Mention the L1 and L2 frequency bands for GPS

Q: 5. Simplify F(A,B,C,D) = E m (0,2,4, 5, 7, 8, 10, 13, 15) and don't care = d (1, 9) in SOP using…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: A communications satellite is used to link a number of mobile ground stations which transmit and…

A: The solution is given below

Q: 16.7 miles is the maximum link distance to guarantee LOS, so the height of the towers must be: * 30…

A:

Q: Find the divergence and curl of A x?у ах + (х — у)az

A: Brief description : In the above given question they have mentioned a vector field called A. For the…

Q: If a carrier c(t) = 10 cos (2π 2*106t) is modulated by a single tone message signal m(t) = 8 cos (2π…

A:

Q: If the Far end cross talk rating of a cable is 24.8 dB at a given frequency and the attenuation of…

A: Consider the following diagram,

Q: signal of frequency, fm with the modulation index of 1.5. Sketch the frequency spectrum of the FM…

A:

Q: Q1:- What are the two components of a signal when the signal is represent on a constellation…

A:

Q: With a given Gaussian white noise with μ = 0 and σ = 3.47,

A:

Q: In case of an acoustic wave (sound) as information signal the transmission channel should be the…

A: Acoustic wave (sound) can be transmitted via air as a transmission channel. It cannot be transmitted…

Q: Frequency deviation for an FM signal is dependent on Select one: O a. frequency of the carrier O b.…

A: It depends upon frequency of carrier wave.

Q: . List the three parameters of a high-frequency carrier that may be varied by a low-frequency…

A: Since, it is only asked to lost the parameters and no explanation is asked, thus solving the…

Q: In a survey conducted by a transmission project engineer of one of the renowned communication…

A: Given the received (r) vector as [010111] and HT = 111011110100010001 . We need to determine the…

Q: The total Power content of an AM signal is 1000W. Determine the power beir transmitted at carrier…

A:

Q: . Motor & appliances

A:

Q: a 10KHZ sinusoidal message signal modulates the amplitude of 1000KHZ carrier signal, what…

A: When a carrier is modulated by message signal using Am modulation techniques then upper and lower…

Q: signal on a loss-less transmission line (a)1/√LC (b) √LC

A: A transmission line has four parameters such as resistance, inductance, capacitance and conductance.…

Q: (6) Without modulation, the carrier power in an AM transmitter is 5 KW. This carrier is modulated by…

A: AM transmitter: The transmitter is a device that transmitter or sends the radio wave that wave has…

Q: Question 10 In case of the DSB-SC communication The carrier alone is transmitted The carrier and one…

A: Correct option is none of the other answers are true DCB-SC is defined as Double sideband suppressed…

Q: In the FM system, the audio frequency is 1 KHz and the audio voltage is 2v. The frequency deviation…

A:

Q: 1- Describe the different types of analog and digital modulation. 2- how radio frequency waves…

A: modulation method classification modulation is the process of converting data into electrical signal…

Q: Identify and describe components of radio frequency communications focusing on units of power and…

A: Radio frequency communication Radio frequency mathematics signal/interference/noise ratios budgets

Q: Solve for Fc = cut off frequency

A:

Q: I'm really interested in learning the names of the three basic frequency bands that are used in…

A: Frequency Band: The lowest section of the electromagnetic spectrum, known as radio frequency (RF),…

Q: A 1-MHz carrier with an amplitude of 1 volt peak is modulated by a 1-kHz signal with m=0.5. Sketch…

A:

Q: Can we used information signal has frequency 500 Hz? why? at AM-SSB

A: The solution is given below

Q: Given the data stream 1110010100, sketch the transmitted sequence of pulses for each of the…

A:

Q: For a given Karnaugh-map, the SOP form is:

A:

Q: B) For AM signal if the message amplitude is IV and frequency is 10kHz, carrier frequency is 450…

A:

Q: 3-24 A recorded data signal of one hour duration has an esti- mated bandwidth of 50 kHz. It is to be…

A: Given that Time duration =1hrs=60minestimate bandwidth=50kHzavailable bandwidth=750kHz

Q: In which/which of the following units is the modulation process performed? O Set ONone of them • Of…

A: To transmit low frequency signal over a longer distance we use modulation since low frequency signal…

Q: The maximum shift in frequency is 3 kHz and the minimum and maximum deviation in frequency of the…

A:

Q: A BTS sending information at 1800 MHz with a 10 Watt (W) output power will only cover half the area…

A: Given that due to the frequency, a BTS broadcasting data at 1800 MHz with a 10 Watt (W) output power…

Q: In the FM system, the audio frequency is 1 KHz and the audio voltage is 2v. The frequency deviation…

A:

Q: What are two of the most common GPS frequency bands? Give their correct values

A: The word GPS stands for Global Positioning System. It is a satellite based navigation and…

Q: For a carrier signal of 1 MHz and modulating signal of 2 kHz what is the frequency range ?occupied…

A: The solution can be achieved as follows.

Q: Which statement about satellites is correct? (multiple choice questions) A. Passive satellites…

A: Geostationary satellite moves with earth rotation. They are stationary with respect to earth. Form…

Q: olve a and b please. a.How FM signal is demodulated using band pass limiter, explain with the help…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: What will be the ROC of the signal x(n)=Ō(n-k)+ d(n+k)? Entire Z-plane Entire Z-plane except z=0…

A: We need to select correct option for ROC .

Q: B) Reduce the following function using Tabular (Quine_McCluskey) method? f(A, B, C, D, E) =…

A: Hi , Hope you are doing well I can answer only first question as per guidelines

Q: (t) , modulation index, power of FM signal if FM si 107 Ogin3000t) nd the di

A:

Q: Question 7 In case of the classical AM communication     The carrier alone is transmitted…

A: Given :    Here in this question they are discussing about the amplitude modulation.     We will…

Q: a 4KHZ sinusoidal message signal modulates a 800KHZ sinusoidal carrier signal, what quencies are…

A:

Q: List down the similarities and differences of RADAR and LASER in the Venn Diagram in terms of…

A: List down the similarities and differences of RADAR and LASER in the Venn Diagram in terms of…

Q: Solve for Wireless Communication Student id= 171731…

A:

Q: B- Explain Zeros and Poles for frequency response.

A: Need to explain about zeros and poles for frequency response

Q: Given a multiplexer, assume i3 = 1, i2 = 1, i1 = 0, i0 = 0. If s1 = 1 and s0 = 0, then y = ?

A: In this question, If a multiplexer,4×1 assume i3 = 1, i2 = 1, i1 = 0, i0 = 0. If s1 = 1 and s0 = 0,…

Uplink and Downlink Segment

The uplink and the downlink are the terminologies that are used in the satellite communications. The data when sent from the ground to the satellite is called the uplink and data when sent from satellite to ground is called downlink. The uplink and the downlink process goes in parallel and this is also a two way communication.