is 125 N t = 0 t. 25 V 6.25 µF7 Vo3250 mH Figure P8.30 Full Alternative Text HE

Q: The switch in the circuit  hasbeen in the left position for a long time before moving to the…

A: The circuit diagram is shown below: At t=0, the switch is moved, the voltage across the capacitor…

Q: 8.33 Switches 1 and 2 in the circuit in Fig. P8.33 are syn- chronized. When switch 1 is opened,…

A: we need to find iL(t) for t>=0

Q: The switch in the circuit hasbeen in position a for a long time. At t=0 the switch…

A: When switch is at position “a” for very long time, then capacitor will act as open circuit and…

Q: Q # 01 In the parallel circuit of Fig. 8.13, find v(t) for t> 0, assuming v(0) = 5 V, i(0) = 0, L =…

A: consider the given question ;

Q: Q8. Explain briefly the application / use of Capacitor 1 and Capacitor 2 in the circuit shown in…

A: Capacitor: This is used to store the energy in electric form.

Q: t31s R4=2K + lóuf R2 R3 50v R1 1K 5k Sk Discussion: 1. Find the initial and forcing capacitance…

A:

Q: 1- Practice Problem 8.7 Having been in position a for a long time, the switch in Fig. 8.21 is moved…

A: Initial switch at position a.  Capacitor act as open circuit after long time.  At time t= 0 sec,…

Q: 2) Consider the closed-loop system shown in Figure 1, If K/J=4, what is the value of Kh will yield…

A: First we will find closed loop Transfer function than we will compare with standard second order…

Q: In the circuit , the resistor isadjusted for critical damping. The initial capacitor voltage is 20…

A: Capacitance is given, Inductance is given , Angular frequency is given by,

Q: 8.33 Switches 1 and 2 in the circuit in Fig. P8.33 are syn- chronized. When switch 1 is opened,…

A: we need to find iL (t) for t>=0

Q: The switch in the circuit hasbeen open for a long time before closing at t=0. Find io(t) for t≥0

A:

Q: Obtain an expression for vc in the circuit of Fig. 8.87 valid for all values of t. (b) Sketch vc(t)…

A:

Q: 39. The inductor in Fig. 8.71 is storing 54 nJ at t = 0. Compute the energy remaining at i equal to…

A: The solution can be achieved as follows.

Q: 8H i(t) Q.39: The switch in the circuit shown in figure beside has been closed for a long time, then…

A:

Q: The circuit in Fig. 8.12 has reached steady state att = 0¯. If the make before-break switch moves to…

A: Given RLC circuit shown

Q: 2. Exercise 8.37 in text 37. For the circuit shown in Fig. 8.69, determine (a) vc(0~); (b) vc(0*);…

A: In steady state capacitor will be open circuit  (a) On applying KCL at point (P)Io =…

Q: The switch in the circuit  hasbeen open a long time before closing at t=0. At the time the…

A: Given: In a circuit

Q: 8.17 In the circuit of Fig. 8.71, the switch instantaneously moves from position A to B at t = 0.…

A: Solution: Given data, For , the switch is at position ‘A’. At , the switch is connected to position…

Q: The resistor in the circuit shown is changed to 250 Ω. The initial energy stored is still zero. Find…

A: To do the circuit analysis the circuit be modified as by using a source transformation circuit we…

Q: Having been in position a for a long time, the switch in Fig. 8.21 is moved to position b at t = 0.…

A: For t<0 the circuit becomes, From circuit apply voltage divider rule: v(0)=18×22+1=363=12 V The…

Q: A series RLC circuit has a resistance of 30 ohms, a capacitance of 10-2 Farads, an inductance of 5…

A:

Q: 8.36 Find v, (1) in the eircuit in Fig. PS.36. 10 A 0.1 H 0.005 F 100 cos 401 V 40 cos (40t - 30) v…

A:

Q: Practice Problem 8.7 Having been in position a for a long time, the switch in Fig. 8.21 is moved to…

A: V(t) and VR(t) for the following circuit is determined as shown below

Q: Figure P8.48 100 Ω 20 Ω 12 2 t = 0 300 V 2 mH 5 µF

A:

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

A:

Q: 8.6 Find values of vc and vo in the circuit of Fig. 8.23 at t equal to (a) 0-; (b) 0*; (c) 1.3 ms.…

A:

Q: In the circuit of Fig. 8.23, find i(1) and ig(t) for t> 0. 20 Ω 1 = 0 ww 4 A 4 20 H 20 Ω. 8 mF |…

A: According to the question we have to find i(t) and ig(t) for t>0.

