om above diagram: a) Find the unknown currents marked in figure (a) b) Determine the value of EMF in figure (b) 14 20 A 15A 50 A A 120 A 40A (a) 1=2A 1.52 2.5 E (b)

Q: Resistor 10k Diode 1N914 VAC + SINE(0 20 10 0 0 0 40) Vdc 5v

A: The given clipper circuit is shunt positive clipper circuit with positive biasing. To get another po...

Q: In the network, find the value of ZL for maximum power transfer. The load impedance has both variabl...

A: Given: Consider the following network: The load impedance has both variable resistance and variable...

Q: 2. Differentiate between magnetic force Fg experienced by a current carrying conductor and a free ch...

A:

Q: 1. Reduce to canonical form

A: The block diagram can be reduced by considering the cascade and parallel blocks and then reduce the ...

Q: R1 100 Ω V1 sine (A 60 Hz R2 10 10 Vrms 1:1 Calculate the magnitude (in RMS) of the voltage across R...

A:

Q: A circuit consisting of a resistor in series with a capacitor takes 100 watts at a power factor of 0...

A: Resistance: It is a property of a material that resists the flow of the current and its unit is the ...

Q: INSTRUCTION: USE 5 DECIMAL PLACES What value of R. will the circuit be in resonance given a parallel...

A:

Q: Answer the question briefly. 1. What is Alternating Current (AC)? Draw a simple graphical representa...

A:

Q: Three similar coils, each of resistance 10 Q and reactance 10 Q, are connected in star across a 400-...

A:

Q: 4. For the circuit below, E = 24230° V, Z, = 2 + j2 N, Z, = 4 - j3 N, = 6 + j8 N, Z, the complex pow...

A:

Q: Find the value of dc and ac resistance of a Germanium junction diode if the temperature is 25 degree...

A:

Q: defined by -2 n< -4 -4 <n<1 4 g[n] = 1sn

A:

Q: . A capacitor has a resistance of 80ohms when connected to a 50 Hz supply. Calculate the value of ca...

A: The solution is given below 

Q: Consider the circuit shown: R1 100 Q V1 sine (A 60 Hz 120 Vrms R2 100 2 4:1 1:2 Calculate the magnit...

A: For easiness , 1st refer all the resistance to source side of the transformer.

Q: What is Inductance and inductor? 2. What is Capacitance and capacitor? 3. Difference between inducto...

A: Inductor resists changes in current Capacitor resists changes in voltage Inductor stores energy in t...

Q: 1.What is open loop power control? On what underlying assumption is it based? 2.What is closed loop ...

A:

Q: < Notes Done How many GPS Satellites are present?

A: GPS satellie is used to circulate the earth it circulates the earth two times in a single day a uini...

Q: 3. What is the rms value of a square wave with an amplitude of 10 A and a frequency of 1 Hz? A sinus...

A: The solution is given below 

Q: For a Full wave rectifier circuit, the AC voltage input to transformer primary is 115V. Transformer ...

A:

Q: Define significance of positive, negative and zero sequence components.

A: Solve the problem

Q: Find the current through the diode D2. *

A: It is given that:

Q: 3. For the power system shown, find short circuit level and short circuit current at the F1 & F2 poi...

A:

Q: an alternating current complies 100 cycles in 0.1s. its frequency is A. 1kHz B. 0.002 Hz C. 20Hz D....

A: The solution is given below 

Q: Find the phase angle in the given alternating quantity: 90sin 400πt V. Kindly provide a CLEAR and CO...

A: Bsin( wt+ theta) Compare the given signal with the above  Signal

Q: 4. If the Z-matrix of a two-port network is Z = 1 then find Y12 and Y22 7 2 3

A: Given Z-matrix Z=4123

Q: Given the differential input signal between V1 and V2 is 1mV. calculate the expected peak to peak am...

A: According to the question, for the given circuit as shown below If V1-V2= 1 mV, then we need to cal...

Q: Below given figure depicts a discrete time signal processing system, {xx} D D a) Find difference equ...

A: (a)  yt=Z-1χ1tχ1t=Z-1χt-14χ1t-15ytZ-14+1χ1t=Z-1χt-15Z-1yt Implies, yt+Z-14yt=Z-2χt-15Z-2tyt1+Z-14+Z-...

Q: loaded zener regulator, has the following parameters: Vin= 16V; the ener rated voltage 10V, series r...

A:

Q: Unipolar line code corrects synchronization problems. true or false

A: Unipolar line code- Unipolar encode is a line code. The positive voltage represents 1 binary, and th...

Q: Use two op amps and resistors to implement the next function vo = V1 + 2v2 – 3v3 – 5v¼ If we feed th...

A: We need to implement the function, vo= v1+2v2-3v3-5v4 using 2 opamps and resistors.  

Q: A capacitor of 1uF is connected to a 50 Hz supply. The capacitiv O 10/n kilo ohms 50 mcga ohms O T/1...

A:

Q: The voltage across by a voltmeter connected across it. a resistance R5 in the circuit of Figure is t...

A: The given circuit is shown below:

Q: An FM transmission has a frequency deviation 28 kHz. Determine the percent modulation of this signal...

A: The maximum deviation in FM broadcast is 75KHz. The percent modulation is percentage of actual to th...

Q: 1. Calculate the current in J3 ohm inductor; compute the power of J3 ohm. Use Nodal analysis - j22 l...

A:

Q: What was the effect on power factor of adding more capacitance? What was the effect on reactive powe...

A: The capacitor is the device that is also used to improve the power factor of the system.

Q: 5. Determine the value of R for which the source supplies 1.00 mW to the rest of the circuit. 500 μF...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. Voltage and cur...

Q: 3. How dose the bandwidth change in relation to increasing signal amplitude? FM

A:

Q: Based on your understanding of resolution, why do you think laser radar (lidar) is more popular than...

A: Introduction: Both LiDAR and RADAR are remote sensing systems that are commonly used for object iden...

Q: Use R1 = 330Ω, R2 = R3 = 1kΩ Construct the circuit below using Proteus Simulation Software and meas...

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: 1. For the circuit shown, find the current I through the 6 Q resistor using Thevenin's Theorem 82 R ...

A: The solution is given below 

Q: Q2/ For A bridge shown, prove that C=1/ w² L, L= 1/ w°C, and f=1/2n LE R2

A:

Q: Rs 500 2 Vz = 20 V Izm = 40 mA 1kn

A: The solution is given below 

Q: 1 kΩ 2 kM Vout Vin C = 20 µF, 2 kΩ 1 kΩ +

A:

Q: Determine the current using the practical model. 20 V Si Si 102 202

A:

Q: Using re model, compute for the AC characteristic of below circuit. (Ai) 15 V 10 k2 45 k2 21k2 I µF ...

A: We need to find current gain for given circuit

Q: 2. Use mesh-current analysis to find the branch currents indicated in the networks shown below. I3 2...

A: In this question,  Find the all unknown current in the shown the circuit using the KCL and KVL.   

Q: Q2) By using Kirchhoff's Current Law Find the current through a 122 resistance(l), and current throu...

A:

Q: Determine the capacitor size in micro farad necessary to increase the power factor by 20% if the loa...

A: Given data, Load P1=100 KW Line voltage VL=480 V Frequency f = 60 Hz Initial power factor Cosϕ1=0.70...

Q: Determine the following: a) Total resistance of the circuit, Total Current and Total Power of the ci...

A: In this question,  We need to  A) Total resistance of the circuit, Total Current and Total Power of ...

Q: Q2) Convert each of the following transfer function into its difference equation z2 – 1 z2 + 1.3z+ 0...

A:

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.