Intravenous therapy usually is driven by gravity by hanging the fluid bottle at sufficient height to counteract the blood pressure in the vein and to force the fluid into the body. The higher the bottle is raised, the higher the flow rate of the fluid will be. (a) If it is observed that the fluid and the blood pressures balance each other when the bottle is 1.2 m above the arm level, determine the gage pressure of the blood. (b) If the gage pressure of the fluid at the arm level needs to be 20 kPa for sufficient flow rate, determine how high the bottle must be placed. Take the density of the fluid to be 1020 kg/m3.

Q: Pure milk at 293 K has a density of 1030 kg / m3 and a viscosity of 2.12 cp flowing at a rate of 2,4...

A: Given that, Temperature T = 293 K Density ρ = 1030 Kgm3 Viscosity μ = 2.12 cP = 0.00212 Pa.s The mas...

Q: An industry produces a degradable waste at flow rate of 0.72 m^3/day. Concentration of pollutant in ...

A: The flow rate of a degradable waste FA = 0.72 m3/day Initial concentrations of raw waste CAo = 850 m...

Q: In a steam engine the pressure P and volume V of steam satisfythe equation PV1.4 = k, where is a con...

A: The work done by the engine in its cycle is to be calculated.

Q: The percent absolute humidity of air at 300C (1.253 in. Hg vapor pressure) and a total pressure of 7...

A: Given, Ptotal=790 mm Hg and at 300 oC, P1*=1.253 in. Hg By unit conversion, we have, 1 in Hg=25.4 mm...

Q: 13.) The density of steel is approximately 7600 kg/m³. Express the density in BG and U.S. Customary ...

A: Given: Density of steel = 7600kg/m3 We are asked to express the density in BG and US customary units...

Q: Pure methane is burned with 40% excess air and 25% of its carbon content is converted to CO, the res...

A: (B) 53.11o C  

Q: Which line must the temperature and pressure have crossed if a squid sample of X is observed to free...

A:

Q: 7.) The czpnduction heat transfer rate through a wall is modeled by the following equation: Q = k4AT...

A:

Q: Pyrite with analysis of 78% FeS2 is burned with 25% excess air (FeS2 ® SO3). 85% of the FeS2 burned ...

A: The schematic diagram for the given process is prepared as:

Q: 12.) An individual running on a treadmill machine generated an average power of approximately 0.27 h...

A:

Q: Give four challenges and suggest solutions for those challenges in biogenic formation

A: The challenges associated with biogenic formation along with the solutions are to be mentioned.

Q: Question : Carbon dioxide (CO2) and methane (CH4) exists as gaseous substances at room temperature. ...

A: The bonding pattern among the molecules of dry ice and LNG is to be mentioned.

Q: Calculate the fraction of pentane in the liquid that is in equilibrium with the following vapor at 8...

A: Given that, Temperature T = 80oC = 353.15 K Composition (in mole fraction) of vapor phase Ethane = 0...

Q: Refrigerant 22 enters a compressor operating at a steady-state as saturated vapor at 10 bar and comp...

A:

Q: In the figure, are the two processes described by G1 and G2 interacting processes? Why or why not?

A: Interacting processes- It is the system in which input of one system is changed then it has an impac...

Q: A weather balloon calibrated at 0.00 °C to have a volume of 20.0 L has what volume in L at -40.0 °C ...

A: Given that : Balloon is calibrated at 0.00oC and have a volume of 20.0L Pressure is constant we need...

Q: An open U-tube manometer according to Figure 2.2-.4a (Geancopical Book) is used to measure the absol...

A:

Q: Determine the Reynolds number for a flow of 25 ° C water in a 1 in diameter sanitary pipe at a rate ...

A: Write the equation for Reynolds number as follows: Re = Duρμ     .......(1) Here, Re is Reynolds num...

Q: According to the following reaction, how many grams of carbon tetrachloride will be formed upon the ...

A:

Q: A real gas mixture consists of 35% N2 and 65% C2H4 (on molar basis), hasa pressure of 18 MPa and a t...

A: The value of the molar-specific volume of the mixture is to be determined and a comparison of this v...

Q: When iron rusts, it combines with oxygen to form iron () oxide according to the following unbalanced...

A:

Q: Examine the reaction equation below. "Heat" being present on the reactant side of an equation indica...

A: Given reaction: Heat + 2NH3 → N2 + 3H2 It is required to determine what does the heat being present ...

Q: Consider a refrigeration system based on an ideal vapor-compression cycle using R-134a as the refrig...

A:

Q: As you know, power production is a very important process in our society. Superheated steam at 40 ba...

A:

Q: A sample of gold weighing 227 grams is cooled then placed in a calorimeter containing 31 grams of wa...

A:  Write the expression for heat of reaction as follows:Q = mCpTf-Ti      ......(1)

Q: 3.) Convert the information given in the table below from the U.S. customary units to SI units. U.S....

A:

Q: Heat Transfer Question

A: Given that, The viscosity of fermentation broth μ = 10-2 Pa.s The density of fermentation broth ρ = ...

Q: Consider a hemispherical droplet of liquid water residing on a flat surface, as shown in the figure....

A: Given data: The vapor pressure of water at 40 0C (pA1) = 0.073 atm Diffusion coefficient of water va...

Q: You desire to flash separate 10 mol/s of an equimolar liquid mixture of 1-butene (1) + n-heptane (2)...

A: Initial moles of the mixture, n = 10 mol/s The mixture contains equal moles of 1-butene (1) and n-he...

Q: A gas whose viscosity is 200uP flows through a capillary tube 2 mm in diameter and 2 meters long. If...

A:

Q: 9.) A motorcyclist who weighs 160 lbf accelerates his motorcycle at a rate of 10 ft/s² over a distan...

A:

Q: 6

A: Energy density of pure gasoline = 115600 BTU/gallon Energy density of ethanol = 75670 BTU/gallon Cos...

Q: Give four challenges and suggest solutions for those challenges in Butterfly valve

A: Our objective is to write the challenges and the solutions for those challenges in butterfly valve.

Q: A refrigerator has an ice tray compartment at -18.0°C and the room temperature is 20.2°C. The refrig...

A:   Given:                     Mass of water, m=377 g            Specific heat of ice, Ci=2.09 kJkg·K ...

Q: Ten pounds of water at 35oF, and 6.00 lb of steam at 250oF and 20 psia are mixed together in a conta...

A: Given: Temperature of water = 35F                                    =35-321.8°C=1.67°C mass of wate...

Q: In the manufacture of nitric acid, ammonia and preheated air are mixed to form a gas containing 10.0...

A: Given that, Mole% of NH3 in the gas mixture of Ammonia and air = 10% = 0.1 Initial Temperature of Am...

Q: The surface pressure of the liquid fuel in the tank is 152.6 kN / m2. The depth of the liquid in th...

A: Given, pressure at surface,  p0 = 152.6 kNm2×1000 N1 kN×kg·m/s2Np0 = 152600 kgm·s2 depth of the liqu...