Locate the centroid coordinates of the shaded area shown in the figure below Y Half Circle R=12 cm, R=6 cm 24 cm 10cm 40 cm 18 cm

Q: Find the flow rate

A: Given: Width of trapezoidal channel, b=3 m Channel slope, S=1/5000 Side slope, m=2 (2H:1V)…

Q: 1. A proposed road bend along a highway construction project is to be laid out such that it will be…

A: Stationing of V = 12+340

Q: how high (ft) is the flow above the crest of a 39 degree v-notch weir when the discharge is 19,514…

A:

Q: Practice Problems G5 G61. A spring has a natural length of 14 ft. If a force of 500 lbs is required…

A: NOTE- As per BartleBy Guidelines , we can only solve first question among two , So upload other…

Q: area shown in the figure below Y Half Circle R=12 cm, R=6 cm 24 cm 10cm 40 cm 18 cm

A:

Q: A consolidated undrained test on a saturated sand yielded the following results. 03 = 12 Ib/in?…

A:

Q: Determine the value of constant of integration C2 (in lb-ft^2). b.) Determine the value of constant…

A:

Q: An underpass crossing a reinforced concrete bridge along the Shaw Blvd. has a downward grade of - 4%…

A:

Q: 5. Find the centroidal distances with respect to x and y axes. NOTE: the figure show is a shaded…

A: Figure is as shown

Q: Problem I. A steel beam cross section is assembled as shown by bolting the channel, C200 x 27.9,…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: The degree of a circular curve of radius 1719 m is approximately equal to 1° C 10° 100° O None of…

A: 1 degree

Q: The cross-section notes shown below are for a ground excavation for a 12m wide roadway. STA 20+8200…

A:

Q: The gross weight of a sixwheel truck and its load is 42000 lbs. The front axle A carries 7000 lbs.,…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: A restrained beam having a span of 5 m is loaded with a distributed load that varies from 12kN/m on…

A:

Q: Solve the resultant and magnitude

A:

Q: Moment-Area Method A simply supported beam is loaded with a concentrated load and a uniformly…

A:

Q: A cantilever beam, 53 mm wide by 153 mm high and 6 m long, carries a load that varies uniformly from…

A: Given:  Cantilever beam with uniformly varying load Dimensions of beam  To find:  Magnitude and…

Q: 2. Given the data of an irregular boundary, find the area using trapezoidal and Simpson's one- third…

A:

Q: A plane has a takeoff speed of 88.3 m/s and requires 1365 m to reach that speed. Determine the…

A:

Q: :A stone is projected vertically upward from the top of a 120m-high tower at a velocity of 36 m/s.…

A:

Q: What is the soil type based on the USCS classification cent paing Sieve#4, 52% Per nt pass g…

A: Step1:Look at the % passing through sieve no 200=10<50%⇒COARSE GRAINED SOIL

Q: 2. Draw the shear and moment diagram of the loaded beam shown in the figure. Determine the Vmax and…

A:

Q: A vertical symmetrical sag curve has a descending grade of - 4.2% and an ascending grade of +3%…

A: Solution-The Given values are as follows g1=4.2%  g2=+3% The  PVI station 10+020  The Elevation=100m…

Q: Determine the specific gravity of cor retical specific gravity of 2.4. The bitumen 1.00.

A:

Q: 3. A PAL on one of its scheduled trip is to fly from Manila (14°36'N, 131°45'E) to Sydney, Australia…

A: 1 degree = 111km. N2 - N1 = (14°36' - 10°16' )*111              = 4°20' * 111             =…

Q: Find importance on the fire protection and prevention regulations and in what manner can you assure…

A: Workplace fire safety is essential in order to avoid or minimize the damage caused by fire. Fire…

Q: A beam has pin-ended support at A and roller support at B as shown in Figure 3 (a) Construct the…

A:

Q: YA 45 CM 20 CM 100 CM

A: This question is from basic of slod mechanics .   Here a fig is given and radius of gyration is…

Q: A storm drain with a radius of 1.8 m flows half full. Find the hydraulic radius in meters? Use…

A: Given data  Radius of drain 1.8 meter Strom drain  Flows half full

Q: A soil sample is collected under the ground water level, what is the void ratio if given the…

A: From Given Data :   Since the soil sample is collected under the ground water level , degree of…

Q: 2. There is a Vertical Curve with a length of 300 feet, a gl of -3.2%, a g2 of 1.8%, a PVI at…

A: The grade of back tangent, g1=-3.2%The grade of forward tangent, g2=+1.8%The elevation of PVI…

Q: Check the bolted section of the given gusset plate connection assuming that the connection is done…

A:

Q: For the beams below, draw the shear and bending moment diagrams using both method of sections and…

A:

Q: of zero shear. Also specify the degree of each curve. What is the maximum shear and maximum bending…

A:

Q: A spiral column is to be reinforced with 16 mm diameter vertical bars. What would be the ultimate…

A:

Q: The length of a summit vertical curve is 200 m. Tangent grades for the vertical curves are +3% and…

A:

Q: A WT265 x 37 structural steel tee shape beam is loaded and supported as shown. Determine the…

A: As per bartleby guidelines, only 1st 3 parts among multiple parts questions need to be solved.…

Q: PROBLEM 1 The City of San Fernando is considering building a new parking lot. The land will cost…

A: The given data is as follows: Cost of land=250,000 pesosConstruction cost=1,500.00 pesosAnnual…

Q: A triangular channel (n=0.016), is to carry water at a flow rate of 222 liters/sec. The slope of the…

A:

Q: Q1/ Find the polar moment of inertia of the shaded area. у-ахis 100 mm 1 y = 100 -30 х-ахis -150 mm…

A: Moment of inertia : Moment of Inertia. The second of inertia approximately any factor or axis is the…

Q: Q3 ) Determine the tension developed in cables AB, AC, and AD required for equilibrium of the 100 kg…

A:

Q: A restrained beam having a span of 5 m is loaded with a distributed load that varies from 12kN/m on…

A: Question is solved using double integration method. As each method is lengthy, so please post…

Q: A continuous strip footing is to be located concentrically under a 300 mm wall that delivers service…

A:

Q: In the case of a rectangular channel 3 m wide and 1 m  deep, the value of Darcy-Weisbach's constant…

A:

Q: 20 k 3 k/ft 1.5 k/ft A C 15 ft 15 ft 20 ft E = 29,000 ksi I = 1,650 in.4

A:

Q: Question 4 A 1030 kg car rounds a curve of radius 85 m banked at an angle of 5 degrees. If the car…

A:

Q: A 67-kg crate (as shown in the figure) moves down along an incline with an initial speed of 7 meters…

A:

Q: A drainage canal in the shape of trapezoidal with a bottom width of 2.5 m and side slopes of 1…

A: Given: The bottom width is 2.5 m. The side slope is 1H:1.5V.  The depth of water is 3 m.

Q: A stone is thrown upward at an angle of 20° and with an initial velocity of 15 , from the top of a…

A:

Q: For a V-shaped concrete lined channel with total included angle of 80°, and a depth of 3m if the…

A:

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.