Oil flows through a 5 cm diameter horizontal smooth pipe at 35°C. The maximum velocity with which the oil flows through the pipe is 8m/sec. Calculate the pressure drop for 12 m length of the pipe. Viscosity of oil is at 0.36 kg/m- sec. Density of oil at 35°C is 1163 kg/m³. (A) 221184 Pa (B) 314894 Pa (C) 437864 Pa (D) 223768 Pa

Q: Two moles of a diatomic ideal gas (O2) and one mole of a monatomic ideal gas (He) are initially sepa...

A: Moles of monoatomic and diatomic gas mixed is given as:   The initial temperature of the container,...

Q: A furnace is fired with fuel oil containing 86% C, 1%N, and 0.1%S with a calorific value of46.4 MJ/k...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: Hydrogen is stored in spherical tanks having a diameter of 1.5 m at 1.30 atm and 250C. What volume c...

A: Consider the hydrogen gas is stored in spherical tanks having diameter of 1.5 m at initial pressure ...

Q: A bomb calorimeter, or constant volume calorimeter, is a device often used to determine the heat of ...

A:

Q: How is learning crystal structure relevant in the study of engineering?

A: Arrangement of atoms in crystals or solids are studied and examined in crystallography Properties o...

Q: For the absorber,entering gas is 180 kmol/h; 98% CO2, 2% ethyl alcohol; 30oC,110 kPa,entering liquid...

A:

Q: What analytical techniques are used to characterize nanomaterials?

A:

Q: In absorption, the absorbent is stripped to an extent that depends on its K-value. In stripping, the...

A: The type of process which is taking place along with the reason in the given diagram is to be mentio...

Q: Q1) The following data belong to lab tests undertaken on a calcium carbonate slurry.The filter area ...

A:

Q: A stream of nitrogen flowing at a rate of 2 kg·s−1 and a stream of hydrogen flowing at a rate of 0.5...

A:

Q: Propane (C3H8) gas supplied at 1 atm and 298.15K is burned adiabatically in a steady-flow burner wit...

A:

Q: Carbon dioxide enters and adiabatic compressor at 100kPa and 300K at a rate of 0.5 kg/s and leaves a...

A: (a) The volumetric flow rate of the CO2 at the inlet of the compressor is to be determined.   Consid...

Q: Motor benzole is a mixture of 3 lower aromatic hydrocarbons, benzene, toluene and xylene in proporti...

A:

Q: Sarah mentions that burning the sludge as fuel is effective. To burn this, fuel oil is mixed with it...

A: Given that, Weight % of carbon in sludge = 40% = 0.4 Weight % of sulphur in sludge = 32% = 0.32 Weig...

Q: Nitrogen oxide reacts with hydrogen at elevated tempera- tures according to the following chemical e...

A: (a) The expression of the rate of reaction for the given reaction is to be determined along with the...

Q: What physical concept forms the premise of VSEPR theory?

A:

Q: Define the Exergy Destruction During Heat Conduction.

A: The destruction of the exergy in the process of heat conduction is to be determined.

Q: (2) ¿Ghä Which of the following sentence * ? is correct Terminating a chain polymerization reaction ...

A: The correct statement out of the given options is to be chosen.

Q: Process flow scheme on how to make tempered glass

A: There are two types of commercial glass based on the process of their manufacture. These are: anneal...

Q: How can engineers contribute to mitigating the problem of water pollution?

A: Water is essential ingredient in daily life. The water is only solvent which is used widely in the c...

Q: The reactor feed (not the fresh feed from the process) contains 3 moles of ethylene per mole of oxyg...

A: The reactor exit contains ethylene oxide, carbon dioxide, water, ethylene, and oxygen. Thus, the rea...

Q: Emergency life rafts are often filled with CO2. Assuming ideal gas behavior, a temperature of 25°C, ...

A:

Q: Producer gas is a fuel that is manufactured from the reaction of coal, steam and air. A producer gas...

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part ...

Q: For  each of the cases below, determine if the heat engine satisfies the first law and if it violate...

A: First law of thermodynamics: First law of thermodynamics represents the law of conservation of energ...

Q: Autocatalytic reaction in a batch reactor Consider the reaction A → B in a batch reactor, where the ...

