In the following circuit, Io =ww10 VA) 1/3 AB) 2/3 AC) 1 AD) 0.6 Awwww

Resistance is the obstruction offered to the flow of current. The electrical element or the…

Answered: In the following circuit, Io = 82 10 V

Engineering

Electrical Engineering

In the following circuit, Io = 82 10 V

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 36RQ: If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad...

See similar textbooks

Related questions

Q: For the circuit show. The value of the voltage across the j20 ohms coil of the secondary circuit…

A: The solution can be achieved as follows.

Q: find the voltage of the inductance 1H if the value of the source is: 50 sin(100) volt R3 R2 R1 552…

A: To find voltage across inductance of value 1H as shown in the circuit

Q: 13 240 V 60 Hz 200 Determine the inductance value if the source current is 13 A ww-

Q: Q.33 Find the value of current I in the circuit below. 20 V 2A 51

Q: An ammeter, a voltmeter, and a wattmeter were installed in an ac circuit and read 15 Arms, 115 Vms,…

A: In this question we will find power factor of circuit....

Q: Calculate the energy and power of the following signals. i. x(t) = 3 + sin(t) ii. x[n] = 2^ u[−n]

Q: If an air gap is added to the core, the inductances in the coils will increase. True False

A: Considering the formula for inductance, L=NφIL=NINISL=N2SL∝1S Where, L is inductance, N is number of…

Q: A t=0 V(t)260 3H 2H

A: In given network at t=0- current source is disconnected from rest of the network hence so inductor…

Q: I. Determine the current in the resistors at time = 0, 1, 2, 3, 4, 5, and 6 ms. R1 V1 SINE(0 20 60)…

Q: Find the current ir for the circuit below. iR=, R1 100 v = 100 sin wt +

Q: 1. An alternating current is given by i = 10 sin314t. with reference to time t = 0, how long will it…

Q: Find the Vout of the circuit below during the positive half cycle. V3 ci 15 Silicon R1 V1 Vout 35 75…

A: In the question, What is output voltage during the positive half cycle Assume the forward bias…

Q: Quèstion 1 What is the value of the conductance of z= 10+5j ? O 01 O 5 0.2 None of the answers

A: In the question Find the value of conductance? If impedance Z= 10+5j given

Q: What is the value of the conductance of z = 5+10j ? None of the answers 0.1 0.2

A: Given Find conductance

Q: Question 1 A direct current (DC) of 4A flows into a previously uncharged 20 uF capacitor for 3 ms.…

A: For the given data voltage between the plates are determined as shown below

Q: For the waveform of Figure 6 below, calculate the period of the waveform: 120 Vp OV- Vertleal…

Q: The current in a circuit falls to 0 from 16 A in 0.01 sec. The average emf induced in the circuit…

Q: When SW1 is closed, the capacitor will 5 V 7 ko 100 47 µF SW 1 Short to ground Hold 5 volts…

Q: ) Determine I, RT, I I, 8r 30V IR. 20n 1on

A: The answers are I= 2A , Rt= 15 ohm, I1 = .48A For detailed solution please see the attachment below.

Q: The 0.5-nF capacitor of figure (1) has the waveform of voltage shown across it. Calculate and plot…

Q: the mmf in ampere-turns. (b) Calculate the field intensity meter. 1. A coil of 2000 turns with a…

A: Coil mmf and feild intensity calculated as mmf = no of turn ×current in the coil

Q: The value of photocurrent will be high on a sunny day Select one: True O False

A: Let us discuss the concept of photo current and insolation in this answer.

Q: 30 Ω ww 25 Q 10Ω 20 Ω а о ww ww 5Ω 15Ω bo

Q: Find the following a) RT b) IT 10Ω 50 60 12 V 10Ω ww

A: Given circuit,

Q: 10. Determine the impedance of the circuit of Figure 2.3 for a 1 kHz sine. 1 k 50 mH 100 nF

Q: A 220 V D.C. generator is run at full speed without any excitation. The open circuit, voltage will…

A: This is a basic problem of dc generator. The solution is given below

Q: What is the value of the equivalent admittance? 100 ww sa -20 j10 a

Q: What is the value of the voltage function at 12 seconds? v(t) = 87 sin (17πt + (5π/4) V

Q: 13. Which of the following quantity is/ are change in substations? a) Voltage b) AC to DC c)…

A: There are basically two types of substations. 1) Transmission substation 2) Distribution substation…

Q: g(t) = A sinc(2Wt)

Q: Q: Calculate ia and i,. 80 fia 60 Ω 300 V 30 N 20 Ω ' 80 Ω

A: The solution can be achieved as follows.

