lease need correct answer and fast      Q5) Draw the Bode plot of Band Pass Filter.

Q: 3- Band pass filter has a center frequency of 50 KHZ and Q of 20, what are the cutoff frequency ?

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: A parallel resonance circuit has a resistance of 4 kohms and half-power frequencies of 16.6 kHz and…

A:

Q: A coil of resistance 20 2 and inductance of 300 mH is connected in parallel with a capacitance of…

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: The roll-off of a lowpass Butterworth filter is 12 decibels per octave in the stopband. What is the…

A:

Q: What is the cut off frequency of RC low pass filter of order 1

A:

Q: Q3/ Determine the centre frequency, maximum gain, bandwidth and type filter for the circuiting…

A: Given circuit, Where, R1=1 KΩ=1×103 ΩC1=0.047 μF=0.047×10-6 FR2=1 KΩ=1×103 ΩC2=0.022 μF=0.022×10-6…

Q: Determine the following: Zi Avs = Vo/Vs fLG, fLC, and fLS low-cutoff frequency

A:

Q: a.) From the plot, what is the center frequency of the band pass filter? _______________________…

A:

Q: (a) Explain on the AM Single Sideband Full Carrier (SSBFC) and compare to Double Side Band Full…

A: In this question,   We need to explain the carrier power and sideband power of the Single Sideband…

Q: band

A: In this question, we have to define pass band, attenuation band and cut off frequency used in…

Q: Bode magnitude plot of a phase system G(3)H(8) has8 been given as the following figure 500 w (log…

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: For the parallel RLC band-pass filter in Figure 10.12, if R = 1 kN, C = 220 nF and L = 100 µH,…

A: Given: A parallel RLC band pass filter in which R=1KΩC=220nFL=100μH According to question:…

Q: 17. Determine the critical frequencies associated with the low-frequency response of the FET am-…

A: The largest amplitude of frequency above which waves reach the ionosphere and below which waves are…

Q: io R = 1.0 kQ 5 cos(2n150000t) V + VR - + + V. L = 1 mH

A:

Q: Design a wide band pass filter with f = 500 Hz and f = 2 kHz, and a pass band gain = 5 for both…

A:

Q: Q1/ Sketch the frequency spectrum at each point (a, b and c) b X(t) L.P.F Sampler Where X(t) = f(x)…

A: We will find out frequency domain at each point in given circuit, we will draw the frequency domain…

Q: Use a qualitative analysis to identify the filter type for the circuit shown in Figure-1 below.…

A:

Q: ii. If the bode plot diagram is experimentally determined, one can find: (a) Transfer function of…

A: The answer is option C

Q: 1.3 We have a band pass signal in the frequency band, 450 Hz to 460 Hz. The carrier frequency is 455…

A: The band pass signal is given in question: where, fH=460 HzfL=450 Hzfc=455 HzBW=fH-fLBW=460-450BW=10…

Q: Q3/ Determine the centre frequency, maximum gain, bandwidth and type filter for the circuiting…

A:

Q: Q2/ In the Low Pass Filter circuit ,if the value of R1=15kn and R2=150kn then the value of Dcgain

A: In this question , we have to find out DC gain of low pasa filter.

Q: What are magnitude and frequency scale factor will transform the prototype high pass filter into a…

A: Write the value of the cut-off frequency and the capacitor value for the prototype high-pass filter.

Q: Determine the region where the circuit works and calculate the middle band voltage gain. (Av=?)

A:

Q: Complete the following table. Specify the type of filter, i.e. high pass (HPF), low pass (LPF), band…

A: Given :   In the given question they have mentioned the electrical circuit which have the energy…

Q: fo0o HCs) =

A:

Q: Q5 A unity feedback control system has open loop transfer function: 2 G(s) = s(1+ 0.5s)(1+ 0.05s)…

A:

Q: Given the circuit below, find the minimum and maximum output voltage after the filter capacitor,…

A: The circuit can be redrawn as Time constant of the circuit will beζ=1.2k×10mζ=12secTime period of…

Q: The booster; If β =(Beta)=200, VBE=0.6V, a) Find the middle band gain. b) Determine the low cut-off…

A: Amplifiers are used to generate the amplified output signal corresponding to the input signal, the…

Q: A parallel RLC resonant ckt R=8kOhm, L=40mH and C=0.25 µF Determine quality factor?

A: Inductor is passive element that store energy in magnetic field. Capacitor is an electrical…

Q: draw bode plot Frequency (1k,10k,20k,40k, 50k,60k,70k,80k,90k,100k)

A:

Q: For the circuit shown in figure determine the capacitive reactance at resonance. 50 Vs

A: From the given circuit diagram, the value of the inductive reactance can be written as XL=25

Q: list the forced commutation and explain the principle work of the resonant pulse

A: Introduction: Commutation is the procedure for shutting off a thyristor. The thyristor's working…

Q: he bandwidth of narrow band FM will be equal to multiplied by 2. ) Kf O carrier frequency O baseband…

A:

Q: B. 1 . В. s] Given a filter H(w), explain how filter or high-pass filter.

A: We are given a filter with transfer function H(w) We can check whether the system is low pass filter…

Q: If the ratio between the dimensions of a circular-cylindrical resonator is 2a>h, what is the…

A: Transverse mode is the way in which any wave travels in a plane perpendicular to the propagation of…

Q: For the circuit shown in figure beside, Derive an expression for @o with respect to the circuit…

A: Resonant frequency is the frequency at which, the network is pure resistive in nature. For a series…

Q: Calculate Bandwidth (BW), Upper cutoff frequency (fu) and Lower cutoff frequency (fL) of a bandpass…

A:

Q: If the Q factor of a BPF filter is 25 bandwidth is 100 kHz Narrow 50 kHz Wide

A: The Quality factor is a parameter that determines the sharpness of the resonance of a filter.…

Q: Q3/ Determine the centre frequency, maximum gain, bandwidth and type filter for the circuiting…

A: Given circuit, Where, R1=1 KΩ=1×103 ΩC1=0.047 μF=0.047×10-6 FR2=1 KΩ=1×103 ΩC2=0.022 μF=0.022×10-6…

Q: Im + Re -100 -1 Figure 1: We want to sketch the bode plot for this filter! 1) Rewrite H(s) in the…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: 5-20. Determine the net receiver gain for an AM receiver with an RF input signal power of -87 dBm…

A: The solution is given below

Q: 18. Identify each band-pass filter configuration in

A: Given:-

Q: Sketch the output voltage Vo versus frequency for the low-pass R-C filter in the figure below and…

A:

Q: Q3/ Determine the centre frequency, maximum gain, bandwidth and type filter for the circuiting…

A: Given data High pass frequency: The value of the capacitor is 0.047μF The value of the resistance is…

Q: 5-4. For an AM commercial broadcast-band receiver with an input filter Q-factor of 85, determine the…

A: The solution is given below

Q: please need correct answer and fast   Q4) Draw the Bode plot of Band Stop Filter.

A: Given: Brief description: Bode plot is one of the stability criteria of the control system. Bode…

Q: Sketch the straight line Bode plot (gain & phase) for the following system & name the type of the…

A: On simplifying the given transfer function as shown below: