Choose the correct response In the figure shown, when the funnel is empty, the water surface is at point A and the mercury shows a deflection of 15 cm.30 cm ØB60 cmAYwater15 cmMercuryDetermine the new deflection of mercury when the funnel is filled completely with water to B.Select the correct response21.1069 cm• 19.5802 cm17. 3435 cm15.0000 cm In the figure shown, when the funnel is empty, the water surface Is at point A and the mercury shows a deflection of 15 cm.K30 cm Ø60 cmAYWater15 cmMercuryDetermine the new pressure at point A.Select the correct response9.81 kPa5.886 KPaO KPa80.0496 kPa

Answered: Image /qna-images/answer/866dc4d3-3009-4af0-b7ad-bd7402092e2e.jpg

Answered: In the figure shown, when the funnel is…

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter7: Length And Length-related Variables In Engineering

Section: Chapter Questions

Problem 42P

See similar textbooks

Similar questions

Using the following notes, what is the elevation of BM14?Station BS FS Elev.BM12 4.64 209.651 5.80 5.06 2 2.25 5.02BM13 6.02 5.853 8.96 4.944 8.06 3.225 9.45 3.71 6 12.32 2.02BM14 1.98
Please calculate for D and please explain how to input the angle 2°54'13'' in the calculator. D = 1/tan(2°54'13''/2)
Calculate the following: A.Adjusted value of angle A B.Adjusted value of angle C C.Adjusted value of angle F D.Adjusted value of angle H
A 100 m tape weighing 3 kg was standardized and found to be 0.02 m short at temperature of 10degC and a 30 N pull when supported throughout. The 1324.55 – meter distance measured is an inclined distance whose difference in elevation between the points is 2 m. What is the correct distance? a. 1 324.28 m b. 1 234.18m c. 1 345.83 m d. 1 432.11 m
A 240 N block is set on a 20 degrees inclined plane with a coefficient of friction 0.30. Find A) The maximum value of P that will hold the block in Place if Angle Theta is zero is nearest to? B) Minimum value of P that will produce in pending motion up the place if Theta is zero is nearest to? C) Smallest possible value of P that will produce impending motion up the plane if Theta can be adjusted is nearest to?
A line was determined to be 2,651.56 meters when measured with a 30 m. steel tape supported throughout its length under a pull of 4 kg. at a mean temperature of 39 °C. Tape used is of standard length of 15 °C under a pull of 5 kg. Cross-sectional area of the tape is 3.95 mm^2. Determine the TOTAL ERROR of the LINE due to TEMPERATURE in meters. Round off to three decimal places. Input the magnitude only.
The instrument was set at point E and the rod readings at points E and F are taken as 3.226 meters and 4.304 meters, respectively. Then the instrument was set at point F and the rod readings at E and F are 2.3 meters and 3.208 meters, respectively. Determine the correct difference in elevation between E and F in meters. If elevation of F is 25 meters, what is the elevation of point E in meters?
Given the cross sectional area below. The horizontal neutral axis is 129.0mm from reference corner 1. The moment of inertia around this neutral axis is 1073352100.6mm4.
In order to find the elevation of point B, a stadia is set up at a point A whose elevation is 100.14 m. The height of the instrument is 1.52 m. The stadia intercept with the rod at B was taken as 1.75 m with the vertical angle 5 ̊30’45” at 2.1 m. The stadia constant is 100 and the value of (f+c) is 0.3. What is the elevation of point B in meters?
16. The rectangular coordinates of a particle are given in millimeters as functions of time t in seconds by x = 20t + 3t² = 40 sin 2t, and z = 30 cos 2t. Determine the angle Teta1 between the acceleration a and the velocity v and the angle Teta2 between the position vector r and the acceleration a, both at time t = 3s.
Can you help me to make the solution explicitly and simplified Thankyou. Given Values: q(kN/m) = 18 P(kN) = 81.00
. You have been given the following constant-head data for planar flow of water in a 1.5-mm thick geotextile that is 300-mm wide by 600-mm long. Calculate the transmissivity in m3/min-m of fabric and then the planar coefficient of permeability in cm/sec. Total head lost, Dh (mm) q (cm3/min) 75 21 150 41 225 60 300 79

SEE MORE QUESTIONS

Recommended textbooks for you

Engineering Fundamentals: An Introduction to Engi…

Civil Engineering

ISBN:

9781305084766

Author:

Saeed Moaveni

Publisher:

Cengage Learning