METHANE IS OXIDIZED WITH AIR TO PRODUCE FORMALDEHYDE IN A CONTINUOUS WAY, IN A PARALLEL REACTION CO2 IS OBTAINED WHEN THE PRESSURE IS LOW ENOUGH FOR THE GAS TO BE CONSIDERED IDEAL GAS, METHANE ENTERS THE REACTOR AT 25C WHILE THE AIR AT 100C. CALCULATE THE AMOUNT OF HEAT TO GET THE PRODUCTS AT 25C

Q: A hydraulic power plant as shown in figure takes in 25 m³/s of water through its turbine and…

A:

Q: 60 of work is done on the system during a process. Consider the device used is an absorber unit…

A:

Q: Temperature difference is not the driving force for heat transfer. O yes No O O

A: when heat takes region between two objects is called conduction. According to the laws of…

Q: " The impeller of a centrifugal water pump runs at a speed of 800 rpm, it has blades widths; b₁-5cm,…

A:

Q: 5. What mass in grams of CO2 (FW 44.01) is evolved in the complete decomposition of a 2.700g sample…

A: Given data: Molecular weight of CO2=44.01 gWeight of sample of MgCO3=2.7 gPercentage of sample of…

Q: 60% NaOH is to be concentrated in a triple effect evaporator to 15% NaOH. If equal amount of water…

A: Given  60%NaOH is concentrated in a triple effect evaporator to 15 %NaOH And equal amount of water…

Q: a. Calculate the total molar amount and mole fractions of methanol, air (N2+O2) and water fed to the…

A: Write the reactions as follows: CH3OH +12O2  → CH2O + H2O       .......1CH2O + 12O2  →  HCOOH…

Q: At 27 °C, 500 cc of H2, measured under a pressure 400 torr, and 1000 cc of N2, measured under a…

A:

Q: Radiation heat transfer needs a media to occur where as conduction and convection is not. O yes No O

A: Radiation are electromagnetic waves that travel without any medium, Rest conduction and convection…

Q: A plant discharges 4,000 gal/min of treated wastewater that contains 0.25 mg/L of PCB,…

A:

Q: Prove that in the 1st order desorption kinetics in TPD, Tmax is independent of surface coverage.

A: we know that,  T(t) = To + βt                where, β = heating rate, T = Temperature and t = time…

Q: In a drying operation, 1000 kg/h of a solid containing 20% by mass of water is to be dried to…

A: There will be no solid in the water stream. The solid balance across the system will give the…

Q: In the manufacturing of chlorine, HCL and O2 are reacted to form C12 and H2O. Air is fed with 35%…

A: Given data: Percent of air=35%Conversion of HCl=75%Basis=100 Mole HCl

Q: A Carnot cycle uses 1 mole of an ideal gas as the working substance and operates from a most…

A: Net Work Done = Work done in isothermally step + Work done from adiabatically step   ----(1)  At…

Q: Use the Peng-Robinson equation of state to determine the volume of 3 moles of ethane gas at 298 K…

A:

Q: Q3:An air compressor takes in air at 100 kPa, 300°C and delivers it at 1 MPa, 600 K to a constant-…

A:

Q: Present any three real gas correlations / equations of state and a short description and discussion…

A: Introduction: Real gases are defined as non-ideal gases in which their molecules occupy space and…

Q: Derive the expression for calculating the isothermal compressibility of a certain gas that obeys the…

A: For detailed solution please see the attached files.

Q: The thermal conductivity of a solid is larger than that of a liquid. O yes no O O

A: In a solid state, the intermolecular areas are very shut to every different and have extra kinetic…

Q: A finite-difference equation is used for each nodal point at which the temperature is unknown. O Yes…

A: We have to answer about the finite difference equation for solving the temperature at the nodes and…

Q: 4-A rigid tank is divided into two compartments by a partition. One compartment contains 3 kmol of…

A:

Q: 3. Nitrobenzene is an intermediate used to produce phenylamine or aniline. Its application extends…

A:

Q: If the overhead stream contains 8.5 mol % water at a pressure of 34.7 psia (2.36 bars), calculate…

A: Given, mole percent of water=8.5% pressure=34.7 psia(2.36 bar) Water partial pressure…

Q: Why the reactor-exchanger is used for the reaction. Clearly explain the reason.

