Name : One side of a plane wall is maintained at 80°C, while the other side is exposed to a convection environment having T = 20°C and h=15 W/m² °C. The wall has k=1.2W/m C and is 40 cm thick. Calculate the heat-transfer rate through the wall and the temperature at the outside.

Q: 65. The temperature of an ideal gas remains constant at 250 °K while the absolute pressure changes…

A:

Q: Ex:Calculate the critical radius of insulation for asbestos with k = 0.17 W/(m.K) surrounding a pipe…

A:

Q: 3. A household refrigerator that has a power input of 450 W and a COP of 1.5 is to cool 5 large…

A: The power input to the refrigerator is W = 450 W COP is 1.5 The specific heat of watermelons is 4.2…

Q: A continuous fractionating column is required to separate a binary mixture containing 0.20 mole…

A: Given, The mole fraction of A in feed, zf = 0.20 The mole fraction of A at top, xD = 0.95 The mole…

Q: O2 (A) is diffusing through Carbon Monoxide (B) under steady-state conditions, with carbon monoxide…

A: Given thatPT =105  Nm2PA1 =13 x 103  Nm2PA2 =6500  Nm2T =0 C =273.15 kDAB  =1.85 x 10-5  m2sz =0.002…

Q: 3. An aqueous solution with a specific gravity of 1.12 flows through a channel with a variable…

A:

Q: It has been proposed that a company invest $1 million of its own funds in a venture which will yield…

A: Given data: Proposal 1: Total available funds = $1 million Amount invested in a venture = $1 million…

Q: Total Pressure (Ptotal) [Pa] P. - total = 3707 H + 131723 Height (H) [ft] In a lab on campus an…

A:

Q: Question From the following data for water: Determine its heat of vaporization (AH vap.) Temperature…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: A combination of two heat engines is operated in series with an intermediate heat reservoir in…

A: For Heat engine in series ηoverall = 1- (1-η1)(1-η2)

Q: An acetone and water liquid mixture is fed to an evaporator to be partially vapourized. The initial…

A: A mixture of acetone and water is to be partially vaporized.

Q: In the gas-phase reaction 2A+B 3C + 2D, it was found that when 1.50 mole A, 2.00 mole B and 1.00…

A: Write the reaction as follows: 2A+B↔ 3C+2D   The temperature of the reaction, T = 25°C = 25+273 K =…

Q: For SO2 at 600 K and 300 bar, estimate the fugacity and of G R /RT by using 2nd virial equation

A: Given data: T = 600 K P = 300 bar

Q: 2.7-6. Energy Balance on a Flow System with a Pump and Heat Exchanger. Water stored in a large,…

A:

Q: Inorder to approach ideal PFR behavior, the flow must be turbulent. For example, with an open tube,…

A:

Q: What are the application of engineering mechanics to the field of chemical engineering? What are the…

A: It is good to have a sound understanding of mechanics to solve coupled transport problems and this…

Q: The growth of plants in a greenhouse depends on the intensity of the lighting (as controlled by an…

A: The given relationship between plant growth rate P and light intensity L is given by…

Q: What is the de Broglie wavelength of a single (1) molecule of a protein that has a molar mass of…

A: My procedure to solve the problem is correct.. Please verify the options once more

Q: 1. A solution of Histidine with a concentration C = 60.5 mg/L has an absorbance of 0.794 when the…

A: Write the Beers law as follows: A = εbC    ......1   Given, The absorbance, A = 0.794 The cell…

Q: A four component mixture of ethylbenzene (z1=0.06, α1=1.25), p-xylene (z2=0.40, α2=1.15), o-xylene…

A: A mixture of four species is to be separated in a distillation column.

Q: 4. Consider a cylinder fitted with a piston that contains 2 mol of H₂O in a container at 1000 K.…

A: As given   mole of H2O (n )  = 2  Temperature of container T = 1000K Initial volume V1 = 10L Find…

Q: A hot solution containing 1000 kg or MgSO4 and water having a concentration of 30 weight percent…

A: Mass of hot solution = 1000 kg Concentration of MgSO4 = 30% Solubility at 288.8K = 24.5% 5 % water…

Q: The value of ArxnH° is 12.93 kJ/mol at 850 K for H₂(g) + 12 (g) 2 HI(g) (a) Assuming that ArxnH is…

A: Given data: Standard enthalpy of reaction at 850K, ΔHr0 = 12.93 kJ/mol Equilibrium constant at 1000…

Q: Bottled gases are the liquified petroleum gases propane and butane. If a sample of this gas were…

A: Given,100 mol The bottled gases are propane and butane. Let the moles of propane and butane be n1…

Q: single isothermal expansion step

A:

Q: Calculate the weight and volume of air required for complete combustio of of 4 kg coal with the…

A:

Q: X (s) Gy(s) G₂ (s) G₂(s) G5(s) Gg(s) G₂ (s)

A:

Q: Air is compressed into a 45 ft³ rigid tank until the pressure is 52.5 psia and the temperature…

A: Introduction:- The equation of state of an ideal gas, often known as the ideal gas law equation, is…

Q: 1. A carbohydrate (S) decomposes in the presence of an enzyme (E). The reaction follows…

A: Given data: M-M kinetic parameter area, Km= 200 mol/m3 Vmax= 100 mol/m3.min CS0 = 300 mol/m3

Q: Q4) Estimate the fugacity of isobutylene as a gas: (a) At 280°C and 20 bar (by using 2nd virial…

A: Given data: T = 280 0C OR 553 K P = 20 bar

Q: Q4. Water flows along the rectangular channel such that after it falls to the lower elevation, the…

A: Given  h = 0.3 Width of channel = 1.5 m Area of channel at Q (A) = 1.5×.3

Q: What is the derivative of d rho U / d rho ] S.   Rho = 1/ V   dU = TdS - P dV

A: It is required to calculate the derivative of d rho Ud rhoS Where rho = 1/V As per the given…

Q: What do you mean by an excess of the reactant?

A: we need to define the term Excess of reactant.

Q: production

A:

Q: 100 A в та

A:

Q: Professor Modyn's steady state flow reactor is now fed acetylene (C2H2)(C2H2) at 2.000 mol/s.2.000…

A: Given that, The molar flow rate of acetylene in the feed stream nC2H2,F =  2 mols %excess dry air =…

Q: Oxygen is diffusing through a stagnant layer of methane 10 mm thick. The temperature is 20°C and the…

A:

Q: A 10-cm-diameter sphere maintained at 30°C is buried in the earth at a place where k-1.2W/m C. The…

A: Given: The diameter of the sphere is d = 10 cm = 0.1 m and Ts = 30oC, and the surface temperature of…

Q: A distillation column with full condenser and partial reboiler separates acetone from isopropanol.…

A: A mixture of acetone and isopropanol is separated into distillate and bottom products with the help…

Q: A pharmaceutical plant uses an incinerator to destroy its organic solvents including heptane (C7H16)…

A: C7H16 + 11[O2 + 3.76N2] = 7CO2 + 8H2O + 41.36N2 WKT, air contains 21% O2 and 79% N2 hence ration of…

Q: The cetane number measures the ignition delay of a fuel. It is measured in terms of the volume % of…

A: Basis = 100mol of flue gas WKT, 100mol of air contains 79 moles of N2 82.16% of N2 will have =…

Q: Five hundred kilograms of an aqueous feed containing 50 mass% acetone is contacted with solvent…

A: Given, The feed, F = 500 kg The mass percent of acetone in feed, zc = 0.5 The ratio of feed to…

Q: 4. A treatment pond with an influent waste concentration of 100 mg/L produces an effluent…

A: given  Initial concentration Co= 100 mg/l Concentration after 5 hr C = 30 mg/l Detention time t = 5…

Q: Im sorry but how did u solve the equation for turnover? 4.8 = 2ln(1-x)-x isnt solvable

A: The production rate of desired product is calculated using the design equation of PFR.

Q: QUESTION 1 A rigid tank of volume 5 m' initially contains saturated water vapor at a temperature of…

A: The initial state of the steam is at saturated vapor. The temperature of the steam, T1 = 120 °C The…

Q: Braqmet erti szips of food riguone eipiensp of beloper sd of ever bluow d. What singular change can…

A: d) To vaporize letter B, we have to increase temperature or decrease pressure because presently…

Q: How diffusivity is dependent on temperature and pressure

A: gIVEN THAT we have to write how diffusivity is dependent on temperature and pressure

Q: A → B + C + D being carried out isothermally in an ideal plug-flow reactor PFR) packed with a…

A:

Q: How is the production process bioethanol from cellulose?

A: Biomass Handling = To facilitate handling and boost the effectiveness of the ethanol manufacturing…

Q: 1. The following data were observed when a gas was compressed. Calculate the work needed to compress…

A: As we know 1 bar = 100000 Pa