A: (a)   The autocatalytic batch reaction for the conversion of A to B is written as:   The reaction r...

Q: The fluid between the same two energy reservoirs in a cooling machine A and B. Both receive the same...

A:

Q: 200 kg/hr of chlorine gas is flowing through a pipeline at a temperature of 800F and at a pressure o...

A: Given that, mass flow rate of chlorine gas = 200 kg/hr, temperature (T) = 80⁰F= 299.8 K, pressure (P...

Q: For Gₚ(s)=3e−²ˢ/{(15s+1)(10s+1)} ,Gᵥ=Gₘ=1 , suppose that a constraint is placed on the manipulated v...

A:

Q: The proximate analysis of a coal is 32% VCM, 5%M, 10% ash, 1.2% N, and 6.2% S. Its calorific value i...

A: Coal composition as given:   Coal calorific value as given:

Q: Give one example of a combination reaction that is a redoxreaction and another that is not a redox r...

A: The example of combination reaction for both redox reaction and non-redox reaction is to be mentione...

Q: Degrees-of-freedom for a three-phase equilibrium.Consider the equilibrium stage shown in Figure 4.34...

A: Number of variables= 4 Streams in + 3 Streams out=7(C+3)+1=7C+22 The number of equations are as foll...

Q: A hydrocarbon (Alkene) is used as a monomer to prepare a chain- growth polymer with molecular weight...

A:

Q: What is the pressure drop in an 18 m length of smooth 1.0 cm i.d. tubing when 25 "Cbenzeneflows at a...

A:

Q: A fuel containing 75% ethane and 25% propane is burned with dry air. All of the H2 burns to H2O and ...

A:

Q: Sarah mentions that burning the sludge as fuel is effective. To burn this, fuel oil is mixed with it...

A:

Q: A mixture contains 52 mol% cyclohexane, 39 mol% cyclopentane and 9 mol% pentane. a) What are the mas...

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If y...

Q: A radioactive waste that contains 1500 ppm(by mole) of 92Sr (Strontium) is pumped at the rate of1.5x...

A: Given data: Initial concentration of strontium = 1500 ppm (moles) Volumetric flow rate = 1.5 ×10–3 m...

Q: Using RCRA procedures, determine if the following are hazardous wastes. State the reason why or why ...

A: Code: P051 Endrin causes various harmful effect when exposed to the human body It may also include ...

Q: An automobile engine is supplied with a gasoline that is found by analysis to contain 88% carbon and...

A:

Q: Coal being used in a power plant at a rate of 8000 kg/min has the following composition Component   ...

A: Given that: the mass flow rate of coal is 8000 kg/min. The water present additional is 4.58 kg/kg of...

Q: A single-pass cross-flow heat exchanger with both fluids unmixed has water entering at 16C and exiti...

A: Given that, Flow rate of oil Vh = 0.19 m3/min = 0.00317 m3/s Density of oil ρ = 870 kg/ m3 Inlet tem...

Q: Assuming that the combustion of hydrogen gas provides three times as much energy per gram as gasolin...

A: Given data: Density of liquid H2 = 0.071 g/mL Volume of gasoline = 80 L Density of gasoline = 0.740 ...

Q: Discuss the practical advantages and disadvantages of heat pumps and electricheating.

A: Heat pump is a device which is used to transfer the heat from one place to another with the help of ...

Q: Using RCRA procedures, determine if the following are hazardous wastes. State the reason why, or why...

A: Corrosive waste have code D002 If the Spent sulfuric acid waste has a pH less than or equal to 2, it...

Q: Some HC1 gas diffuses across a film of air 0.1 in. thick at 20°C. The partial pressure of HC1 on one...

A:

Q: Acetic acid anhydride needs to be hydrolyzed in a continuouslyoperating cascade reactor consisting o...

A:

Q: Consider a batch reactor in which the following liquid phase reaction is occurring:A → BThe reaction...

A: Given that, Liquid phase reaction A→B is occurring in a batch reactor with a jacket that is maintain...

Q: A furnace is fired with fuel oil containing 86% C, 1%N, and 0.1%S with a calorific value of46.4 MJ/k...

A:

Q: A piston cylinder containing 3 lbm of water at 100 psia and T. Heat is added to the water. in this p...

A: