Include the contents of Transportation Policy Analysis and Planning in your summary. Please offer further information and explain its purpose.

Q: 1. Ra XW VX Find Ra, Rb, Ma & Mb: WX Draw Shear & Moment Diagram YZ XW Rb

A:

Q: 6- Estimate the TOTAL streamflow in the channel below given the values in the table and the flow of…

A:

Q: Water table in a canal command receives a recharge at the rate 2.5 mm/day. Sub-surface ditch drains…

A:

Q: In a truss girder of a bridge, a diagonal consists of mild steel flat 400 ISF and carries a pull of…

A: Given. Gross diameter,d= 26 mm Determine the number of rivets required in the splice?Diagonal…

Q: 8 kN 4 m 15 kN 5 kN 2 m 2 kN 2m 2m A B с D E The aluminum rod shown has a diameter of 20 mm and is…

A: Given: diameter, D = 20 mm E = 70 GPa

Q: A steel MRF is 78 ft tall. Estimate the natural period in seconds to three decimal places.

A: Given- Type -  Steel MRF  Height - 78 Ft.   To Calculate - Natural period in seconds.

Q: c) A reservoir of water is connected to a 12 inch diameter pipe 50 feet long and capped at the end.…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: 5 - An aluminum circular shaft, fixed at both ends, is loaded by torques applied at points B and C,…

A: Given Data  Shear modulus (G) = 85 GPa  Diameter of shaft (d) = 40mm  Length of AB (LAB) = 0.5m =…

Q: 6- Determine the resultant force acting on the 0.7-m-high and 0.7-m-wide triangular gate shown in…

A:

Q: Question-6b, A leaf spring is required to have a span of 2 .0 m. Determine the required thickness…

A:

Q: 1.41 Estimate the tensile strength required to prevent cracking in a concrete-like material that is…

A: Given Length L = 50 in initial temperature =100oF Final temperature = 0oF α=5×10-6/FoE=5×106psi To…

Q: A 5% upgrade on a six-lane freeway (three lanes in each direction) is 1.25 mi long. On this segment…

A: Reference : HCM Highway Capacity Manual, 2000 Given data : Upgrade, Number of lanes, % of SUTs and…

Q: A watershed is 30% meadow (good condition) and 70% commercial and business areas (85% impervious).…

A: Given: 30%meadow, 70% commercial and business area 50% soil group C,  50% soil group D Required:…

Q: What factors make wood more flexible in the longitudinal direction? a. low moisture content O b.…

A:

Q: P1-8 300 81 3' 1-8. The 300-lb force of Fig. Pl-8 acts on the box B. Resolve this force into two…

A: Given, To determine, Force along OA and Force through point C

Q: A 30 kN/m 3 m 3 m B

A:

Q: solve for Reaction right and reaction left

A:

Q: Question 7 When wood is stretched in the longitudinal direction, most of the stress is taken by a.…

A:

Q: 5. A 13-m-high, 7-m-wide rectangular plate blocks the end of a 12m-deep freshwater channel, as shown…

A:

Q: 10.6 The moisture content of wood test was performed according to ASTM D4442 procedure and produced…

A: Objective: To determine the moisture content of the given wood.   Given: Weight of the wood specimen…

Q: 3 A concrete gravity dam section is shown in the figure. Assuming unit weight of water as 10 kN/m²…

A: Given- Unit weight of water=10 kN/m3 Unit weight of concrete=24 kN/m3 Heads H=65 m & h=5 m, It…

Q: Gasoline a mixed with 9 ft^3 kerosene so that the volume of the mixture in the tank becomes 23ft^3.…

A: Given Specific gravity of gasoline =0.7  Specific gravity of kerosene =0.8 9 ft3 of Gasoline and 14…

Q: A drain carrying 5m³/s of wastewater with its BOD of 100mg/l joins a stream carrying 50 m³/s flow…

A: Given: A drain carrying, 5 m3/s of wastewater with its BOD of 100 mg/l. Joins a stream carrying, 50…

Q: Determine variables requested below for a horizontal curve with the following characteristics.…

A: Answer We know that length in full superelevation is given by  length in full superelevation =…

Q: For a gauge pressure of A of -10.89 kPa, what is the specific gravity of the gauge liquid B in the…

A:

Q: A. A simply supported girder spans 12 m. It carries two (2) beams, each at 4.5 m. from the supports.…

A: Given data Bending about x-axis  Beam: W410 mm × 100 kg/m Find the maximum bending stress.

