mw 367Jna 2367 3 367 9 367 15 367 12-367 367 Tw, inital 23.3 29.8 34 ليها 45.6 52.4 58.5 Tw, Final 29.8 34.6 ५०१ 45.3 5.75 58.5 Cp = m Q AT At QW) 1366 عمه 285 325 361.6 383.3 65,2 calculate CPP w/g.c Time(s) 74 30 36 33 30 34 Cp

Q: A continuous single effect evaporator concentrate a dilute juice stream entering at 3wt% salt…

A: Concentration of salt entering the evaporator = 3 wt % Salt concentration exiting the evaporator =…

Q: Question 2: A spring-loaded piston-cylinder device contains 1 kg of carbon dioxide. This system is…

A: (2) Given, The mass of CO2 is 1 kg. The initial pressure of the gas, P1 = 200 kPa The initial…

Q: 3) A binary mixture of methanol and water is to be separated in a continuous multi- stage…

A: A mixture of methanol-water is to be separated in a continuous multistage distillation column.

Q: What are typical ratios of nanomaterials to polymers in polymer in polymer nanocomposites?

A: To explain what the typical ratios of nanomaterials to polymers in polymer nanocomposites are

Q: (2) Consider the gas has composition by mass of 25% nitrogen, 23% oxygen, 32% helium and the balance…

A:

Q: Benzene is held at 425 K. Find the fugacity and fugacity coefficient at: a.) Psat b.) 2 bar c.) 12…

A:

Q: The irreversible, exothermic liquid-phase reaction A----->B is to be carried out in a 1 m³ adiabatic…

A:

Q: A simple batch distillation

A:

Q: Are you sure about the flowrate? Because the equation you gave indicates that as FAo decreases, then…

A: If we decrease flow rate , then we have more residence time for the reactant to react  and if we…

Q: EX2 Given reaction 4A = B, which has time-independent stoichiometry and kinetic equation r = k[A]".…

A: Given that 4A→ B-dAdt=kAnlet initial concentration of A be Aowhen 20% A is consumed than…

Q: Vapor Composition, Mole Fraction BENZENE 1 0.9 0.8 0.7 0.6 0.5 0.4 0.3 0.2 0.1 For part a) For part…

A: Composition of the feed is, Benzene = 0.491 Composition of benzene in the overhead product = 0.966…

Q: A completely mixed 100 L tank receives constant chemical mass addition of 300 mg/min and a 40 L/min…

A: Given that, The volume of the tank V = 100 L Input mass flow rate of stream 1 = Min,1 = 300 mg/min…

Q: Question 1 Consider the specific gravity of Acetic acid is 1.049. Calculate the density of Acetic…

A:

Q: Methane is burned completely with 25% excess air. The fuel and air enter the furnace at 25°C and the…

A: Write the reaction for the combustion of methane as follows: CH4 + 2O2 → CO2 + 2H2O One mole of CH4…

Q: 1. Natural gas usually contains a mixture of methane and ethane. Methane (CH4) and ethane (C₂H6)…

A: The process flow diagram of a process is given.

Q: E4B.1(a) The standard molar entropy of liquid water at 273.15 K is 65 J K−1 mol−1, and that of ice…

A: Given: Molar entropy of liquid water = 65 Jmol.K Molar entropy of ice = 43 Jmol.K Increase in…

Q: 3:We wish to strip SO₂ from water using air at 20C. The inlet air is pure. The outlet water contains…

A: given  = X1 = 0.0011 and X2 = 0.0001 m = 22,500 mmHg/mol fracSO2

Q: What will happen to the b) pressure if the container is tightly sealed? Explain the answer in your…

A: b. Given that Specific gravity of liquid chemical = 0.750 And atmospheric pressure Need to answer…

Q: Fraudium has a normal boiling point of 59.2 K and a melting point (at 1 atm) of 52.1 K . Its…

A: Given that- For fraudium, Boiling point=59.2 K ( at 1 atm) Melting point=52.1 K ( at 1 atm) Triple…

Q: 3. A horizontal steam pipe has an outer diameter of 8.9 cm and passes through a large room whose…

A: Write the expression for the heat transfer by radiation as follows: Q1 = εσATs4-Tw4      ......1…

Q: What is the final temperature of the helium gas?

