iven the tabulation below. Compute for the following: (Show your Solutions) a. Latitude and Longitude of each line.  b. Coordinates of each Station. Coordinates of A= 20000 N, 20000 E.  c. Sketch the traverse.

Q: Solve for the missing line details: latitude, departure, distance, and bearing. Lot Side Length (m)…

A: To find. Missing details of the lot. Length Bearing. Latitude Departure

Q: A line of 5 m on the original map is shrunk to 4.6 m. Calculate the shrunk scale if the original…

A: To find out the shrunk scale of the map.

Q: 3. Complete the table and sketch the traverse, assuming no measurements were obtained for line EF.…

A:

Q: Compute the missing side AB. (Type your answer using 2 decimal places, numerical value only, no need…

A: A closed traverse ABCDA is given in which the bearing of all lines are given and distances of line…

Q: Q.3. A levelling table is given below. a) Calculate the elevations of every station given in the…

A:

Q: Complete the missing data. Plot the traverse using an appropriate scale. LINE DISTANCE (meter)…

A:

Q: 1. The diagonal scales are used when measurements are required in units. a) 1 b) 2 c) 3 d) 4 2.…

A: 1. A diagonal scale is used when very small distances are to be accurately measured or when…

Q: 1.13 List the legal requirements for registration as a land surveyor in your state. 1.14 Briefly…

A: There are different eligibility criteria to become a land surveyor. One should need to fulfill all…

Q: Q2) From the figure below,draw a contour map with scale 1:600 and contour interval (2m). The area of…

A: A contour map is a map that shows the topographic features of the ground

Q: In the accompanying tabulations, the length and direction of one side are unknown. LINE AB BC…

A: A closed traverse bearing and length have been given in the tabulated form and it has been asked to…

Q: A line of 5 m on the original map is shrunk to 4.6 m. Calculate the shrunk scale if the original…

A: given- line of 5 m shrunk to 4.6 moriginal scale=1 cm=80 m

Q: Show complete solution. Round off to 2 decimal places. Do not forget the units. Problem No.1 • Given…

A: Given that  Distance between grids = 20m Interval between contour lines = 11m Now we have to plot…

Q: Use the method of compsite areas to calculate the centroidal coordinates of the plane regions shown…

A:

Q: The area bounded by the water line of a reservoir and the contours with a contour interval of 2 m.…

A:

Q: LINE AB BC BEARING N70°55 E DISTANCE (m) 43.73 29.91 S05°30' E S 30°44' W S 86°40 W N 23° 4T W CD DE…

A: given - field notes of closed traverse     to find - missing data

Q: Activity Answer the problem below. As always, show your solution on a clean sheet of bond paper and…

A: The given table is shown below:

Q: The accompanying tabulation gives elevations of points over the area of a 30m x 30m city lot. The…

A:

Q: Complete the missing data. Plot the traverse using an appropriate scale. LINE DISTANCE (meter)…

A:

Q: Determine centroidal coordinates of the volume. 610 mm 813 mm 1220 mm wu 099

A: Consider the figure,

Q: What do the numbers 43°07'30" and 70°52'30" at the southeast corner of this map represent?

A: Maps represent the earth and its different parts in the form of drawing. It is used by engineering…

Q: Find the new coordinates of a square A (10, 0), B (5, 0), C (5, 5), D (10, 5) after it has been (a)…

A: Finding out the new coordinates.

Q: Which of the following scales is used for the same area in a map, the detail of the map will be the…

A: There are two types of scales used on a map. * Large scale - it shows small area with greater…

Q: Q.1) For the area below, find the coordinates of the centroid. 300 mm 400 mm 300 mm 300 mm

A:

Q: Problem 3 A field is in the form of a regular pentagon. It is required to determine the directions…

A:

Q: Calculate the area of the rectangle where the coordinates are given in meters as shown in Figure…

A:

Q: If a map is to have a 1 inch border, what is the largest nominal scale that may be used for a…

A: here i have the  standard scale

Q: The accompanying tabulation gives elevations of points over the area of a 30m x 30m city lot. The…

A: The contour is drawn below

Q: on a map scale 1:25000, the map distance measured between two points X and Y is 32:75 cm. Determine…

A:

Q: b) A map is prèpared using a scale of 1 cm=100 m. What is the RF of the map. If the area of the map…

A:

Q: The cross-section notes shown below are for a Station 32+300 6.25 + 2.25 + 2.20

A:

Q: Plot the open compass traverse tabulated below. Use convenient scale. Line Length (m) Bearing АВ…

A: The handmade drawing of traverse is attached which will give you idea about the plot.

Q: A series of closely-spaced ridges and valleys occurring at regular intervals.Blank 1 Blank 1 Add…

A: This question is related to Contours from Surveying Engineering.

Q: Calculate straight line equation fitting the below data

A:

Q: Given in the accompanying sketch is a cross-section which has been plotted from soundings taken…

A:

Q: A map has a ratio scale of 1:125,000. If on the map you draw a line that is 3” long, how many feet…

A:

Q: 1. INTERPOLATING CONTOURS GRAPHICALLY. The accompanying tabulation gives elevations of points over…

A: Given, Horizontal scale 6 cm =10 m Index contour=880,885,890 and 895

Q: Draw a line scale if the accuracy is 40 for a map with scale 1: 20000 and show 440m, 80m , 720m

A: Given scale = 1:20,000

Q: line from A to B 5 cm on a map with scale 1/2500. This line must be fixed on ground surface if the…

A: Given Scale = 1/2500   Note  Correction due to slope is always negative.

Q: Identify what is wrong with the given data of a three-sided polygon then correct it.

A: for n-sided traverse we haveSum of interior angles=(2n-4)×90°here n=3Sum of interior…

Q: An old map was plotted to a scale of 40 m to 1 cm. Over the years, this map has been shrinking and a…

A:

Q: The lengths and W.C.B. of the sides of a closed traverse ABCDEFA are given below. Prepare a Gale's…

A: Solution I have only solve gale chart part Given table Line Length (ft) W.C.B. AB 6 47012'17"…

Q: Find the missing data on the given table below Line Length Bearing АВ 30 N 16°27' E BC 44 N 55°56' W…

A:

Q: Define integer ambiguity.

A: Ambiguity can be defined as the quality of being open to one or more interpretation. In simple words…

Q: 7. Find area of sector of a circular with radius 36 nches and intercepted arc of length 24inches.…

A: 7. We know angle subtended at centre in radian by an arc of length ,L and radius R is given by, θ=LR…

Q: 6. Cartography symbols depend on a) map scale & map purpose b) represented area e) size of paper 7.…

A: As per company's policies We are supposed to answer only first three questions  Kindly post other…

Q: Use the method of compsite areas to calculate the centroidal coordinates of the plane regions shown…

A:

Q: Convert this graph to absolute and relative Cartesian coordinates. 1.00 0.75 2.00 1.50 1.25 0.50…

A:

Q: Write a computational spreadsheet for calculating areas within closed polygon traverses by the…

A: Computational Spread sheet : First the given data has to be placed in the columns of spreadsheet.…

Area Computations

The area is the mathematical estimation of the inner space occupied by any shape or object and area computation is the evaluation of how much inner space that particular shape or object has utilized. Simple applications include calculating the area of wall for the quantity of paint or plaster to be applied on it, area calculations for construction of a trapezoidal dam and how much material is required, calculating the area of a circle to determine the range or distance of wheels that they are capable of covering due to varied radii and so on.