Is the thickness of an insulating material considered as the outer radius in computing the insulation resistance of a cable? Yes or no. * Your answer These are the electrons in the outermost shell of an atom that experience the least force of attraction towards the nucleus. * Your answer Does higher resistivity mean good insulator or good conductor? Write either good insulator or good conductor. Your answer

Is the thickness of an insulating material considered as the outer radius in computing the insulation resistance of a cable? Yes or no. * Your answer These are the electrons in the outermost shell of an atom that experience the least force of attraction towards the nucleus. * Your answer Does higher resistivity mean good insulator or good conductor? Write either good insulator or good conductor. Your answer

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.1P: The Aluminum Electrical Conductor Handbook lists a dc resistance of 0.01558 ohm per 1000 ft at 20C...

See similar textbooks

Similar questions

A 415 single core cable has a conductor diameter of 0.5 cm and a sheath of inside diameter 3 cm. In cable insulation, find: (i) minimum stress (in V/cm); (ii) maximum stress in (V/cm); (iii) Describe where these minimum and maximum stress will occur in cable insulation?; (iv) Suggest what should be the minimum dielectric strength (in V/mm) of the cable insulation to avoid any breakdown of the given cable
Why are materials that are good thermal conductors also good electrical conductors? What kinds of problems does this pose for the design of appliances such as clothes irons and electric heaters? Are there materials that do not follow this general rule?
Compute the resistance of a conductor whose resistivity is 20.54 ohm-CM per foot with circularc ross-sectional area of 38 mm2a nd length of 5,000 meters. If the conductor is drawn until its resistance becomes 10 ohms, what will be its new length?
Theoretically solve an unknown resistance for Transmission line conductor by using any two methods (for example: Wheatstone bridge, Kelvin bridge, Potentiometer method etc). And then compare them and state that between in this two used methods which one is better and why. [Note: You can choose any practical value for ratio arms]
A solid cylindrical aluminum conductor 25 km long has an area of 336,400 circular mils. Obtain the conductor resistance at 20C and 50C. Find the AC resistance per Km of the cable at 50C. Assume a skin-effect correction factor of 1.02 at 50 Hz. The resistivity of aluminum at 20C is 2.8x10-8 Ωm
Q3. What will happen if the conductor in black wire and green-yellow wire touches each other? What will you do to solve this problem?
A three phase, 33 KV, underground cable system, consider a single core of conductor radius 0.8 cm diameter and lead sheath of 2.3 cm. The core and lead sheath have been separated by two intersheaths with radius 1.3 cm and 1.8 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same. Please i need it know please
In your own words, define a. an ideal conductor; b. an ideal voltage source; c. an ideal current source.
A lead conductor is 5cm in length and 8 sq. cm in cross-sectional area. The terminals to be joined by this conductor are 8 cm apart. Hence, the conductor was pounded and reshaped until it is 8 cm long. If the resulting conductor has uniform cross-sectional area, determine the resistance. Resistivity of leads is 22x10^-8 Ω-m.
7. Write an equation for the currents that pass thru point b? 8. What can you conclude about the currents that enter and exit branching conductors?
Non Ferrous Metals possess High Electrical insulation properties? Select one:True False
Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and the ratio of C1/C=0.1 (Shunt capacitance per self-capacitance) is given. If the string is connected to line of voltage 33kV. a) What is the voltage distribution over the unit of string and what is the string efficiency? b) When the string is supplied by a Guard Ring and this lead to add a two air capacitance of value 0.2C, 0.1C respectively to the nearest to the conductor. Find the new voltage distribution and the new efficiency.