Q: Question A raft foundation 10 m wide and 12 m long is to be constructed in a clayey soil having…

A: Given data- A raft foundation- Width B=10 m, Length L=12 m Shear strength C=12 kN/m2, Unit weight of…

Q: P1.17 A cylindrical rod of diameter d = 0.625 in. is attached to a plate by a cylindrical rubber…

A:

Q: A single lane unidirectional highway has a design speed of 65 kmph. The perception-brake-reaction…

A:

Q: If Dynamic viscosity = 0.0008 kg/m sec; gravitational acceleration g (9.81 m/sec2), average particle…

A:

Q: Question 3: Annual maximum floods in White Dog Creek are log-normally distributed. The average and…

A:

Q: 5- A 13-m-high, 7-m-wide rectangular plate blocks the end of a 12- m-deep freshwater channel, as…

A:

Q: Wood has reduced 1 improved O thermal insulating properties as the wood moisture content increases.

A: given : statement    to find : fill up and reason

Q: Determine the resultant force acting on the 0.7-m-high and 0.7-m-wide triangular gate shown in the…

A:

Q: 4- Consider the system shown in the figure. If a change of P kPa in the pressure of air causes the…

A:

Q: an 8 lane bfs in rolling terrain has a lanr width of 12 ft right shoulder width of 8 ft one…

A: BFFS = 70 mph   (Standard value taken) Lane width = W = 12 ft.Total no of lanes = 8Right shoulder…

Q: What is the length of side "b" to the correct number of significant figures? B A O 300.92' O…

A:

Q: Determine the seismic weight of the 1st floor above ground (2nd story) and the roof. Provide the…

A: All members associated with the floor diaphragm as well as any applied loads using the Dyn Mass load…

Q: The tension of cable AC is 110 N. Determine the mass of the crate at point E. g=9.81 m/s² X C 3m E…

A: Given, Tension in cable AC, TAC = 110 N   To find : Mass of crate at point E

Q: Using τall = 7.95 ksi and knowing that G = 5.6 × 106 psi, determine for each of the cold-rolled…

A: Given,τall=7.95 ksiG = 5.6 × 106 psiTo determine, For each of the cold-rolled yellow brass bars…

Q: A field was supplied water form and irrigation tank at a rate 120 lit/sec to irrigate an area of 2.5…

A: Given- Rate of flow=120 lit/sec Area A=2.5 ha Duration of irrigation=8 hrs distance=4 km & rate…

Q: Two foundations are located next to each other as follows. Determine the stress increase on a…

A: Given data in question  Stress 90 & 120 kPa Cross sections 5×3 m & 6×6 m Depth 3 m To find…

Q: 1- A city will extract water from a river that has an annual 7-day low flow that follows a Pearson…

A: Mean μ =1.87 Standard deviation σ =0.452 Skewness coefficient, Cs=-1.2 Return period, = 100 years

Q: 1-1. Determine a pair of horizontal and vertical components of the 340-lb force of Fig. Pl-1. 1-2.…

A: Angle made by the 340-lb force with the horizontal, θ =tan-1(158)θ= 61.93°

Q: Design an unequal angle section to serve as a tie member of 1.6 m length in a roof truss. It has to…

A:

Q: Figure Q2 shows a beam structure subjected to a point load of 80 kN on span AB and a uniformly…

A:

Q: A flooring system consists of parallel I-beam sections spaced at 3 m on centers with simple spans of…

A: Given data: Flooring consists of parallel I-beam, continuous Span of beam, L=6m with spacing 3m…

Q: Problem 2: Calculation of the Flow Rate in a Pipeline Figure 1 shows a pipeline which delivers…

A: We'll use the Bernoulli's equation to calculate the flow through the pipe:…

Q: What is the true area (in acres), if the area calculated by the chain which is found to be 0.6 link…

A: Given data : Area = 100 acres Tape measures or length = 0.6 link too long Assume = standardized…

Q: 1-11. The 200-lb force of Fig. Pl-11 acts on the 200 box B. Resolve the force into two components,…

A:

Transportation Planning Process

A transport planning process is the process of defining future policies, objectives, investments, action plans and spatial planning projects to meet future transportation-related needs. As is being done today, it is a collaborative process that incorporates the views of a wide range of stakeholders including various central and local government agencies, state-owned enterprises and the private sector. Transport planners, planning organizations or federal agencies use a multidisciplinary approach to analyze a variety of alternatives and impact on the transportation system to contribute to profitable outcomes.