Q: +1 5V +) 16u(t) V – FIGURE 8.89 100 Ω 400 Ω i(t) 5Η

A:

Q: 10) The phasor diagram for the circuit shown in Fig. 6 is: VR R Va Ve Fig. 6 None of these VE (c)…

A:

Q: IRT C Vo R Answer: (a) 100 2: The resistor in the circuit in Assessment Problem 8.4 is adjusted for…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: The circuit shown has been inoperation for a long time. At t=0, the source voltage suddenly…

A: Draw the circuit for t < 0.

Q: Find the voltage across the capacitor as a function of time for t>0 for the circuit in Fig. 8.72.…

A:

Q: Find i(f) and v(r) for t > 0 in the circuit of Fig. 8.24. Practice Problem 8.8 Answer 10(…

A: For the given circuit i(t) and v(t) is calculated as shown below

Q: An RL series circuit has an EMF (in volts) given by 3 cos 2t, a resistance of 10 ohms, an inductance…

A:

Q: 10. (a) With reference to the simple circuit of figure 8, compute i(t) for (a) t = 0- ; (b) t = 0*;…

A:

Q: RC and RL 28. The switch shown in Fig. 8.65 has been closed for 6 years prior to being flipped open…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: 8H i(t) Q.39: The switch in the circuit shown in figure beside has been closed for a long time, then…

A:

Q: Assume that at the instant the 2 A currentsource is applied to the circuit the initial current in…

A: Let V be the voltage across all the elements in the circuit. Redraw the circuit for t > 0 in the…

Q: 8.14 The switch in Fig. 8.69 moves from position A to position B at t = 0 (please note that the…

A:

Q: Practice Problem 8.9 Determine v and i for t > 0 in the circuit of Fig. 8.28. (See comments about…

A: Solution: The given circuit is For , source is not connected to the circuit therefore the initial…

Q: Exercise 1 F The circuit in Fig. 8.12 has reached steady state at t = 0. If the make- before-break…

A:

Q: For the circuit in Fig. 8.7. find: (a) iL(0+). vc(0*). vg(0+). (b) dir(0*)/dt, dvc(0*)/dt,…

A: We know behaviour of capacitor and inductor at t =0 and t tends to infinity . We will replace by…

Q: 8.14 Find each capacitor voltage in the circuit shown in Fig. 8-9. 20 F 30 μF Ht 400 V Ht V₁ 40 μF…

A:

Q: 8.30 Find vd) and i,(1) in Fig. P8.30. 3H 2H F0.1 F 25 cos 21 V i,(1) (1)°a 0.05 F vo(1) 50 Figure…

A:

Q: In the circuit shown in Fig. 8-14, the switch closes at t=0 s. Find r, and i for >0 s if (0) 100 V.…

A:

Q: Practice Problem 8.8 Find i(f) and v(f) for t > 0 in the circuit of Fig. 8.24. 12u(t) A 0.2 F 5 H…

A: we will use KVL to find the differential equation governing the system. And we will use initial…

Q: In a short circuit test conducted on a circuit breaker, the maximum restriking voltage is observed…

A: Maximum re-striking voltage, Vm=160kV

Q: I need the answer quickly

A:

Q: If the switch in Fig. 8.100 has been closed for a long time before t = 0 but is opened at t = 0,…

A:

Q: 8.20 The switch in the circuit of Fig. 8.74 has been closed for a long time but is opened at t = 0.…

A: