One 12 V battery supplies 100 mA to a boom box. How much energy does the battery supply in 4 h? a. 17.28 kJ Ob.4 kJ OC. 4.8 d. 1.2 kJ e. 4.32 kJ

Q: 2. Analog to Digital Using PCM, perform the steps need to convert the signal to its digital…

A: Given: To find: From the graph of analog to digital conversion, we have to answer, i) How many…

Q: 3. An analog signal is given by v(t) = 2Vsin(2 450t) + 3Vsin(2л250t + 300°) + 1.5Vsin(2+800t): a)…

A: Given: v(t)=2Vsin(2π450t)+2Vsin(2π250t+3000)+1.5Vsin(2π800t), To find: a) Based on the Nyquist rate,…

Q: Calculate vo.

A:

Q: Consider the given network, where Vx= 3.7 V. 45 92 Vx 75 92 12292 220 2 0.3 A Employ Thévenin's…

A:

Q: A DC DC motor should be operated a strong field which is due to the What happens to suddenly goes a)…

A: motor operating in strong field due to current if suddenly if = 0 what happens to rotating motor

Q: 4. When vs = 10cos(2t) V, M₁ = 2H and M₂ = M3 = 1H, determine the capacitor voltage in the circuit…

A:

Q: How do I find the Fourier Series coefficients of (1 + cos(2pi*t))(cos(10*pi*t + pi/3)) using…

A: Given below clear explanation

Q: -4. A 30 KW, 250-V, d.c. shunt generator has armature and field resistances of 0.060 and 100…

A:

Q: When connected to a 120 V (rms), 60-Hz power line, a load absorbs 4kW at a lagging power factor of…

A: Given, The voltage, V=120 V supply frequency, f=60 Hz Power absorbed by the load, P=4 Kw The power…

Q: 4) An 8 bit Analog to Digital converter (ADC) has an analog input voltage range of -10V to +10V.…

A:

Q: Q1\ A single-phase voltage controller has maximum voltage of 200 V,60 Hz and a load of R = 30 2. For…

A:

Q: Determine the Total Response when x(n)=4(0.5)nu(n)+3(0.75)nu(n) using the Z-transform, given the…

A: Given below cear explanation

Q: A Q1 using the curves of Fig. 1: a. Determine the voltage across Si diode at a current of 2 mA. b.…

A: “Since you have posted multiple questions with multiple sub parts,we will provide the solution only…

Q: A single phase transmission line 120 km long has the following constants: Resistance/km/phase =…

A:

Q: Consider the unity feedback system shown in Figure 2 where R(s) is reference input and Y(s) is…

A: Given, The unity feedback system,

Q: Consider the signal ≤ n ≤2 y (n) = {0, elsewhere a) Compute the DTFT of the signal i.e. Y(w). Find…

A: Given: y(n)=1 ;0≤n≤20 ;otherwise To find: a) DTFT of the signal. Sketch the magnitude and phase…

Q: A single phase transmission line 120 km long has the following constants: Resistance/km/phase =…

A:

Q: 2) Calculate to. 5V 16 Ω - 24 Ω + 8 Ω wid 12 Ω Vo

A: The circuit is shown below:  The voltage Vx at the Non-inverting end is calculated as:…

Q: &l=3 20 cm Depth = 15 cm &12=5 20 cm &₁3=8 20 cm 2 mm

A: Here we have to find the parallel plate capacitor.

Q: A silicon pn junction at zero bias has dopant concentration of N₁ = 3 x 10¹7cm-3 and N₁ = 4 x 10¹6…

A:

Q: Problem 3 For two signals x₁ (n) = {2, 1} and x₂ (n) = {-1, 2}, 个 个 a) Calculate 2-point Discrete…

A:

Q: Question 1 : a) Compute the RMS value of the current source in Fig. 1a if the output of the current…

A: We need to find out the RMS Value of current and power for given circuit.

