Name: (11) The supply voltage VCC equals 9V. The base resistor Rais 42. Take 0.6V for the knee voltage of the base-emitter diode. Draw the load line for a short-circuit current of 15mA (a) What is the value of the collector resistor RC in that case? (b) What is then the voltage Va across the transistor? (c) What is then the current le through the transistor? RB m VCC 9.0V RC lc (mA) 15 Ō 10 Student nr: saturation region 5 Answers: (a) RC- (b) Va= (c) Ic= active region cutoff region 10 15 VCE (V) {npn} 20 L₂=0.4 mA 1₂=0.3 mA IB=0.2 mA Ig=0.1mA Ig=0 mA

Name: (11) The supply voltage VCC equals 9V. The base resistor Rais 42. Take 0.6V for the knee voltage of the base-emitter diode. Draw the load line for a short-circuit current of 15mA (a) What is the value of the collector resistor RC in that case? (b) What is then the voltage Va across the transistor? (c) What is then the current le through the transistor? RB m VCC 9.0V RC lc (mA) 15 Ō 10 Student nr: saturation region 5 Answers: (a) RC- (b) Va= (c) Ic= active region cutoff region 10 15 VCE (V) {npn} 20 L₂=0.4 mA 1₂=0.3 mA IB=0.2 mA Ig=0.1mA Ig=0 mA

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Identify the source, drain, gate, and bulk terminalsand find the current I in the transistorsAssume VTN = 0.70 V
A transistor must reach a saturation voltage ≤ 0.1 V with IC = 10 mA. What arethe maximum value of βFOR and the minimum value of the base current? Use the transistor parameters from Table.
Design a common emitter transistor so that it will operate in the linear region with a max swing on the output. Use a voltage devider configuration (ex 4.10) with a collector current of Ic = 2mA and a supply voltage of 12 V. Calculate all the resistor values. Choose Ve= 10% of Vcc
An npn transistor with IS = 5×10-16 A, βF = 100, and VA = 65 V is biased in the forward-active region with VBE = 0.72 V and VCE = 10 V. a) What is the collector current IC? b) What would be the collector current IC if VA = ∞? c) What is the ratio of the two answers in parts a and b?
Instruction/s: Draw, Illustrate and label your schematic diagram before solving the problem. 1.) Given a Fixed-Biased transistor circuit with Beta DC is 200 , voltage at common collector is +22v ,base supply voltage is +11V, Base resistor is 47kOhms , collector resistor is 390 ohms ,Voltage at Base-emitter junction is 0.7v. Determine the Q-point of collector current and Voltage at collector-emitter junction. These is the example or guide that might help in answering the problem.
Draw the IV graph for a MOSFET in deletion mode, with a drain source current of 1.2 mA. Indicate this value on the graph
I need answer ASAP. Thank you! Given: RD = 2kohm , Rs = 0.51kohm , RG = 1Mohm and VDD = 18V Gate junction saturation current= 6 mA and VTO = -4 V A.) Find the value of drain current and gate current. B.) What type of JFET DC biasing is this? C.) Find the Drain voltage, Emitter Voltage and Gate Voltage.
Topic: Transistor Familiarization a. Describe how to determine whether an unknown transistor is a PNP or NPN type with just the aid of an ohmmeter. b. In order for a PNP or NPN transistor to function, what bias must be applied to the emitter-to-base junction? c. Differentiate the transistor from the vacuum tube.
An npn transistor with IS = 5×10−16 μA, βF = 100,and VA = 65 V is biased in the forward-activeregion with VB E = 0.72 V and VC E = 10 V.(a) What is the collector current IC? (b) Whatwould be the collector current IC if VA = ∞?(c) What is the ratio of the two answers in parts (a)and (b)?
Determine the operating point values of current Ic(=Icq), voltage Vce(=Vceq), Vce(cutoff) and Ic(sat) in the circut below. The current gain B for the transistor is 180. Vcc = 16, Rb=330kohm, Rc=1100 ohm and Re = 550 ohm
Consider the BJT circuit in Figure 6. Assume that the following values remain constant during the operating conditions, DC  = 100 and VBE = 0.65V,Calculate:i. Base, collector and emitter currents ii. VCE and VCB iii. DC alpha, DC
A PMOS transistor is operating with VBS = 0 V,VGS = −1.5 V, and VDS = −0.5 V. What are the region of operation and drain current in this device if W/L = 40/1?