-Mass-Acceleration (FMA) Method to compute for the normal force.
A cylindrical tank containing a fluid (sg = 0.75) is accelerated upward by a net force of 40 lb. The volume of the fluid is 1.60 cu. ft. If the depth of the fluid is 3 ft, determine the force acting on the bottom of the tank.
A rectangular tank 20 ft long by 6 ft deep by 7 ft wide contains 3 ft of water. If the linear acceleration horizontally in the direction of the tank's length is 8.05 ft/sec2, (a) compute the total force due to the water acting on each end of the tank and (b) show that the difference between these forces equals the unbalanced force necessary to accelerate the liquid mass.
Consider two blocks connected . BlockA has mass 2.00 kg, and block B has mass 5.00 kg. The table on whichB sits is frictionless, the cord connecting the blocks is light and flexible,and the pulley is light and frictionless. The horizontal force F S hasmagnitude F = 20.0 N, and block B moves to the left with an accelerationof 1.50 m/s2. What is the coefficient of kinetic friction that one block exerts on the other?
Determine the smallest force P that must be applied in order to cause the 150-lb uniform crate to move. The coefficent of static friction between the crate and the floor is μs = 0.5
Answer is 1,022.80. Show your solution. Forces F1 and F2 shown below act on the screw eye. If F1 = 501 lb, determine the magnitude of the resultant force (in lb) if it is directed vertically upward. Use F2 = 578 lb., α = 20°.
A uniform bar AB weighing 424 kN, is fastened by a frictionless pin to a block weighing 200 kN as shown in figure below. At the vertical wall, f = 0.268 while under the block f = 0.20. Determine the force P needed to start the motion to the right.
A cylindrical tank containing a fluid (sg = 0.75) is accelerated upward by a net force of 40 lb. The volume of the fluid is 1.60 cu. ft. If the depth of the fluid is 3 ft, determine the force acting on the bottom of the tank. 4 decimal places answers
A rectangular tank 20 ft long by 6 ft deep by 7 ft wide contains 3 ft of water. If the linear acceleration horinzontally in the direction of the tank's length is 8.05 ft/sec2, a.) Compute the total force due to the water acting on each end of the tank and b.) show the difference between these forces equals the unbalanced force necessary to accelerate the liquid mass. i need an answer right away please sir , thanks.
If blocks A and B has the total mass of 250 grams with a ratio (A:B) of 2:3, what will be the smallest force F needed to cause motion of block B if P=300 N? Let the static friction of the surfaces between A & B and B & C will be 0.25 and the surfaces between the ropes and pegs D & E be 0.35.
Determine the resultant of the vertical thrusts on the sphere shown in the figure for the data: d=0.6m; R=0.5m;h=4m.