INSAT-2E was launched from 1. India 2. French Guiana 3. Peru 4. Mayotte

Q: 13. For the given circuit below, find Vs

A: For the given circuit the value of input source voltage needs to be calculated by calculating the…

Q: Perform the large signal analysis for the following circuit. 4.51 if IS = 6 x 10-16 A.

A:

Q: V at CI Table 6-2. Full-Wave Voltage Doub Vin V at C2 V at C1 V at C2-C1 Table 6-3. Voltage Tripler…

A: In the given questions we need to calculate the voltage across capacitor C1, C1 and C2-C1…

Q: value of currents

A:

Q: The voltage across a 5 μF capacitor is known to be Vc = 500te-2500t V for t≥ 0, where t is in…

A:

Q: i need help please using j-k flip flop is fine   Design a 3 bit sequential circuit using T-Flip…

A: To do: We have to design 3 bit sequential circuit using J-K flip flop for the given states sequence,…

Q: What is the relative permitivity of the insulator used in a capacitor given that a copper resistor…

A: Specific resistivity of copper= 1.7x10-8 ohm-meter total resistance R=136 milliohms capacitor rating…

Q: [Q5B] The signal m(t) (whose spectrum is shown in the figure below) is sampled at a rate of 15k…

A: Given: Spectrum of a signal m(t), which is sampled at a rate of 15000 samples per second and A = 2…

Q: The 3 bit JK flip flop is able to count from 010 to 710, giving 8 different states (MOD-8). Modify…

A:

Q: Write the complete solution of second-order system - overdamped system response. C(s) s(s²+95+9)…

A:

Q: 14.38 Find the resonant frequency of the circuit in Fig. 14.78. 1478 L мее с www R

A:

Q: What is the output of e-4t u(t) * e¯³t u(t)? e-4tu(t) - e-³tu(t) tu(t) - e¯4tu(t) -4tu(t).e -3tu(t)…

A: Given, Signal expression, e-4tut*e-3tut

Q: A 220 V separately excited dc motor takes 20 A and the armature resistance is 1.0 0. If the armature…

A: Terminal voltage = 220V, Armature current = 20A, Armature resistance = 1ohms and the armature…

Q: b) Find the Node voltage at point "a". Give the answer as a function of time Va(t) = ? Note: Be…

A: Circuit is given as,

Q: Example 4 A lossles TL having Zo= 400 borking at. 223m. By using Crank dragram, draw the standing…

A: A lossless TL having Z0 =400 Ω, working at λ=3 m. By using Crank diagram, draw the standing wave at…

Q: 3. In a super heterodyne receiver, the IF is 455kHz. If it is tuned 1200kHz, the image frequency…

A: Step-1-> Acccording to given question we have, IF= 455 kHz Tuned frequency(fs) = 1200 kHz. Image…

Q: Write the differences between drive-in and pre-deposition process?

A: We need to explain differences between drive-in and pre-deposition process.

Q: 5. Find the range of K (K > 0) when the system is stable. 2.220 (Do not include marginally stability…

A: For the given system the value of K needs to be calculated for which the system is stable and the…

Q: 1) Using KCL, KVL and Ohm's Law find lo in the ciruşt in Fig.1.1 6 mA Ix 3 ΚΩ 4 ΚΩ www 6 ΚΩ 3 ΚΩ 1ο…

A: The circuit is given that

Q: Find the RMS value of V-100 sin(377t+76) V

A: Equation of voltage is given as, vt=100sin377t+760 V.

Q: Consider a solar cell with a photocurrent of 25mA and a reverse saturation current of 3.66x10-11 A.…

A: Given: I=3.66×10-11 AT=300 K

Q: 2. A certain passive network has equivalent impedance Z = 3 + j40 and an applied voltage v(t) = 42.5…

A: 2

Q: In the circuit shown in (Figure 1), the switch makes contact with position b just before breaking…

A: We need to calculate- Part a) Initial current through the inductor Part b) Time constant for t>0…

Q: 4. Sagnac interferometer Consider interferometer shown below. The input beam with amplitude E₁ is…

A: To demonstrate that output 2 of the Sagnac interferometer is always zero, we can use symmetrical,…

Q: The resistivity of a uniformly doped n-type silicon sample is 0.50 - mc. If the electron mobility…

A: ρ=0.5 ,μn=1250 cm2/V-sec,q=1.6×10-19 Coulomb. The donor impurity concentration is required?

