Models are used in many different contexts nowadays. Is it possible to arrange the models?

Q: A bearing wall carries a total unfactored load of 200 kN/m. It is to be supported on a 400 mm deep…

A:

Q: A 200 mm 50 mm Fixed to ground B 200 mm 2000 KN X A block of rubber 50 mm thick is sandwiched…

A: Data given dimension of steel plate = (200×200) mm                                         =…

Q: A prismatic bar AE of negligible weight is hinged to a vertical wall at A and supported by a strut…

A:

Q: The steel plate below i attached to a strong gusset plate as shown The plate grade of the steel is…

A:

Q: wo sections, A and B, are 0.5 km apart along a 0.05 m diameter rough concrete pipe. A is 115 m…

A: Given, Pipe length, L = 0.5 km or 500 m  Diameter, D = 0.05 m  Elevation difference, ZA - ZB = 115 m…

Q: 7. Which one of the following is a conservative force? a) rolling resistance b) friction c) air…

A: 7-f) spring force is a conservative forceA conservative force is a force that can be described by a…

Q: Q-18b, For laminar flow at a point A, 2 m from the leading edge, boundary layer thickness is 3mm;…

A: Given Data  Laminar flow over flate plate  Boundary layer thickness at 2m from leading edge = 3mm…

Q: Open Channel Flow - Uniform Flow A penstock of 1 m diameter and 5 km length is used to supply water…

A: Given data- Diameter of penstock d=1 m, Length L=5 km=5000 m. Nozzle diameter dn=15 cm=0.15 m, Head…

Q: The actual velocity for flow in a soil deposit of porosity 0.33 is 1.39 mm/sec. The coefficient of…

A: Given- Porosity n=0.33, Actual velocity V=1.39 mm/s, K=4.58 cm/s, It is needed to find the…

Q: Question 1: 10M Stirrups 350mm 2 - 20M 2-25M+1-20M 850mm F The figure above shows the cross section…

A: As per Bartleby's guidelines we are supposed to answer only first three questions. Kindly repost…

Q: Problem 1: Inputs: ● ● z = 2 m F = {-6i+2j+ 3 k} N Mo = { 5.6 i 13.8 j + 20.4 k} N-m a) Compute y…

A: Given: Z = 2m F = (-6i +2j +3k) Mo = (5.6i-13.8j+20.4k) Required : x, y, check using Mz and d

Q: 3 A 3m wide rectangular channel carries a flow of 6m³/s. The depth of flow at a section P is 0.5 m.…

A:

Q: A student began an experiment of 5 day 20°C BOD on Monday. Since the 5th day fell on Saturday. The…

A: Given data- Experiment starts on 5 day 20oC Monday, 7 days BOD=150 mg/L, BOD rate constant…

Q: Activity A B с D E F G H Table Q3: Data for Project XCX Duration (Days) 3 4 2 5 1 2 4 3 Predecessor…

A: For the above given activities,  Critical path is    =>   A-B-D-G-H  Total duration needed is 19…

Q: the question is about a flat bar, not a T Beam

A: Given: Plate: PL 12.7mm X 165mm The cross-sectional area, Ag = 2095.5mm2 CSA-G40-260W steel grade:…

Q: A beam ABCD has equal over hangs to both the sides and is loaded as shown. Find the slopes and…

A: Given:- To find:- Slope and deflection at the free end, supports and mid span Concept:- Double…

Q: Consider the truss shown below. Determine the forces in members GC and GF using the method of…

A: Given, To determine, Force in GC and GF

Q: A Triangular masonry (specific gravity 2.5) dam with with height 50 m and base 30 m retains water…

A: Given- Specific gravity G=2.5 Height h=50 m Base b=30 m FOS=?

Q: Question # 01 A w=2 S mmmm 4 l B 8 8 4 Draw shear and bending moment diagrams for the following…

A: Given: Required : Shear force and bending moment diagram

Q: A first-stage flocculator uses a six-bladed Rusthon turbine 2 m in diameter rotating at 25 rev/min.…

A: Given, Diameter of turbine, D = 2 m Rotation speed = 25 rev/min  Density of water, ρ = 999.7 kg/m3

Q: A fully penetrating pumping well extracts groundwater from a confined aquifer with a pumping rate of…

A: Since the second question is incomplete the first question is solved. Given: Drawdown = 10 cm = 0.1…

Q: Consider a vertical trench of saturated undrained clay with p = 0, y = 16 kN/m3, and Cu = 15 kPa as…

A: This is a question on stability of soil slopes. The weight of soil will cause a moment about point O…

Q: The ultimate BOD of the waste water whose 5 day BOD (BOD), and rate constant (base e) are…

A: Given 5 day BOD=150 mg/L rate constant k=0.23/day Ultimate BOD=?

Q: II. Answer the following: 1. What is the value of the resistance factor for gross area in LRFD? 2.…

A: As per Bartleby's guidelines we are supposed to answer only first three questions. Kindly repost…

Q: Solve the shear and moment diagram using the equation method

A: Given Data  Draw shear force and bending moment diagram using equation method.

Q: Answer the following questions. 1- If the bearing angle of the line AB is S 50°20'E, what is the…

A:

Q: 5.6 A cable is subjected to the loading shown in Figure P6.6. Determine the total length of the…

A: Given Data  Find the total length of the cable and tension in each cable and support reaction.

Q: Draw the 3 Principal Views of the object (units in cm) 5.0 3.0 1.5 R=1.0 1.5 ↓ 1.0 3.0 -2.5 2.0

A: I have draw  Top view.  Front view

Q: A 2 % sewage sample (in distilled water) was incubated for 3 days at 27°C temperature. After…

A: Given 2% sewage sample Do consumed=10 mg/L Dilution factor DF=2% Ultimate BOD=?

Q: e considering a rigid body in ons of equilibrium can we write? c) 4 d) 6 = 200 x

A: The answer is a) 2. For a rigid body in 2D, there are only two linearly independent equations of…

Q: A flownet below a dam consists of 24 equipotential drops and 7 flow channels. The difference between…

A: Given- Equipotential drops Nd=24 Flow channels Nf=7 Head H=6 m G=2.70 Void ratio e=0.70 FOS=?

Q: If the coefficient of friction between the steel wedge and the moist fibers of the newly cut stump…

A: The maximum angle at which the wedge may be driven into the wood can be calculated using the formula…

Q: List only Two of the following: 1) The Purpose of Water Demand with the percentage of each purpose.…

A: This question is related to the Environmental Engineering from Civil Engineering. As per question we…

Q: The wide flange beam shown in the figure supports the concentrated load W and a total uniformly…

A: Given:- To find:- Moment of inertia of the section Concept:- Moment of inertia of the symmetrical…

Q: For the following beam, select the correct FBD(s). There may be more than one. A 20¹ Possible Free…

A: Given, Simply supported beam with dead load 100 lb/ft   To find : Correct choice for free body…

Q: A field is in the form of a triangle. If the true bearing of side AB is N48°15'E, AB = 15, BC = 12,…

A: a.) Azimuth (from South) of BC: The formula for finding the azimuth of a line given its bearing…

Q: 1. In picture on the right, let's say that F₁ = 400 N, F₂ = 560 N & F3 = 280 N. a) Divide all forces…

A:

Q: 2. Determine the largest load P that can be applied to the frame without causing either the average…

A:

Q: с d = 20 mm Al 20 kN 30 kN 15 kN D d = 15 mm B k 6 m 2 m 2 m 4 m 2 m A beam is suspended by a rod (6…

A:

Q: Water (bulk modulus of elasticity = 2.2 x 103 MPa) is flowing with a velocity of 2 m/s through an…

A:

Q: For a population of 2 lac having per capita daily demand of water of 150 litres, determine the water…

A: Detailed solution is attached below as

Q: A wooden buoy (s.g. = 0.62) is 70 mm by 70 mm by 5 m long is made to float in sea water…

A:

Q: Identify the hydrologic processes that affect flood runoff from a 3000-ft section of interstate…

A: The movement of water over the earth surface is known as surface runoff or flood runoff. This occurs…

Q: 3. A beam ACB, simply supported at the ends, has a moment inertia of 41 for the length AC and I for…

A:

Q: The force of magnitude F = 172 lb acts along the edge of the triangular plate. Determine the moment…

A:

Q: A reservoir with a live storage of 300 million cubic metre irrigate 40000 hectares (1 hecatre = 104…

A: Given data in question  Storage 300 million cubic meter Area 40000 hectares Base period 120 days 2…

Q: A pump is used to draw water from an open reservoir to an open tank on the top of a building. The…

A: Given,  Flow rate (Q) = 50 L/s or 0.05 m3/s Static head (Hs) = 6 m  Static discharge head (Hsd) = 20…

Q: For a road with a distance = 3 km. Calculate (TMS) AND (SMS) for the following traffic. car Time…

A: Given,  Length (L) = 3 km or 3000 m    To find : Time Mean Speed (TMS) and Space mean Speed (SMS)

Q: The friction angle of a soil layer is 37 degrees and the cohesion is 5 Kpa. The lateral earth…

A:

Q: determine the number of sheets of roof decking required to cover a roof that is 180 ft by 90 ft if…

A: Roof size- 180 ft by 90ft Sheet size- 42ft by 3ft 3 inch  Decking length - 42 ft  Lapping length -2…

Length and Length related Variables

Length can de defined as the measurement or extent of physical quantities or objects from one terminal to another terminal. Stone age humans used finger length, step length, and so on to measure the size or displacement of an object. Nowadays, depending on how precise the measurement requires to be and the object’s size is measured, we use measuring devices for measurements like rulers and steel tape. Most people have used a ruler or tape measure to measure a particular distance or the size of an object. For more precise measurements of tiny objects, the development of measurement tools such as the Vernier caliper, which permits us to measure dimensions within 1/1000 of an inch. In the last few decades, electronic distance measuring instruments (EDMI) have been implemented that permit us to measure distances from a few feet to many miles with reasonable accuracy.