The standard practice of synchronous generator construction now a days is tohaveCylindrical fieldRotating armatureEither of the aboveRotating fieldIn an alternator, the armature reaction influences the magnitude ofNo load lossWave form of generated voltage.Speed of the machineFluxTerminal voltage per phase

These are the few questions related to the basic understanding of alternators their construction and…

ndard practice of synchronous generator construction now a days is to ndrical field ating armature er of the above ating field ternator, the armature reaction influences the magnitude of load loss we form of generated voltage. ed of the machine = minal voltage per phase

ndard practice of synchronous generator construction now a days is to ndrical field ating armature er of the above ating field ternator, the armature reaction influences the magnitude of load loss we form of generated voltage. ed of the machine = minal voltage per phase

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.48P

See similar textbooks

Related questions

Q: What are the limitations of the electromagnetic method?

A: Electromagnetic method includes the use of a energized dipole , which is supplied a Alternating…

Q: An AM signal has the equation: Find the amplitude of the carrier v(t) = [15 + 4 sin (44 x 10^3t)]…

Q: Compose the voltage equations based on the variables given. Retain the signs generated by the…

A: The given circuit diagram is shown below:

Q: A burglar alarm rings if the door switch or the window switch is activated. However, a key operated…

A: The AND gate results in a output "high" only when both/all of the inputs given to it are "true"…

Q: UPSs measured in ____________ and ______________. __________________ are what your system uses and…

A: Given about UPS systems An uninterruptible power supply or uninterruptible power source is an…

Q: 1. Calculate the gain of a negative-feedback amplifier having A = -2000 and p = -1/10. 2. Calculate…

Q: inductive reactance of 10 ohms is connected in parallel with a capacitive reactance of 30 ohms. If…

A: Active Power- It is power utilized by the load. Active power is equals to the multiplication of…

Q: Q1/ For a LTI system, drive the frequency response, if you know that the input is: r(t) = M cos(wt +…

A: Given,For a LTI system,The input signal is,rt = Mcosωt+θ

Q: State the condition for the stability of a linear system.

A: Linear system:- If a system satisfies the superposition theorem or additivity and homogeneity both…

Q: Given the inductance of 2.5 µH with a reactance of 400 Ω. What will be the value of the frequency?

Q: For the following frequencies, determine the free-space wavelength, the ITU frequency band, and…

A: Given (a) 450 MHz, (b) 2 GHz

Q: A combination of three resistors R1, R2, and R3 in series is connected across a voltage source VT.…

Q: Solve the approximate value of VE of Figure 45. VCC 16V 33.9ΚΩ Q1 V₁₂₁ R1 $68kQ R2 $9.1kQ 1.3 V 1 V…

A: We need to find out emitter voltage for given circuit

Q: Solve the value of emitter resistor of an emitter-stabilized bias circuit with cutoff voltage of…

A: We need to find emitter resistance for given circuit .

Q: Find the currents using Maxwell's Method

A: Brief description: By the use of mesh analysis we need to calculate the values of all the branch…

Q: For the emitter follower network, find (a) lg (b) Ic (d) Ig (d) Vg (e) Ve (f) Vg (g) Vec (h) Vcz 12…

A: Collector current (IC): Current is the rate of change of the flow of the charges. The current that…

Q: Draw the linear approximation to the log - magnitude on semilog paper for th open loop transfer…

A: Given transfer function is GHs=271+s2s31+s10 Where, K=2720log27=28.627Cut off frequencies 1,10rad/s…

Q: 1. A coil of 2000 turns with a 100-mA current has a length of 0.2 m. (a) Calculate the mmf in…

A: Given a coil has, Number of turns, N=2000 Current, I=100 mA Length, L=0.2 m

Q: Determine the bandwidth and baud for an FSK signal with a mark frequency of 99 kHz, a space…

A: In this question we will find bandwidth and baud for an FSK signal....

Q: DRAW CIRCUIT OF ANALOG TO DIGITAL CONVERTER CIRCUIT. AND EXPLAIN HOW IT WORKS

A: Analog to digital converter:- This converter is used to convert the analog quantity to digital…

Q: VGS Q2) For the circuit shown in Fig. 1, calculate the following given that the values of the…

Q: The dc shunt generator given its rated voltage when the field resistance is higher than critical. O…

A: We know that the critical field resistance is the highest allowable shunt field winding resistance…

Q: [1] Draw output waveform for the following circuits if sinusoidal signal of 6V peak-to-peak with…

A: Diode: It is a semiconductor device and this is unidirectional because it flows the current when…

Q: Which of the following is an interrupt controller? Select the correct response: a. 82C59A b. 82C55A…

Q: 01 A 10 kVA, 500/2000 V, single-phase, 50 Hz transformer gave the following test results : 500 V at…

A: In this solution the concepts related to the SC & OC tests of a transformer is discussed. Given…

Q: A 50 HP, 440 V, 3 Phase, 60 Hz, 6 Pole squirrel cage induction motor is operating at full load and…

A: To determine full load torque of a 3- phase induction motor operating at a slip of 5%

Q: HE 0.47μF Determine re. 24.88 02 82.84 Q 42.88 Q 128489 mt www # 0.47μF 58 kQ 10 kQ 1.2 k Cw Cwo 5.6…

Q: If the frequency were doubled, what would be the new impedance? R E sine R = 123 ohms XL = 16 ohms…

Q: la W R4 202 V5 -4V X V4 Hill 6V Ib y R6 40 g R5 40 Ic Z V6 -2V

Q: decimals Four resistors, R1 = 100 ohms, R2 = 250 ohms, R3 = 350 ohms, and R4 = 200 ohms are…

Q: Find the z-transform of the following equations: a. 2un +n

Q: 1. Resistance Measurement Choose a 10% (or a 5% tolerance if you don't have a 10%) tolerance…

A: While designing of any circuit, it is important to know the standard resistance available in the…

Q: Find the output voltage v.(t) using the Fourier transform for the circuit given when v(t) = etu(−t)…

Q: 3 la V4 R4 X ww 4.11 202 6V V5 .4V Ib R6 40 bo g R5 ww 40 Ic Z ||| V6 2V

Q: Get the phase difference of the two signals. Only the absolute value of the angle is needed. a(t) =…

A: In this question, We need to determine the absolute value of phase difference of the two signals.…

Q: What is the largest value of output voltage from an 8-bit DAC that produces 1.0V for a digital input…

Q: 1. When a synchronous motor is at working condition, is there induced electromotive force in the…

A: This is belongs to synchronous motors

Q: 8. Three JK flipflops are connected as a synchronous counter that goes through the following…

A: In this question we need to design a given counter

Q: A function is implemented by using 16x1 MUX, the function is Logic 1 Logic 0 Output 0 1 2 3 4 5 6 7…

A: The 16:1 mux can be given as .

Q: A three-phase source has a phase sequence of EAB - EBC - ECA and delivers the following delta load…

Q: Electrical Engineering For a unit feedback system having the following gain functions: G(s) Ks -…

A: Given: For a unity feedback system having the following gain functions: Gs=Ks-4.21s22s+5.7 To find:…

Q: ۲۰۱ 1 (666) 20 8 8 × 8 + 8×6 + 8×6 التاريخ حد (666 ) 10 8x6+8 46 8*6 438 الم

Q: An amplifier has a Rin = 1.2 kΩ. The coupling capacitor is 1 µF. Determine the approximate lower…

Q: 2. Using Kirchhoff's Voltage Law, find the current through the R₂. 8V 3V R3 18 Ω R2 202 R1 302 www

Q: Q3) The equivalent parameters of a transformer referred to the 10 2. The load voltage is =…

A: In this question we need to find a load impedance

Q: T(s) = s³ +7s2 -21s +10 6 so +55 654 +0s³-s²-s+6

Q: 1.) Given a base bias non transistor with V88=15V $8=150 Resistor at base to have an What value OF…

A: Base resistance: The resistance that is connected to the base terminal of the BJT is known as base…

Q: 2. Find the IN and RN of the circuit shown below as seen from the terminals A and B. 10V 212 63 72…

Q: Draw the logic diagram

Q: An abc-sequence, three-phase, 4-wire, 380-V supply is connected to an unbalanced load having phase…

A: This question is related to 3 phase circuit calculations

Question

The standard practice of synchronous generator construction now a days is to
have
Cylindrical field
Rotating armature
Either of the above
Rotating field
In an alternator, the armature reaction influences the magnitude of
No load loss
Wave form of generated voltage.
Speed of the machine
Flux
Terminal voltage per phase

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which of the following is true for the phasor diagrams drawn according to the ohmic, inductive and capacitive operating states of a round pole synchronous generator? a) Due to the voltage Efd, the excitation current is equal in capacitive operation and inductive operation b) Due to the voltage Efd, the excitation current is large in capacitive operation and small in inductive operation c) Due to the voltage Efd, the excitation current is small in ohmic operation and larger in inductive operation d) Due to the voltage Efd, the excitation current is small in capacitive operation and large in inductive operation.
Draw voltage phasor diagrams for different load cases of salient synchronous generators and derive the expression of the induced voltage.
A short shunt compound generator has an armature,shunt field and series field resistances of0.02 ohm, 80 ohm and 0.03 ohm respectively. The generator’s induced emf is 510V when theterminal voltage is 500V. How much load current is delivered under this condition.
A three phase synchronous generator with negligible resistance and Xs=20 ohm has induced voltage as well as terminal voltage per phase equal to 230 V. for the load angle of 30o, power received by the bus is .........W.
Q/ During the test of separately excited generator the speed of rotation must be held constant and the generator field resistance must be adjusted to make the generator terminal voltage 220V at no load. True False
A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line).
Which of the following is true in the phasor diagrams drawn according to the ohmic, inductive and capacitive operating states of the round pole synchronous generator a) Due to the voltage Efd, the excitation current is large in capacitive operation and small in ohmic operation b) Due to the voltage Efd, the excitation current is large in ohmic operation and small in inductive operation c) Due to the voltage Efd, the excitation current is small in capacitive operation and large in inductive operation. d) Due to the voltage Efd, the excitation current is large in capacitive operation and small in inductive operation.
Explain the working principle of the asynchronous generator. please write the answer with computer
Write and explain the parallel connection conditions of synchronous generators?
Explain the characteristics and usage areas of the asynchronous generator types.
A three-phase, 12-kV, 60 Hz, 6 pole wye connected synchronous generator has synchronous reactance of 15 Ω per phase and negligible armature resistance. For a given field current, the open circuit voltage is 13 kV. Determine the following:(A) Terminal Voltage b) Excitation voltage EA at maximum powerc) The maximum power developed by the generator
A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line). Answer fast