jo.25 jo.125 jo.2 elle j0.25 relle jo.4 j0.15 jo.1 j1.15 j1.1 1.25/0° 0.85/-45° llle ellete

Q: write the ontpul wavefarm of the given IGBT based single - phase systen! Ib Lo 1eattery Co Vo K2

A:

Q: DIagram: FauLt ち phase 3phase Load Source 2 Line Values: Source Line Imped ances: Eon: 120 L0 Vv ·)…

A:

Q: tind 2L for maximum toansfer and the power value of maximum average power franstersed do 2, in below…

A:

Q: A customer has the following average daily load schedule as follows: 6 AM TO 12 NN= 20KW; 12 NN TO…

A:

Q: IV) For the voltage waveform shown below. If the voltage is in volts and the time is in…

A:

Q: he efficiency on full load, 0.8 lagging p.f. The voltage regulation on full load, 0.8 leadin

A:

Q: Find the instantaneous voltage at 200us of the 10Vpk 1kHz sinusoidal source. v(200us) =[9_5]Volts…

A:

Q: calculate The otal charze by volume C.1S IXI, lyl, lz1502 w/

A:

Q: 0.2 ohm j1.6 ohm 0.8 ohm j3.4 ohm 79ohm j55 ohm a A 24020º 240Z120º 0.2 ohm j1.6 ohm 0.8 ohm j3.4…

A: Given:-

Q: 1. Calcule los voltajes Vg, Vg, Vc, Vce,Vout , la corriente Ic y la ganancia A, del siguiente…

A: The given circuit is a common collector amplifier the required parameters can be calculated by using…

Q: Largest value reached in half cycle is called as O a. Mean Value O b. Instantaneous Value

A: the waveform of the signal takes some time to reach form its one value to its other value.

Q: Date: Day:TM R Daw the Wayne diagram of the F0loming parts @ P(AUB)= PCA)+P(B) PCANB) %3D @ PCAUR…

A:

Q: The effect of temperature rise in an overhead transmission line is: O a. Decreases the SAG and…

A: Choose the correct option The effect of temperature rise in an overhead transmission line?

Q: A load absorbs 20 kVA at a lagging power factor of 0.6. The complex power is: Select one: O a. 20000…

A:

Q: Tipple faCLor. 100mH 52 1:4 470 µF RL Vs Vs = v2 5 sin 314t

A:

Q: Determine the peak and average power delivered to RL. 2:1 115 V rms · 220 Ω elle lelll

A: Given circuit:    Given  circuit  is  a half‐wave rectifier circuitprimary  to secondary  turns  is…

Q: Vdc across the load is 110 V rms/ 1.0k 12.36V 24.73V 110V 55V

A: In this question,  We need to choose the correct options What is average DC voltage?

Q: A load of 20 + j35 Q is connected across a 220 V source. Determine the power factor. Ans: Choos

A:

Q: A. – 78.1 - j41.9. B. 93.4 – j77.8 C. 120.2 - j20.7 D. - 114.1 - j41.9 REE – April 2005 42. The…

A: In this question we need to find a total load current in amperes.

Q: Find the 2) NETRGE and RMS valne 24 12

A: Note: As per the company guidelines we can solve first question please post the second question once…

Q: The variation of the load is considered over a period of month in the monthly load curve.…

A: True The monthly load curve can be obtained from the daily load curves of that month. average values…

Q: Use the information below to answer questions 24 un The voltage across and the current through a…

A:

Q: 2260'A j40 60 20 j20 24,079 ll le

A:

Q: Main Line 10.1 S1 S2 MO.0 10.0 S2 MO.0 MO.0 T40 T37 TON 120 100ml T37 Т38 TON 60 er 100m Т38 Т39 TON…

A: Solution - According to the PLC I/O wiring scheme and PLC code with utilization of ladder diagram,…

Q: 22 32 552 reele 10 20° 1460 32 (b) Determine the Real power, Reactive power consumed by the marked…

A: In this question,  We need to find the real and reactive power in the RX branch.  S= VI*

Q: 6. A generating station has the following daily load cycle: Time (hours) 0-6 6-10 10-12 12-16 16-20…

A: The solution can be achieved as follows. The answer attached with the question is incorrect.

Q: Q1. In the circuit shown below, the source is E = 220 and 50 Hz and the load is 5 ohms and the angle…

A:

Q: The per unit impedance of a generator on a 60 MVA, 20 kV base is j0.09 p.u. The per unit impedance…

A: Given, Zpuold=j0.09 puMVAold=60 MVAMVAnew=100 MVAkVold=20 kVkVnew=20 kV

Q: 21. 62 82 る享55 Ez lo01D E1- 100 LO N Calculate 11, 12 and 13 using Kirchhoff's Laws

A: To solve this question we need to find node voltage.

Q: 1Ω j40 390 V (ms) j260 Isource line |load (+

A: Solution: (a) From the circuit,IL=250∠0°1+j4+39+j26IL=250∠0°40+j30I¯L=5∠-36.87° (b)…

Q: he MCB used in distribution board is O a. frequency multiplier O b. waveform correcting device O c.…

A: The explanation is as follows.

Q: Two alternators running in parallel supply the following loads: 1500 kW at 0.9 lagging pf…

A:

Q: Question # 1 Determine the power and the rms value of: (a) g(t) = C. cos (wot + 0) (b) g(t) = C1 cos…

A: Sinusoids of different frequency will be always ORTHOGONAL. C. DC signal and exponentials are always…

Q: Write the equivalent voltages in the table below: Peak voltage Average Voltage 170 V 108.29 V 339.36…

A:

Q: Two 800kW alternators A and B operating in parallel. The speed regulation of A is 100% to 103% from…

A: Solve the problem

Q: Problem 7.4 Obtain the power factor for each of the circuits shown. Specify each power factor as…

A: In this question we will find power factor..

Q: 4. 12430° + 825° - 62-20° 5. j9 + j?1 +j

A: Solution of question (4): It is asked to solve 12<30°+8<25°-6<-20°.

Q: Quesbon- ob: Ihe nelwerk Shown is operating the Steady Stale with sinusoidal vO Hage sourses. If V,…

A:

Q: Given: E = (80 – j20) volts and I = (5 + j2) Amperes Determine the: a. Apparent Power b. Reactive…

A:

Q: 0.3: An 10 KV, 1000 KVA star-connected alternator has a resistance of (2.5) 2 The following data are…

A: Given, 10 KV, 100KVA star connected alternator. Ra = 0.5 Ω Field current 48 60 132 168 216…

Q: 3. j0.15 j0.50 j0.20 j0.30

A: The bus admittance matrix  of a 3-bus system is given by: Where, Y11, Y22,Y33 are the self…

Q: please solve all question 1.1) Calculate Vpk and Vpk-pk for 6 VRMS 1.2)Calculate Vpk and VRMS for…

A:

Q: Determine the rms value of the ware form W+XV) 1 2 Į 2 3 4 5 t(s)

A: The given signal is periodic with period 4 sec. The formula and calculation is shown in the next…

Q: Calculate the power consumed by the 102 resistor using nodal analysis. jsn 1002 20/30 v 2002 -j150…

A:

Q: The output of a station with two alternators in parallel is 40MW at 0.75 power factor lagging. One…

A:

Q: A generating station has a connected load of 40 MW and a maximum demand of 20 MW : the units…

A: given maximum demand = 20 MW Connected load of 40 MW  No. of units generated= 60×106 kwh…

Q: 02 2400 ? 2000 Determine: 1. The power factor angle of the load. 2. The power factor of the load. 3.…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Part A The following graph shows the voltage and current through a single circuit element. What is…

A: Time period is the time for which waveform repeats. Power dissipated =(Vm×Im×cos(angle between…

Q: Vs j1 N Ω 50 V1 20 -j1 n 20 d the real part of the voltage. +

A: Given:V1=4∠0° V

Q: iz 110 iz 31 V (+ 1

A: Using mesh analysis we find the value of the power delivered by the voltage source. Please find the…