A:

Q: A single effect evaporator is used to concentrate a dilute stream of sugar syrup containing 15%…

A: Concentration of solids entering the evaporator = 15 % Concentration of solids exiting the…

Q: The figure below shows a mixed 200 L tank receives a single inflow but has two outflows. The tank is…

A: Given that, The volume of the tank V = 200 L Input mass flow rate of stream 1 = Min,1 = 200 mg/min…

Q: Consider a sphere of mass 1.8 kg with the following properties k=0.45 W/m°C, a = 0.13 x 106 m²is,…

A: Mass of the sphere = 1.8 kg Thermal conductivity, k = 0.45 W/m.0C Thermal diffusivity, α= 0.13*10–6…

Q: Hot brine from a geothermal well passes through 120 3 cm-O.D., 1 mm-wall- thickness, 16 m-long…

A:

Q: (c) Given x₁ = 0.33 and P = 120 kPa, find y₁ and T. (d) Given y₁ = 0.33 and P = 120 kPa, find x₁ and…

A: Answering c) and d) as mentioned in the question. C) Given, x1 = 0.33 P = 120 kPa Use Raoults' law…

Q: (a) partial molar properties and (b) summability relation

A:

Q: can you explain how you interpolated and show the steps?

A: Initial pressure of steam = 2700 kPa Quality = 0.9 Final pressure = 400 kPa

Q: What ratio of CH3NH₂ to CH3NH3* is needed to prepare a pH 9.70 buffer? (Kb for CH3NH₂ is 4.4 x 10-4)

A: Kb for CH3NH2 = 4.4×10-4 PH = 9.70

Q: Question 4: An insulated room is heated by burning candles. Is this a heat or work interaction? Take…

A: 4) Using the entire room as the system, there is no heat interaction because it is well insulated…

Q: Problem 2. Water is flowing through a circular pipe of radius R=2.5cm. The velocity profile of the…

A: Given, The velocity profile, v = v01-rR1/7 Where, v0 = 3 m/s The radius of circular pipe, R = 2.5 cm…

Q: 200 E240 S 220 + V242 DO P240

A: Feedback controls are widely used in modern automated systems. A feedback control system consists of…

Q: The conversion of an irreversible first-order, liquid-phase reaction, taking place in a PFR of 600…

A: Irreversible first order reaction is taking place in a PFR (plug flow reactor) with following…

Q: (a) (i) List four factors that influence the microstructure of an alloy. (ii) Briefly describe the…

A: To List four factors that influence the microstructure of an alloy Briefly describe the difference…

Q: Question 4: An insulated room is heated by burning candles. Is this a heat or work interaction? Take…

A: soulution 1 we have given insulated room means No transfer of heat take place outside the…

Q: 1A 8A H2A 3A 4A SA 6A 7A He Li Be BCN OF Ne P S Cl Ar Na Mg 38 48 58 68 7888 18 28 Al Si Sn Sb Te I…

A: Electronic configuration represents the arrangements of electron around the nucleus in the shells,…

Q: ХА Рт — Р В Po A PO в

A: given that there is an equation given in therms of total pressure and partial pressure ..we have to…

Q: 5.11. The data given below were obtained for the reaction A → B using a laboratory-scale reaction…

A:

Q: 2. Assuming a feed of xf = 0.45 at 10 bar at the bubble point, we want to achieve an xp= 0.70 and xw…

A: A mixture of cyclohexane and butanol is separated into distillate and bottom products.

Q: A 60-40 mixture (by moles) of A and B is separated into two fractions. A flowchart of the process is…

A: Given, The feed flow rate of the mixture, F = 1250 lbmolh The composition of the mixture is 60% A…

Q: Choose the correct option: 19. A reduced pressure (vacuum) distillation is used when: a) The…

A: Distillation is a separation process in which the light key component is separated from heavy key…

Q: Explain the differences between absorption and adsorption(four points each).

A: Absorption is a chemical or physical method or mechanism in which the species like atoms, molecules…

Q: Estimate ƒ₁. 2. 1. and 2 assuming that the mixture is an ideal solution. ƒ₁=| Î2² ƒ₂ = [ $13 (2 11…

A: System of ethylene (1) and propylene (2). Temperature, t = 150°C = 423 K Pressure, P = 30 bar Gas…

Q: Wet steam at 10 bar flows at a molar flow rate of 80 mol/s and a volumetric flow rate of 0.2 m3/s.…

A: Pressure of steam = 10 bar Molar flow rate of steam = 80 mol/s Volumetric flow rate = 0.2 m3/s

Q: 1. A problem indicates that the enthalpy of a compound can be predicted by an empirical equation H…

A:

Q: Consider the reaction: 2CO(g) + O₂(g) → 2CO₂(g) Using standard thermodynamic data at 298 K,…

A:

Q: Air at-100C blow at 10 m/s over the exterior of a 30 cm-O.D. pipeline spanning a river gorge. The…

A:

Q: Nitrogen gas enters a 0.450 m diameter pipe at 30.0 °C, 2.60 atm (absolute), and 6.30 m/s. The pipe…

A:

Q: Question A feedwater heater that supplies a boiler consists of a shell-and-tube heat exchanger with…

A: NOTE = According to Bartleby policy we can answer only first 3 subparts of the question. a) water is…

Q: hat are the specific enthalpy, H, and specific volume, V, of steam at 400.0 °C and 40.0 bar? = = Is…

A: