In which of the following cases would recrystallization be favored over extraction when purifying a mixture of two solid compounds? I. When the desired compound is freely soluble in the solvent pair at all temperatures. II. When a significant difference in pKa exists between the two compounds. II. When there is a significant excess of the undesired compound.

Q: A centrifugal pump is used to elevate toluene (ρ = 867 kg/m3) from Tank 1 situated at  10 m from gro...

A: Note: Since we are entitled to answer only 3 subparts, we’ll answer the first three. Please resubmit...

Q: Is it possible for more than one mechanism to be consistent with the rate law of a given reaction? E...

A: Rate law is the reaction which relates the initial or forward reaction rate with the concentration ....

Q: Please fill out table for kelvins and answer the question below ?

A:

Q: Please, use the Book:   Please use the Book:Process Dynamics and Control, Third Edition or Fourth Ed...

A:

Q: A sample of a hydrocarbon contains 2.59 * 10 ^ 23 atoms of hydrogen and is 17.3% hydrogen. the molec...

A: Given, Percent mass of hyrdogen in sample = 17.3% Percent mass of carbon in sample = 100% - 17.3% = ...

Q: The heat of combustion of fructose, (C6H12O6), is -2812 kJ/mol. A fresh yellow apple weighing 120 g ...

A: The heat of combustion for fructose, ΔH = -2812 kJ/mol Weight of the yellow apple, mapple = 120 g Ma...

Q: Use the data below to calculate AG°rxn for the reaction: A+2B → 2C+ 2D Data: A+2B . →4C AG° rxn - 37...

A: The given reactions are: 1.     A+2B→4C                            ΔGrxn(1)0=−372.0 kJ/mol2.     C→D...

Q: A reaction has an activation energy of 195 kJ/mol. When tge temperature is increased from 200°C to 2...

A: The increase in the rate constant for an increase in the temperature is to be determined.

Q: In SPME for HPLC, analytes are desorbed from thefiber into solvent that is injected into the HPLC co...

A: SPME also known as Solid Phase Micro Extraction is an equilibrium sampling method and can be used fo...

Q: Q19) (a) Write the oxidation and reduction half cell reactions and arrive at the balanced net redox ...

A: Given the equation is, F=96500 Coulombs The atomic mass of Cr=52 g/mol Cr deposit gram A is 40 gram

Q: N2 and O2 gases have KH values 76.48 Kbar and 34.86 kbar respectively at 293 K temperature.  Which o...

A: The gas which is more soluble in water is to be chosen.

Q: Balance the following equations, predict the sign of ΔS°rxn if possible, and calculate its value at ...

A: Entropy is defined as the measurement of the degree of randomness. Entropy is directly proportional ...

Q: Which of the following is a correct mass balance equation for aqueous solution of La(IO3)3:

A: This question is based on the concept of mass balance. Substance  = La(IO3)3

Q: A sample of 10g of sodium reacts with Oxygen to form 13.83 g of sodium chloride (Na2O) and sodium pe...

A: Mass of sodium=10g Mass of Sodium Oxide formed=13.83g To calculate the percent composition of the mi...

Q: DETERMINATION OF pH OF DIFFERENT SOLUTIONS show complete solution For those who will be using scient...

A: Given that: pH has to be obtained for each solution. The pH and pOH  are calculated as: (1) For the...

Q: Calculate the entropy change ΔS and comment on the sign of the change. NH4Cl(s) → NH4Cl (aq) Values ...

A: Entropy (S) is a thermodynamic property that measures the degree of randomness or disorder-ness of t...

Q: Which mechanism did this reaction take - Sn1 or Sn2? H20 Но. CI

A: The given reaction is hydrolysis of secondary alkyl halide (2-chloro3,3-dimethyl butane). In hydroly...

Q: Hi! Can you answer this? Thanks. I. In filtration using calculus, the fictitious volume (Ve) is con...

A: The two given statements to be checked for their authenticity are: In filtration using calculus, th...

Q: i need the answer quickly

A: Given, Where S is the stiffness of the beam  C1=constant  EI =Flexural Rigidity L= stiffness for a ...

Q: Refer to the problem below.

A: Given data: Initial concentration = 1.5 M Value of rate constant = 0.2 L/mol.s Rate of reaction = k[...

Q: The Orsat analysis of combustion of HC with negligible nitrogen shows 15% CO2, 2% O2 and 83% N2. The...

A: Orsat analysis of the flue gas: 15% CO2, 2% O2, and rest N2   The basis of the calculation is taken ...

Q: Please use Book: Introduction to Chemical Engineering Thermodynamics 8 edition, 2018 (Smith, J.M., V...

A: n-hexane  Temperature = 6 C = 279K Pressure = 41 bar Specific Volume of liquid hexane = 128 cm3 / mo...

Q: box with a volume of 22.4 L contains 2.0 mol of nitrogen gas and 1.0 mol of hydrogen gas at 0°C. Wh...

A: The correct option for the pressure is to be chosen.

Q: 1. The system as shown in Fig.1. The gauge pressure at the bottom of the tank is 242 kPa, what is th...

A: Given, Gauge pressure at the bottom of the tank, P=242 kPa=242000 Pa

Q: Two of the colligative properties are elevation of boiling point and the depression of freezing poin...

A: Thermodynamic reasons behind these properties are: The boiling point of a solution that contains a n...

Q: Complete and balance the following half-reaction in acidic solution MnO₄⁻(aq)→MnO₂(s)

A:

Q: i need the answer quickly

A: Given: diameter of tube d = 25 mm = 0.025 m mass flow rate of water m = 1.5 kg/s Mean bulk temperatu...

Q: 2. Calculate (NPSH)A according to the figure given below. (density of the fluid=1514 kg/m³) P1=775mm...

A: NPSH (NET POSITIVE SUCTION HEAD) is defined as the total head of fluid at the impeller center line m...

Q: Calculating Limiting Reactant Problems. Show your complete solutions. 1. Si + 2 Cl2 ➡ SiCl4 In the g...

A: The limiting reactant in a chemical reaction is the reactant that will be consumed completely. The e...

Q: Consider the reaction: 2B1F3(g)→Br2(g) + 3F2(g) Using standard absolute entropies at 298K, calculate...

A: The reaction given is:   The temperature of the reaction, T = 298 K Moles of BrF3 reacted, n = 2.06...

Q: Calculate the pOH if you titrate 10.00 mL of 0.00101 M potassium acetate with 3.00 mL of 0.00404 M H...

A: Volume of potassium acetate = 10 ml = 0.01 L Molarity of potassium acetate = 0.00101 M  Volume of HB...

Q: i need the answer quickly

A: Fixed Bed Reactor (1) Diameter = 4 cm Height = 9 cm   Distillation Column (2) Diameter = 3 cm Height...

Q: Please answer quickly.

A: The following subparts to be answered.

Q: need explanation soon

A: Initial pressure = 2 bar  Initial temperature = 300 K  Final pressure = 0.5 bar  Cv = 1.5 R 

Q: Compounds having the same molecular mass but different chemical structural formulas are called isome...

A:

Q: Calculate the IV flow rate in ml/her for Dopamine 1,600 mcg in 500ml of D5W running at 4 mcg/min

A: In chemical analysis, the concentration of a solution is defined as a measure of the amount of solut...

Q: what is hte pH for the complte titration of 34.5 mL of 0.192 M benzoic acid, HC6H5CO2, with 0.150 M ...

A: Given that: Volume of weak acid, benzoic acid (HC6H5CO2)= 34.5 mL Concentration of (HC6H5CO2)= 0.192...

Q: As part of your project work for the semester, you have been provided with a copper container of mas...

A:

Q: How to speed? At distance 2m and time is 2 sec

A: The speed for the given data is to be calculated.

Q: Also,which of the 3 given equations is most likely to be correct?

A: Thermal decomposition of AgNO3. The possible decomposition equations are : 1) 2 AgNO3 ---> 2AgNO2...

Q: Find the percent increase in the fugacity of gaseous oxygen per degree rise in temperature in the ne...

A: In solution thermodynamics, the fugacity of a real gas is an effective partial pressure that replace...

Q: Chemical Engineering Question

A: In thermodynamics, the melting point of a substance is the temperature at which it changes state fro...

Q: I need to solve this please

A:

Q: How many moles of NH3NH3can be produced from 3.8 moles of H2H2? Use the following balanced chemical ...

A: N2 + 3H2 → 2NH3

Q: A sample of (3.3) grams of water (18.02 g/mol) was heated from 0.0°C to 100°C. Calculate the amount ...

A: According to the Law of Conservation of Energy, energy can neither be created nor destroyed. One for...

Q: An electric current is passed through three cells in series containing respectively solution of copp...

A: This question is from Faraday's law. Atomic weight of Ag = 108 Atomic weight of Cu  = 63.5  Atomic w...

Q: How are composite materials produced?

A:  When a material is produced using a combination of two or more constituent materials with different...

Q: A spherical slice with radius 3.2 cm of a carrot was dried by using tunnel drying. During process fr...

A: (a)

Q: If the second ionization energy (12) of Be is 18.7 eV, which of the following is a possible value fo...

A: The correct option regarding the second ionization energy of lithium is to be chosen.

Q: Describe the different zones in batch sedimentation. What is the critical point? How do you calculat...

A: Sedimentation is a physical treatment process by which water can be treated by using gravity to remo...

Steady State Model

The steady-state model typically states that the entire universe is always enlarging, although it balances a fixed average density and matter that is being constantly generated to make new galaxies, star forms at a similar rate that the previous ones get indistinguishable due to the growing range and velocity of recession.