Q: charges one plate of the capacitor positive 19. When a capacitor is connected to an AC circuit, the…

A: When a capacitor is connected to ac circuit, the ac generator charges the plates positive and…

Q: Given the circuit below, Calculate the following: 15 V A 1 KHz a. Voltage drop between Points A and…

Q: V. All divdes haue barrion voltage of O.55V 552 (sine) Solve Io ldc)

A: Given RL = 55 ohm, Vpp = 400 V

Q: If the effective voltage across a resistor is 2.2 V, then The maximum voltage is: Select one: O a. 4…

Q: 2/ Calculate the average and r.m.s values of the current waveform given by: i(t) = 100 + 25 sin 3wt…

Q: For the given circuit, the voltage v(t) for t< 0 is volts.

Q: 5. From the figure, calculate the average voltage. V 10 -10 5 сл 10 ω!

Q: Find io in the circuit below 0.25 F 1 H 0.5ix 1Ω Vo 16 sin (4t – 10°) V

Q: An e.m.f. of 16 volts is induced in a coil of inductance 4H. The rate of change of current must be…

A: Given; EMF induced vL=16 V Coil inductance L=4 H

Q: 20 Exp. ter the ctranit shown below, ind Vx. 了+ にんんエ Is=2A 6.

Q: An alternating current (AC) generator is a device that produces a O current O potential difference O…

A: The explanation is as follows.

Q: What is the value of the equivelent admittance? 50 30 0.47+0.21j 23.4+5j None of the answers 51.09…

Q: A 2H inductor is connected to 120V 60Hz system. What is its inductive reactance?

A: Given: Inductance L = 2H Voltage V = 120 V Frequency f = 60Hz

Q: ketch the output waveform of the given circuit, assuming that the pltage of the battery is 1V and…

A: Given that circuit Vi=10V VBB=1v

Q: 5. The unit of capacitive reactance is farad ohms henry none of the above 6. When the supply…

A: 5. Any reactance has only units as OHMS 6.If frequency increases then the capacitor becomes more…

Q: For the circuit shown below: 20 7VT ww 7 A 12 The magnitude of current through 3 Q resistor will be…

A: Given circuit is -

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

In the following circuit, Io =
ww
10 V
A) 1/3 A
B) 2/3 A
C) 1 A
D) 0.6 A
ww
ww

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad rating? 166 microfarad 15 microfarad 200 microfarad 3450 microfarad
A load takes 50kw at a power of 0.8 leading. Calculate the apparent power and reactive power.
An ac system supplies an apparent power of 10KVA to a circuit; the reactive power being 6KVAR. The power factor of the circuit is ____. a. 0.6 b. 1 c. 0.8 d. 0.75
Determine the voltage vo(t) when vs(t) = 25 cos (100t-15°) V. As shown in the image.
A voltage v = 311 sin (377t + 600) is applied across a circuit having an inductance of 0.34 H. What is the magnitude of the impedance in ohms?
Find the two elements in a series circuit (i.e., R and L, or R and C, or L and C), given that i(t) = 2 √2 sin(120πt + π/6) A. and v(t) = 100 √2 cos(120πt - π/6)
A circuit is having a power factor of 0.8 and apparant power of 200 VA. Calculate the reactive power.
Find the total/resultant effective voltage, given the following: e1 = 10 sin ωt e2 = -15 cos (ωt – π/3) e3 = 10 cos ωt e4 = -20 sin (ωt– π/3)
Reduce 5 cos(ωt+75°)−3 cos(ωt−75°)+4 sin(ωt) to the form Vm cos(ωt+θ)..
The voltage across a 100 mH coil is v = 100 sin 50t. Which of these expressions describesthe current? 2) _____A) 20 sin 50tB) 20 sin(50t - 90°)C) 2000 sin(50t - 90°)D) 20 sin(50t + 90°)
In power system, reactive power is highly sensitive to change in voltage magnitude.Select one:O TrueO False
Analyze the sinusoidal AC circuit and solve using KCL, KVL, or Nodal Analysis Solve for nodal Voltage Assume all other variables are equal to 1 Is = 1 < 0 A R = 1 Ohms L = 1H C = 1F