In wind turbine,at 16-40 km/h wind, generated power does not increases with wind speed. Select one: True False

Q: Find the total load on the disk.

A: Total charge enclosed by disc is surface integral of charge density.

Q: jan

A: The given circuit is shown below:  In the ac circuit, the condition for the maximum power transfer…

Q: The alternative method is available to determine Y Bus O. None both Z bus and Y bus Z bus

A: To find out the correct answer

Q: By how much the velocity of wind turbine will be multiplied, if its wind power is tripled?

A:

Q: Write a matrix equation that determines the loop currents. ww 23 V 6 2 30 V 20 V I3 19 V ww 10 V

A:

Q: Investigate the stability of the following system. (Consider the quadratic form as lya punor…

A: The effectiveness of a system is determined by its stability. The impulse response of a system can…

Q: Solve the following Real-Life problems by using Gauss Elimination method Analyze the given…

A: a mesh is a loop that does not enclose other loops. KVL, states that “in any closed-loop network,…

Q: determine the value of load Z for maximum power transfer

A: Voltage division method- When elements are connected in series then voltage drop across any single…

Q: Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal…

A: To determine the current in each branch

Q: If a car moves (14 km) North, (20 km) East, and (14 km) South, what is its displacement? O 34 km,…

A: Given data Car moves 14 km North and 20 km east,14km south

Q: Use node method to find i

A:

Q: Complete the sentence The power factor must be close to ……………. To insure that losses in the…

A: To find the answer

Q: Develop the graph of the network shown infigure given obtain the (i) incidence matrix. (ii) reduced…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Determine the complex power absorbed by the voltage source

A: In this question, Determine the complex power absorbed by the voltage source?  Complex power S= VI*…

Q: Complete the sentence The power factor must be close to To insure that losses in the transmission…

A: Power factor- It is ratio of real power to apparent power. Cosϕ=PSWhereP=real powerS apparent…

Q: Find the Maximum power transferred to the load R.

A:

Q: The emf generated by a dc generator depends upor the number of conductors only. Select one: True…

A: In this question we will write about emf generated by dc generator...

Q: B b) The AC bridge shown below in the figure has an Z₁ = 40092 + j2002, Z₂ = 6002 - j3002, Z3= 5002…

A: given here a ac bridge with Z1 = 400 + j 200 Ω  ,  Z2 = 600 - j 300 Ω  ,  Z3 = 500 Ω  and Z4  is…

Q: Four industrial centers are located at the corners of a square of 26 km side. The loads are 4000 kW,…

A: The industrial centers are located at the corners of the given square. The best location of the…

Q: For the circuit shown, calculate power at W1.

A: It is given that:

Q: In Transmission Line, the DC and AC Resistance will always be equal. Select one: True False

A: AC resistance is the resistance of the conductor, taking into effect the Skin and proximity effect.…

Q: If the power system has 'n' number of generators, then the size of the B- coefficient matrix is…

A: As per the guidelines of Bartleby we supposed to answer first question only for remaining questions…

Q: Find the current using matrix

A:

Q: 6. A solid steel shaft is stressed at 80 MPa when twisted through 4°. Using G = 83 GPa, compute the…

A: Given: Stress, τ=80MPa or 80 N/mm2Length, l=5×103 mmθ=4o  or  4π180G=83GPa or 83 N/mm2f=20Hz

Q: Cauer and foster

A:

Q: 12

A:

Q: Prove this: C(5)=GIs)

A:

Q: The generator fuel cost function of the three generators are given below F1 = 478.8 + 7.47P1 +…

A:

Q: Consider a monopolist described by the following equations: Market demand for monopolist's product:…

A: It is given that: P=680-QMC=50+2Q

Q: find the current using maxwell's mesh

A: In this question,   We need to determine the current using maxwell's mesh?

Q: Find the average power delivered to the 50-ohm resistor in the cis

A:

Q: In which of the following matrix construction or building will consume more time ? Why of Justify ?…

A: Sol. More time is required z matrix.  z matrix is used for fault analysis. Inverse of y bus matrix…

Q: • AIn a 3 units suspension insulator, the voltage across the top and middle units are 30% and 32 %…

A:

Q: Find power associated

A:

Q: 40

A:

Q: Q1: If the power generated by a wind system at a height of 50 m is equal to 30 kw at a wind speed of…

A: Given that Pw1=30 KWh1=50 mh2=?v1=4m/sPw2=1.5Pw1v2=2v1 Although it is known that , in the case of…

Q: Calculate the wind power per meter square in Mirpur. Assume average wind speed in Mirpur is 21 km…

A: Given: Average wind speed, V=21 km/h Air density, ρ=1.3 kg/m3 For wind power per meter square, the…

Q: matrices.

A:

Q: The generator fuel cost function of the three generators are given below F1 = 490.8 + 7.47P1 + 0.7P,…

A:

Q: If the power system has 'n' number of generators, then the size of the B- coefficient matrix is…

A: the power system has 'n' number of generators,    the size of the B- coefficient matrix is (nxn)

Q: Problem 2. In the circuit below, Find ZL for maximum power transfer to the load. Also, find the…

A: To find ZL for maximum power transfer to the load, open the circuit the load impedance and calculate…

Q: Find the distance (21210) amd the line between Hhe

A:

Q: Determine the best-fit line equation of the curve. (Note the constants and their units.) (The…

A:

Q: b. use nodal analysis to solve

A: The given circuit is shown below:

Q: Solve the loop 1) ABCDA 2)ADCBA

A: The given circuit is shown below:

Q: By Nodal Analysis, determine the voltage V₂ of the circuit 252 jsn v m 8410A (1 Lin 452 jiori 2014…

A:

Q: Wind turbine is considered one of the prime mover types. (T or F) • Transmission lines are used to…

A: 1)Prime mover: it is a machine which converts some energy in to useful work as in wind mill as a…

Q: HAWT type wind turbine has the following data, height of tower =100 m, diameter of rotor = 80 m,…

A: According to question: