is + Vo Len ti 20 mH m in 4 mH 6 mH

Q: Find the elements of the equivalent circuit relative to the secondary of a single-phase transformer.…

A:

Q: If the voltage of the carrier (Voc) is greater than from the Voltage message (Vm). Therefore the…

A:

Q: Design a system that has a 15% overshoot and stabilizes in 2 seconds. analyzes its absolute…

A: The maximum percentage overshoot of the system is 15%.The settling time is 2 seconds.

Q: A 3200/240-V, 60-Hz, 1-phase transformer is built on a core having an effective cross-sectional area…

A: For single phase transformer,

Q: 3. a) Consider a single tone message signal m(t) = Am cos(2nfmt) where fm = 30 Hz is the message…

A:

Q: 23] Determine the output of LTI system h(n) = =(5,6,5} if if the input signal is x(n) = {1,0,5}

A: We need to find output of LTI system y(n)Where impulse response h(n)={5,0,5} start at n=0 , and…

Q: A shunt generator has a full-load current of 44A at 150V. The stray losses are 625W and the shunt…

A: Given:Full load current Stray losses Shunt field resistance To determine:Input power Armature…

Q: 1- ..the value of path loss that one expects to be exceeded by the actual path loss 50%. 2- Radar…

A: “Since you have posted multiple questions, we will provide the solution only to the first five…

Q: Design the oscillator circuit as shown in fig(3) for frequency of IkHz, given FET parameters g-Sms,…

A: Given:

Q: True or False 1. In solid grounding large fault current flows between the fault point and the…

A: We need to tell about whether the given statement are true or false.

Q: What is the response time of LCDs?

A:

Q: 1. The initial voltage across the capacitor at t = 0 in the circuit shown in following figure is…

A: In this questionWe need to determine the voltage across the capacitor C and current in it. We…

Q: The op amp in the circuit in (Figure 1) is ideal. Figure V₂ 20 ΚΩ ww 5 ΚΩ w 160 ΚΩ ww +●+ 18 V -18 V…

A: The circuit diagram,

Q: Q5) A system is given as a) -3, b)-33 considering the root-locus, calculate the location of the…

A:

Q: the ripple factor of a capacitor filter for a peak rectified voltage of 30 V, capacitor C = 50 µF,…

A: Given dataPeak rectified voltage, Capacitance, Load current, To find outWe have to determine the…

Q: 25 V + 15 Ω 10 Ω 10 F #l} ν 10 Η mor 20 Η ell www 10 Ω

A: it is asked to find i, v in given circuit under steady state conditions

Q: Chose the Q/ For the type E chopper to be operated in the fourth quadrant? A. only switch is…

A: type E  chopper : a four quadrant chopper is a chopper which can operated in all the four quadrants…

Q: 12.79V 1.32 M 0.4л I г DIZA 3124 льте

A: Circuit diagram is given as,

Q: a- Use Norton's theorem to find the voltage and power through R₂ in the following circuit. b-…

A:

Q: The expression of the current source in the circuit in the figure is as follows: i(t) = 10cos(wt +…

A:

Q: 5. The transmission line of Problem 4 above is energized with 765 kV at the sending end when the…

A: Solution:Given Data:sending end voltage =765 KVReviving end voltage=735 KVLoad Resistance=264.5 ohm…

Q: 1) Find the current flowing through 10 resistance by using Kirchhoff's voltage law / Mesh analysis.

A: It is given that:

Q: Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. L = 1 h,…

A: In this questionWe need to determine the maximum charge on the capacitor C. We knowMaximum Charge on…

Q: Sv + + U X- vr 20 + 28 Find V and ix 2h tm 25862 YV

A:

Q: Calculate the ripple voltage of a full-wave rectifier with a 150 µF filter capacitor connected to a…

A:

Q: Example 7 For the circuit shown, use R1=R2=47k02, RE=5.7k 2, RC=3.3k 2, RL=10k 2 and Vcc=12V,…

A:

Q: 10 HP 380 Volt, 50 Hz, 2 pole, Y connected induction motor, the shaft of the motor is running at…

A: Given dataInitial speed, To find outWe have to determine the speed when the shaft torque is reduced…

Q: HSWOI 1- In a circuit, voltage and current are given by v(t)=10 sin (oot +30°) And i(t)=10 sin (oot…

A: In this question, we have to find the correct option regarding power consumption in the circuit,…

Q: What is the value of capacitance of a capacitor which has a voltage of 4V and has 16C of charge? A.…

A:

Q: The admittance for an inductor L is: Select one: O a. (SL) Ω-1 O b. C 1/(SL) H

A: Inductance is given as value L.

Q: Question No.84 Find the output Boolean function for the logic circuit. Ao Bº Di

A: Logic circuit:

Q: Describe the main features of the different types of technology that can be used for playing back…

A: Analogue recording:- Analogue implies to a continually shifting illustration of a continuously…

Q: Question 2 R(s) + K 114 s(s+1.4)(s+10) L(S) Y(s) Find the root-locus of our given system using the…

A: In this questionWe need to draw the root locus of the given system. P no of polesZ no of zeros.

Q: A 100 W, 250 V lamp is connected in series with a 100 W, 200 V lamp across 250 V supply mains.…

A:

Q: FET amplifier

A:

Q: +8) FIND i(t),:>0 2 k 13V 6k i(t) m mog (100 F Xt=0 4 k 6v

A:

Q: For the circuit shown, use R1=7MQ,R2=15M, Rs=2.9k 2, RD=5.9k, RL=1k , Rsig=1k and VDD=10V,…

A: The given problem is from MOSFET. For DC equivalent all the capacitor are opened. The detailed…

Q: 3 DECIMAL PLACES: Two 3-phase, 7.4 kV, star-connected alternators supply a load of 3008 kW at 0.8…

A: Given Data:The three-phase alternators 1 and 2 with,Rated voltage The synchronous impedance of the…

Q: 3.39 Use Laplace transformation to determine the mesh currents I(s) and 1(s) in Figure 3.36. Let v…

A: In problem 3.37 the value of the resistor is missing,The  circuit diagrams,

Q: Materials in parallel, supplying a load of 500 amps, with a terminal voltage of 240 volts, and the…

A: Materials in parallel, supplying a load of 500 amps, with a terminal voltage of 240 volts, and the…

Q: ASSESSMENT PROBLEM Objective 2-Be able to calculate the inverse Laplace transform using partial…

A: The transfer function,

Q: 1- The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in Fig.1.…

A:

Q: Derive SNR expression for an 8-bit quantizer (considering that the probability density function of…

A:

Q: Find V, in the network in Fig. 12/6°v(t 2Ω -jΩ Μ jΖΩ ΖΩ jΖΩ jin Ω 3Ω © V 2/0° Α

A: In this circuit, mutual inductance between two inductors is given. Two dependent voltage sources…

Q: Can you redo it? I need step-by-step solution, like there should be Step 1, Step 2, Step 3, and so…

A:

Q: in part a are you able to explain or show the steps where the j's cancel out from…

A: It is given that:

Q: Determine the capacitance between point A and B.

A: It is given that:

Q: Two alternators operating in parallel supply 2516 KW to a load at a lagging power factor of 80%If…

A:

Q: R ли ㅗ с mit Find the Power spent effective voltage value V=50√2 sin (2006) V R=3-2 С =им Ғ L = 0,18…

A: Voltage Resistance Inductance Capacitance

Q: 2. a) Consider a single tone message with frequency fm (double-sideband) modulated carrier of…

A: Given:a) Noise power, Pn = 0.5, b) Spectrum of m(t),