Is Is 25 A Power absorbed by R₂ will be: None of the above 1200W ●7500W R₁ 300W M R₁-3 ohms. R₂- 12 ohms. R₂ 2/

Q: Why would we want to use circuit theory and when can we use it? What are the characteristics of…

A: When the two charges are separated by a small distance, then it forms an electric dipole. The…

Q: 23. Determine stability of the following systems. Check for BIBO, symptotic and integral stability.…

A:

Q: The magnitude is nonnegative. If the amplitude of a sinusoid is given by a negative number, the…

A: We need to find out phase of given function

Q: 33. Determine Vo for each network of Fig. 2.177 for the input shown. V₁ 12 V -12 V Si 2.2 ΚΩ (a) V₂…

A:

Q: Explain how one can distinguish between two circuit elements which are connected in series verses…

A: In networks we can have passive elements like resistor, capacitor and inductor that can connect…

Q: 6. Find ; whose transfer function is G(s) = 361 s2+16s+361

A: Given: Transfer function, Gs=361s2+16s+361

Q: In the circuit shown in Figure 10.27, find the transfer function H(w) = Vo/Vin 1/(jwC) HH in O +…

A:

Q: An ideal transformer has a turns ratio of 15:1 and is supplied at 180V when the primary current is…

A:

Q: A What is the equivalent resistance of the circuit of fig. between terminals A and B bur UN 32 823…

A:

Q: When the rms output voltage of a bridge full-wave ideal diode rectifier is 5 V, the peak inverse…

A:

Q: given BJT has an emitter current of 15 mA and a collector current of 14.95 mA. What is the exact…

A:

Q: A 4-pole generator has a lap-wound armature with 60 slots with 15 conductors per slot. The useful…

A: Given, In a dc generator, Number of poles, P=4 Lap wound so number of parallel path, A=P=4. Slots is…

Q: 3. Determine the current and voltage through R₁ and the power absorbed by R1 using mesh analysis. R1…

A:

Q: Q5: An output pulse of 3 ms duration is to be generated by a 74LS122 one-shot. Using a capacitor of…

A:

Q: A uniform line charge of 16 nC/m is located along the line defined by y=-2,2 = 5. Determine E at…

A:

Q: 4 Find the F. T. of the following Signals using differentiation prop. X(t) = 2 S (+2) -2 S(t-2)…

A:

Q: When the current diode is large, the bias is forward inverse O poor reverse Other:

A:

Q: The cathode of zener diode in a voltage regulator is normally 1- less positive than the anode 2-…

A:

Q: find the transfer function G(s)=Ɵ1/T(s

A: Given : Rotational mechanical system Find : Transfer function:G(s)=Ɵ1/T(s)

Q: Q5) Use superposition to find v, in the circuit of Fig. 5. 4 A 2 Α 10 Ω 8 Ω ΜΕ Figure 5 12 V 5Ω www

A:

Q: . (A)-Create an 8086 Assembly language program that subtracts two 8-bit ASCII numbers, the first and…

A: Given: 8086 Assembly language program to subtract two 8 bit ASCII numbers. Two 8-bit ASCII numbers…

Q: Let R₁ = 25 2, R₂ = 75 2, L = 69 mH, C = 46 µF, and vs(t) = 155 cos(2 R₁ R₂ HI Figure 9.22 O a.…

A: GIVEN:  R1=25ΩR2=75ΩL=69mHC=46μF VS(t)=155 cos(2π×50t)+60°) FIND: impedance of the capacitor and…

Q: Using voltage divider for the below circuit Find V₂ ? U₁ 10 V + 01 R₁ 8 ΚΩ O R₂ 12 2 ΚΩ U2

A: please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: In the circuit shown in Figure 10.18, find the mesh current I₂. Zc R₁ 56 20° V Figure 10.18 a. 12 =…

A: This is a problem of circuit. The calculation is shown in the next step

Q: A lead wire and an iron wire are connected in parallel. Their respective resistances are in the…

A:

Q: 9. In cases where huge starting torque is required for accelerating heavy loads, preferred. a.…

A:

Q: A three phase balanced load having a power factor of 0.52 lagging draws a line current of 25A at…

A:

Q: how to stop a rapid rise in power supply from destroying and malfunctioning your computer

A: Power surge:- A significant increase in the current flowing through your electrical system causes…

Q: What is the noise power bandwidth greater than the half power bandwidth of a system?

