Suggest the most appropriate routing methods to be implemented for a small network topologyshown below to forward packets from R1 to ISP and vice versa. Justify your answers.192.168.10.0/24209.100.10.8/30GO/0so/0/1ISPInternetR1so/0/0GO/1192.168.11.0/24PC B

ANSWER: Network Topology: Network topology alludes to how different hubs, gadgets, and associations…

Answered: network topology

Engineering

Computer Science

network topology

A+ Guide to Hardware (Standalone Book) (MindTap Course List)

9th Edition

ISBN:9781305266452

Author:Jean Andrews

Publisher:Jean Andrews

Chapter8: Connecting To And Setting Up A Network

Section: Chapter Questions

Problem 10RB

See similar textbooks

Similar questions

Using packet tracer, implement a network that has the following components: 1- At least five routers 2- At least 7 subnets 3- At least 12 PCs 4- At least 4 switches 5- Use RIP routing protocol To assign IP addresses of the routers and PCs, use the IP address from your ID as follows Assume your id is 118zyxw, Consider the numbers z, y, x and w as deciemal You have the subnet 118.0.0.0/24 If your ID is 1181234 then the IP is 118.0.0.0/24 Use this subnet to get at least 7 subnets.
What is the objective of the routing protocol? Here's an illustration of how the Routing Information Protocol (RIP) works.
To what end does the routing protocol serve? Here's a case study of the Routing Information Protocol (RIP) in action.
Consider a network with 4 links between two hosts where the maximum allowable packet size is 1000 bits; each link has a transmission rate of 2000 bits per second, except the second link has a transmission rate of 1000 bits per second. How long does it take to send 6000 bits from one host to the other? You may ignore propogation delay, assume there is no other traffic on the network, and assume that no routers drop packets due to queue length. Round your answer to two decimal places.
What are the objectives of the routing protocol? Here is an example of how the Routing Information Protocol (RIP) works so that you can see how it operates.
With OSPF, a router broadcasts its link state information to all other routers in the autonomous system to which it belongs. Is this statement true or false? whichalgorithm does it use to determine the least cost paths ?
In the figure, the communication link capacity between Router 1 and Router 2 is 3 Mbps. If a 2 Mbps Voice over IP traffic and a 1,5 Mbps HTTP traffic share this communication line, what will happen?
109. If delays are recorded as 10 bit numbers in a 50 router network, and delay vectors are exchanged twice a second, how much bandwidth per fill duplex line is occupied by the distributed routing algorithm? a. 5 bps b. 500 bps c. 1000 bps d. 1500 bps
This elementary problem begins to explore propagation delay andtransmission delay, two central concepts in data networking. Consider two hosts, Aand B, connected by a single link of rate R bps. Suppose that the two hosts areseparated by m meters, and suppose the propagation speed along the link is smeters/sec. Host A is to send a packet of size L bits to Host B. d. Suppose Host A begins to transmit the packet at time t=0 . At time t= ?????? ,where is the last bit of the packet? e. Suppose ????? is greater than ?????? . At time t= ??????, where is the first bit of the packet?f. Suppose ????? is less than ??????. At time t= ?????? , where is the first bit of thepacket?
In the TCP/IP architecture, which of the following layer is responsible for routing packets? A) Transport layer B) Physical layer C) Application layer D) Internet layer Answer: iv) How many bits are used in the IP addresses of IPv4? A) 16 B) 20 C) 32 D) 40 Answer: v) For a 200-mile transmission line, which of the following will require the least number of repeaters? A) unshielded twisted pair B) shielded twisted pair C) optical fiber D) coaxial cable Answer: vi) The binary 1 represented by the absence of a line signal and the binary 0 by alternating positive and negative pulses is ________. A) pseudoternary B) NRZ-L C) bipolar-AMI D) differential Manchester Answer:
In order to troubleshoot a network running OSPF with just one region, what steps must be taken and what resources must be made available? How do you find the cause of missing route entries in an OSPFv2 single-area routing table? How do you find the cause of missing route entries in OSPFv2's single-area routing table?
For example, suppose your kid uses the school's wireless LAN to access the web by typing in www.google.com. Keep going with this hypothetical situation. (Or, you know, any other website that occurs to you right now) For clarity's sake, list the available routing protocols in the order in which they should be used.