It is only required to move the cutting tool from the circumference to the center of the workpiece in a facing operation on a lathe because... C) Past the center of workpiece, the material moves away from the cutting edge and might damage the cutting tool A) Past the center of the workpiece, friction between the cutting tool and the work piece increases damaging the cutting tool OD) Both b and c B) Since the workpiece is rotating, cutting tool covers entire diameter E) a, b and c are correct

It is only required to move the cutting tool from the circumference to the center of the workpiece in a facing operation on a lathe because... C) Past the center of workpiece, the material moves away from the cutting edge and might damage the cutting tool A) Past the center of the workpiece, friction between the cutting tool and the work piece increases damaging the cutting tool OD) Both b and c B) Since the workpiece is rotating, cutting tool covers entire diameter E) a, b and c are correct

Precision Machining Technology (MindTap Course List)

2nd Edition

ISBN:9781285444543

Author:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Publisher:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Chapter4: Drill Press

Section4.3: Drill Press Operations

Problem 2RQ: Briefly define the term cutting speed.

See similar textbooks

Similar questions

Systematize the following operations in a rising sequence of their cutting speeds. (a) Turning (b) Grinding (c) Drilling (d) Milling
In which cutting process workpart is fed past a rotating tool with multiple cutting edges? a)Broaching b)Turning c)Milling d)Sawing
In toolbit nomenclature, the point where the primary and secondary cutting edges met. a. intersection point b. nose c. meeting point d. edge
Tool and cutter grinders can be used to _______ existing cutting tools or to create new, customized cutting tools.
Many of the cutters used in machining are made of either __________________ or ____________________.
Cutting action on the power hacksaw is very similar to the _________________ ______________.
What are the two basic types of tapping toolholders?
Sawing machines can be divided into roughly four categories. They are _________________, ______________, ________________, and the ______________.
Which must be set first, the tool geometry offset setting or the work offset setting?
The TPI specified on a print is 0.030". If checking a taper attachment setup with a cross-slide-mounted dial indicator, how much movement should register on the indicator if the carriage is moved 1" in the cutting direction?
If TPF is 0.42", how much movement should register on the cross slides digital readout in radius mode if the carriage is moved 1" in the cutting direction?
What is the cutting tool used in the Milling machine? Select one: a. Multipoint cutter b. No cutting tool required c. Grinding wheel d. Single point cutting tool