A: please comment if you need any clarification if you find my answer useful please put thumbs up.

Q: Find Fat the rect (t=1)-rec७(611)

A:

Q: Q5: An output pulse of 3 ms duration is to be generated by a 741S122 one-shot. Using a capacitor of…

A: Given data:- Time period, T= 3 ms Capacitor, C= 50,000pF The 74LS122 is a retriggerable monostable…

Q: If the two headlights of a car each dissipate 55W and each of them are connected to the two…

A:

Q: The resistance of a conductor 1 mm² in cross-section and 20 m long is 0.346 2. Determine the…

A:

Q: 8 In wien's bridge, the output frequency is determined by: a-LC combination. c- RLC combination.…

A: Weins Bridge The Weins bridge was developed by Max Wien in 1891. It contains 4 resistors and 2…

Q: Represent v(t) = 350 cos(250t +150°) - 280 сos(2л5оt -30°) V by a single sinusoid. O a. v(t) = 630…

A: We need to simply the given function

Q: 37. Sketch v, for each network of Fig. 2.181 for the input shown. 20 V -20 V C HH Ideal C C ott…

A: We need to find out output voltage for given circuit

Q: The function F(A, B, C, D) shown in the Figure can be simplified to: Note: o is XNOR symbol (Ao B) +…

A:

Q: a. Calculate 57. b. Compare 57 to half the period of the applied signal. c. Sketch Vo Vi 12 V f = 1…

A:

Q: A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 resistor…

A: Inductance (L) = 318.3 mH Resistance (R) = 200 Ω Frequency (f) = 50 Hz Voltage (V) = 240V We have to…

Q: Determine the value of the Current 13. +1 12 V + - ww 892 O A. 0.44 Amps OB. 1.05 Amps O C. 0.15…

A:

Q: How many persons in a conference room? that have the following conditions RSH= 0.030MW, sensible…

A: SOLUTION GIVEN-->                ROOM SENSIBLE HEAT = RSH…

Q: Example 4.5. A generating station has an installed capacity of 50,000 kW and delivers 220 × 10 units…

A: We have generating station which has,   Installed capacity = 50,000 KW Units delivers/Annum = 220 *…

Q: x(t) = 26(t+2)-26(t-2) - rect( ct (²+¹) +rect (¹¹)

A: Given: xt=2δt+2-2δt-2-rectt+12+rectt-12. Require: Fourier transform of the given signal.

Q: Select true or false for 1 and 2 1 Op amp component is temperature limited due to maximum output…

A: Op-amp is an operational amplifier that performs arithmetical operations like addition, subtraction,…

Q: A MOSFET has........ Select one: O a. four O b. two O c. three O d. five terminals

A: The MOSFET stands for Metal oxide semiconductor field effect transistor. It is a semiconductor…

Q: A battery of unknown e.m.f. is connected across resistances as shown in Fig. 2.26. The voltage drop…

A: We have a circuit as shown in figure .   We have been asked to find the reading of the ammeter means…

Q: please solve step by step. please show all properties of op-amp.

A:

Q: Q5: An output pulse of 3 ms duration is to be generated by a 741S122 one-shot. Using a capacitor of…

A:

Q: 36. Sketch ig and v, for the network of Fig. 2.180 for the input shown. 10 V -10 V VI 16 10 km2 5.3…

A:

Q: Find F-T it. -X(t) = 28 (+ +27_28 (+-2)_rect (6+1) +rect 8-1 auso 4 (Sin² (w) - 25/uc (ZW)) Hello…

A: Note:  The given answer is incorrect. The correct answer is given below

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.