Q: Figure C₁ 카 - 40 V + 8nF 10 nF HE +5V- 48 nF HE +30 V- 4 nF 24 nF 10 V 30 nF 카 - 20 V + Part C Find…

A: In this question We need to determine the equivalent capacitance across the terminal a and b. and…

Q: Write expression as sum of Minterms for Any One Neutral function F over 04 variables A, B, C,…

A: Here We Have to Write Sum of Minterms for the GIven Questions 1. Any One Neutral function F over 04…

Q: 250V + 25 Ω 8A + Vo W Find Vo using source Transformation 100 Ω 2002

A:

Q: For the circuit shown find the impedance phase angle Z (in degrees) i = 0.02 sin(157t +40)

A: Circuit diagram is given as,

Q: For the PMOS transistor shown V₁P = -0.8 V and kp = 0.2 mA/V². The values of Vs and Vsp are:…

A:

Q: A lossless transmission line has equivalent circuit parameters R=0 /m, L=4 µH/m, C=1 pF/m and G=0…

A: here we have to find the attenuation constant and phase constant.

Q: Solve for the mesh currents in the circuit below.  You must show your system of equations.  You may…

A: The circuit diagram,

Q: Please answer ASAP. Thanks 1.Choose at least 4 functions (except unit step, signum and impulse…

A: Rectangular Pulse Functionrect(t) = 1, -T/2 ≤ t ≤ T/2              0, otherwise To find its Fourier…

Q: For a 4- bus network, Zbus is shown below. [0.71660 0.60992 0.53340 0.580491 0.73190 0.64008 0.69659…

A:

Q: Assume that you have only one push button and need to energize four LED Indicators as shown. Design…

A: Task: We have one push button and need to energize four led indicators.Pressed Once->Yellow…

Q: Determine the current through the 4 kn capacitive reactance of the circuit below. E₁ R₁ = 100 V 0° 2…

A: Circuit diagram is given as,

Q: 4. An incident wave of frequency 1 MHz propagates in seawater, which is a good conductor at 1 MHz…

A: here we have to find the skin depth , wavelength , velocity.

Q: 1. Calculate the power dissipated by the voltmeter and by resistor R when (a) R=3002 and (b) R=3M2.…

A: The sensitivity of the voltmeter, S=12 KΩ/V The full-scale deflection of the voltmeter, fsd=200 V…

Q: What factors affect the magnitude of the induced voltage in a coil?

A: The magnitude of the induced voltage in a coil is influenced by several factors.

Q: a. If the refractive indices of medium 1 and 2 are n₁ = 1.54 and n₂ = 1.50, respectively, find the…

A: The critical angle can be calculated using Snell's law and the formula for the critical angle:…

Q: For the system, make an accurate plot of the root locus and find the following: a) The breakaway and…

A: Given: GsHs=Ks+2s+1s-1s-2 Required: Make an accurate plot of the root locus for the given system…

Q: A 2 pole, 50 Hz, 13.8 kV, 10 MVA, start connected synchronous generator achieves the rated…

A:

Q: What is the relative permitivity of the insulator used in a capacitor given that a copper resistor…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: t n. Determine the output waveform for the network below and calculate the output dc level and the…

A:

Q: A 460 V, 50 kW, 50 Hz, three-phase synchronous motor has a synchronous reactance of Xs = 4.15 Ω and…

A: VL = 460 Vf = 50HzP = 50 KwXs = 4.15 ΩLaf = 83 mHPin = 40 Kw

Q: 2. For the figure below, determine the (a) Power dissipated in the load (b) Wattmeter reading 1=20 A…

A: In this question We need to determine the power dissipate across the load and wattmeter reading.  We…

Q: 5) a) For the circuit shown in the figure, write an equation for potential difference VA-VB in terms…

A: In this question We need to determine the voltage difference between the A and B terminal.  VAB = VA…

Q: QUESTION 6 A unity feedback system has the open loop transfer function shown below. Use the Nyquist…

A: Transfer function is given as, HG(s)=k(1+s)s21+s102

Q: Draw the analogue electrical system of the mechanical network using Force-Voltage Analogy.

A: For the given mechanical translational system the equivalent electrical network needs to be obtained…

Q: For V1=30, R1=430, and R2=660 of the figure shown below, Determine the currents I₁, I2, and ID2. + E…

A:

Stator and Rotor Magnetic Field

The stator and rotor magnetic field is the resulting magnetic field generated by a system of coils that are symmetrically aligned. They are supplied with polyphase currents. The magnetic field is generated by poly-phase (two or more phases) current or single-phase current. In the latter case, two field stator windings are supplied and two resulting electromagnetic fields are generated beyond the stage.