A: Given PFD of isothermal dehydrogenation of ethylbenzene , pioneered by BASF To answer Why is the…

Q: 1. Air is compressed from an initial state of 1 bar and 25 °C to a final state of 5 bar and 25 °C in…

A: Given:  Reversible isothermal compression that mean temperature is constant,  △U AND △H is zero…

Q: Hex-1-ene gas, C6H12, burns in oxygen to produce carbon dioxide and water vapour. a. Write an…

A:

Q: A nozzle receives 36 kg/s of air at a speed of 142 m/s and with an enthalpy of 1060.00 kJ/kg. Air…

A:

Q: Q. A house wall may be approximated as two 1.2 cm layers of fiber insulating board, an 8.0 cm layer…

A: Given Details: Inner Temperature , Ti=150C Outer Temperature, To=450C Wall dimensions =3 m high , 5…

Q: Use this graph to answer the following questions: What is the half life of the reaction? Round your…

A:

Q: width and 5 m A horizontal square wooden rod, 2 m long. 0.2 m head width is hung and fixed at the…

A:

Q: HW3: A gas flows a horizontal pipe when the cross-sectional area has changed from 40 cm² to 20 cm²…

A: Given, R = 292 J/kg.K and the process is isothermal.

Q: 4. A vessel containing 1.000 kg of water at 25.00 °C is heated until it boils. How much heat is…

A: GivenMass of water heated =1 kg, or 1000 gInitial temperature of water=25oC , or 298KFinal…

Q: A mixture containing only BaSO4 (FW 233.38) and CaSO4 (FW 136.14) contains one half as much Ba2+ as…

A: Given that formula weight of BaSO4  =233.38formula weight of CaSO4  =136.14

Q: Q2: Air flows out of a nozzle straight up 30 m. What is nozzle velocity exit?

A: Given: (Z2 -Z1)  = 30 m  From first law of thermodynamics we get,  where (nozzle velocity exit) V1…

Q: Q3 At present 80% of reactant A is converted into product by a second-order reaction a single mixed…

A: Given data: Conversion achieved in the single CSTR = 80 % Conversion achieved in 4 CSTRs connected…

Q: A chemical engineer is studying the rate of this reaction. He fills a reaction vessel with and…

A: Dear User! As per our authoring guidelines, we have answered the first of the multiple questions…

Q: Steam at 8200 kPa, and 400 deg Centers a turbine and leaves at 10 kPa. What is the entropy of the…

A: Given : At inlet :              Pressure = 8200 kPa              Temperature = 400 0C At exit :…

Q: Calculate the gage pressure in a 4 m³ vessel occupied by 16 kg of N₂O (behaving as ideal gas) at a…

A: Molecular weight of N2O = 44 g/mol  Given Mass  = 16 Kg = 16000 g  Mole of N2O = Masss/ Molecular…

Q: Q2: Air flows out of a nozzle straight up 30 m. What is nozzle ?velocity exit

A:

Q: The work produced by a constant temperature, prpessure-volume thermodynamic process can be computed…

A:

Q: Q2/ Moist air at I atm, a dry-bulb temperature of 105 "F, and a wet-bulb temperature of 75 °F is…

A: Note: We are supposed to solve only 3 subparts of a question as per our guideline. please send other…

Q: A steam hammer weighing 3000 lbs and falling 29 inches is used to drive wood piles. Compute the…

A: Given data: Weight of steam hammer = 3000 lbs Penetration of pile per hammer blow = 0.5 in Height of…

Q: Calculate the amount of theoretical air required for complete of 2 kg coke assuming 100% carbon…

A:

Q: The table below shows the flue gas composition (in gmol) from the combustion of fuel oil: N₂ CO2 H₂O…

A:

Q: Nitric acid, which is among the top 15 chemicals produced in the United States, was first prepared…

A:

Q: On a hot summer day at Tallahassee, FL, the temperature of the outside air is 35°C and the pressure…

A: The independent mass balances are obtained from the number of components in the system. The…

Q: 1. What are the main components of closed conduits flow networks?

A: Introduction: Fluid flow: Fluid flow is usually the movement of fluid this is subjected to distinct…

Q: A reaction turbine has guide vanes at an angle of 30° and the runner blades make an angle of 80°…

A:

Q: The minimum air by weight required for the complete combustion of hydrogen which presence in 1 kg…

A: Given that- Mass of fuel, M= 1 kg Composition of fuel- C= 75% = 0.75 kg =750 g H2= 21% = 0.21 kg=…

Q: 1. A gaseous fuel mixture has a molal analysis: H₂ = 14% CH4 = 3% CO = 27% O2 = 0.6% CO2 = 4.5% N₂ =…

A: Given, Molal composition