into the parallelogram shape as shown in the figure. All edges remain the same length a, as the sheet deforms. Determine

Q: A hollow aluminum box beam has the square cross section shown in the figure. Calculate the maximum a...

A: Given:- V=28k To find:- the maximum and minimum shear stresses πmax and πmin

Q: Given: Instrument @ "B", BS "C", FS "A" Northing B = 5000.000, Easting B = 10000.00, Elevation B = 5...

A:

Q: A single stage standard rate trickling filter treats a flow of 3.79 MLD of sewage with BOD of 156 mg...

A:

Q: Q3. Find out the support reactions, by using energy methods. M, EI A C 2L

A:

Q: Determine the design flexural strength in ft kips of a W12 x 35 of A242 (Fy = 50ksi) steel subject t...

A:

Q: The first layer 2m thick very fine wet sand with silt having water content of 8% and S=45% lying in ...

A:

Q: A solid circular disc of uniform thickness of 10 mm, radius 500 mm and mass 10 kg is used as a flywh...

A:

Q: A trench was cut in a clay slope as shown in the figure. When the trench reached a depth of 3 m, the...

A: Given data, depth =3m  

Q: Determine degree of static indeterminacy

A:

Q: Which of the following has no effect on the rate  of evaporation from soils A) Radiation B) Temperat...

A: Radiation, temperature and vapour pressure deficit has the effect over rate of evaporation from soil...

Q: Which of the following defines a Bar Chart the most? 1. A line graph of repeated measurements tak...

A: To choose the choice which gives the most accurate definition of a Bar Chart.   Option 1: A line gra...

Q: a 4 m C 4 m 12 kN 6@3 m 18 m %3D

A:

Q: In its natural condition, a soil sample has a mass of 2270 g and a volume of 1.15x10-3m3. After bein...

A: Given data : Specific gravity of soil solid GS=2.68 Wet mass of soil MWet=2270 g Dry mass of soil MD...

Q: A dose of 100 me/l of alum is used in coagulating a turbid raw water. Calculate the sum of amount of...

A:

Q: Find the discharge i8 Area f retanjular channel 20 mt and uelocity of water Vs

A: Introduction : The given question is related with fluid mechanics . In this question we are provided...

Q: Why is the knowledge in air conditioning as well as Air Handling Unit (AHU) plays an important role ...

A: 1. The major goals of a heating, ventilation, and air-conditioning (HVAC) system are to offer therma...

Q: What is the amount of load that center of the rectangular concret To ic 3 5ON

A: Modulus of ruptutr is given by :M=3PL2bd2

Q: (a) Determine the reactions at A and E if P- 1010 N. The reactions are positive if to the right or u...

A:

Q: Design the most economical A36 steel base plate to resist a dead load = 1,400 kN and a live load = 1...

A: Solution: Given: Live Load = 1700 kN; Dead Load = 1400 kN fc = 27 MPa; Column dimension = 700 mm x 7...

Q: Draw the shear and moment diagrams for the simply supported beam. Indicate the point of maximum mome...

A:

Q: Give the pros/advantages and cons/disadvantags of outer-pipe inspection along wi a some explanation.

A: Advantages of Outer-pipe inspection Easy detection of Pipe issues: A professional pipe inspection w...

Q: What is the depth of water in a trapezoidal channel with z=2 and carrying a 2.5 m3/s water flow? The...

A:

Q: 1 Example 3 Design a simply supported rectangular reinforced beam with tension steel only to carry a...

A: Design is as per ACI CODE 318

Q: Determine degree of static indeterminacy

A: Introduction : The given structure is beam structure . We have to compute degree of static indetermi...

Q: Estimate the number of plywood and ceiling joist required for a bedroom with general dimensions of 4...

A:

Q: Q3 Water in a horizontal channel accelerates smoothly over a bump and then undergoes a hydraulic jum...

A:

Q: Consider the beams under the action of the loads shown. Which of the following bending moment sketch...

A: here is your answer ;

Q: 2. Water is pumped from reservoir A at elev. 15 m by a 150mm diameter pipe 200m long with a friction...

A:

Q: e cross-sectional area. Determine the average normal stress acting at na-a. Show this distribution o...

A:

Q: In calm waters, the oil spilling from the ruptured hull of a grounded tanker spreads in all directi...

A: To determine the rate of increase of area that is affected by the soil spill at given radius of the ...

Q: 200mm 15 mm 15 mm 200 mm 15 mm 200mm II. Determine the following: 1. Uniform weight. 2. Centroid fro...

A:

Q: Which of the following diameter of Grade 60 reinforcing bar can withstand a tensile load of 210 000 ...

A: step 1-

Q: A nozzle meter is connected with a pipe line to measure fluid flow rate as shown in Fig. 2. The diam...

A:

Q: The bubble tube of a level has sensitivity of 30" per 2mm divisions. Find the error in staff reading...

A:

Q: In its natural conditioh, a soil sample has a mass of 2270 g and a volume of 1.15x10-3m3. After bein...

A:

Q: A simply supported 20 m effective span RCC rectangular beam 600 mm x 1500 mm is reinforced throughou...

A:

Q: 1 The value of integral 7 (cosx,5z,6z + zsinx) · (x,y,z) ds where s is the surface of sphere x2 + y?...

A:

Q: Apply this to the special case b;=3 m, b2=2 m, and y,=1.9 m. a) Find the flow rate if y2=1.5 m. b) A...

A: Given -  To Find - a - find flowrate if y2 = 1.5mb- Find the depth y2

Q: A simple beam of length L 5 5 m carries auniform load of intensity q 5 5.8 kN/m and a concentratedlo...

A: Given:- P=22.5kN q=5.8kN/m To find:- (a) Assuming σallow =110 MPa, calculate the required section mo...

Q: Oueston- Calulote min sD auinad to ovoiolo heod on Collision Of fwo Cars oPoching from the opposite ...

A: Given-V=90 kmph and 60 kmphReaction time t=2.5sCoefficient of friction, f=0.7Brake efficiency, n=50%...

Q: 16 ft 100 kip • ft D 2/3

A:

Q: Pros and cons of Land severance

A:

Q: Cueston- Colaulote min sD rawired to ovoiol o heod on Collison from the opposite drrechin ot aod • o...

A: Given data- Speed of the cars V=90 kmph & 60 kmphReaction time t=2.5scoefficient of friction, f=...

Q: Use Slope-Deflection Method to solve for the unknows on the 120mm x 120 mm beam shown in figure. E =...

A: Slope deflection method Fixed end moment due to udl wl^2/12 Due to uvl wl^/30 and wl^2/20

Q: A 44KN/m distributed dead load, "w" kN/m distributed live load and a single 15kN point load may be p...

A: Given data; Distributed dead load =44 kN/m Point load =15kN Reaction at A =958.5kN

Q: Use Slope-Deflection Method to solve for the unknows on the 120mm x 120 mm beam shown in figure. E =...

A:

Q: b 2 m 3 m 12 kN 4@4 m = 16 m %3D

A:

Q: Compute for the corrected amount of water needed in the concrete mix if the mass of fine and coarse ...

A:

Q: A reducer bend having an outlet diameter of 15 cm discharge freely. The bend, connected to a pipe of...

A:

Q: An RCC square footing of side length 3 m and uniform effective depth 250 mm is provided for a 300 mm...

A: Given data  Length of Square footing L = 3 m = Width B Uniform Effective depth d = 250 mm Column dim...