Q: Consider the following ODEs modeling causal LTI systems at initial rest, with input x(t) and output…

A: According to the question,

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A: In this question We need to determine the power absorb by the 3.3 ohm resistance.  Power P= I2 R We…

Q: A length of copper telephone line has a resistance of 24 ohms at 20 deg. C. What is the resistance…

A: Given data, Initial resistance R1=24 Ω. Initial temperature Ti=200 C. Final temperature Tf=360 C.…

Q: The switches in the figure below have been closed (left switch) and open (right switch) for a long…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: A DC electric field of magnitude Ez is applied along (6.15) the growth (2) axis of a quantum well.…

A: Given: In this question, the given details are, A DC electric field of magnitude εz is applied along…

Q: In the given circuit, /x = 0.0004v₁ A. IN lo bo 10 kO 20k0 With respect to the given circuit,…

A: The given problem is from circuits. The detailed solution is given in the next steps

Q: 3. A 20 ohm resistor is connected in series with a coil of inductance 80 mH and negligible…

A:

Q: A PN silicon diode has ND = 10¹8 cm³ and N₁ = 10¹6 cm³, Tp = n = 1µs and A = 1.2x10 cm². Determine:…

A:

Q: The potential difference between terminal points e and fin the diagram is: +10.0 v. (R₁ = 1.00, R₂ =…

A: We need to find out the current and emf of battery for given circuit .

Q: For the CE voltage-divider configuration, calculate the input impedance. A B D 533 02 757 Ω 949 Ω…

A:

Q: Consider a 220V (Line-to-Line) 60Hz, 3-phase, 4pole Induction Motor. The parameters of the 34.2mH.…

A: Given: In this question, the given details are, Consider a 220V (Line-to-Line) 60Hz, 3-Phase, 4pole…

Q: A loss less transmission line having Surge Impedance Loading (SIL) of 2280 MW is provided with a…

A: Given: A loss less transmission line with, Surge impedance loading, SIL1=2280 MW At a uniformly…

Q: 6. Find the output voltage when the input voltages shown in Figure 6 are applied to the scaling…

A:

Q: For a unity feedback system where K(s² + 4s + 5) G(s) = (s² + 2s + 5)(s + 3)(s + 4) a) Generate the…

A: Given below clear explanation

Q: A system has a closed loop transfer function: K(s+3) s4 +7s³ +14s² + (8 +K)s +3K Using the…

A: here we have to find the range of k for system stability.

Q: Part (0) Prior to coming to the lab, calculate the theoretical parameter values of S1, S2, a, wd and…

A: Given: Rtot = 200Ω C= 0.01μF L= 100mH Need to calculate S1, S2, α, ωd and T

Q: Given the signal below:- answer the following. a-plot X(4-t). b. Plot the even part c- Find an…

A:

Q: 3. Consider the circuit in Figure 3. (use ideal diode model in the related calculations) (a) What…

A:

Q: Let D = 6xy ax + 2(xz + 3z2) ay + 3yz az C/m2. Evaluate the surface integrals to find the total…

A: Given D = 6xy ax + 2(xz + 3z2) ay + 3yz az C/m2  rectangular parallelepiped 0 < x < 2, 0 <…

Q: Given the following system, determine the response of the system, the roots of the system, the…

A: Given,  System transfer function is C(s) /R(s) = 30/[s2 +15s +30] We need to determine the system…

Q: (Part a) Differentiation in frequency of DTFTs. Show that d -jnx[n] ⇒ X(e³¹). dn (Part b) Time-shift…

A: “Since you have asked multiple question, we will solve the first question for you. If you  want any…

Q: 3. A 230 V series motor is taking 50 A. Resistance of armature and series field windings is 0.2 £2…

A:

Q: Given the following system, determine the response of the system, the roots of the system, the…

A:

Q: Determine the best current density in A/mm² for a 3-0 overhead line if the line is in use for 2500…

A: Given data, Specific resistance ρ=1.73 Ω Conductor cost=3  per kg Weight W=6200 kg/m3 Energy cost=10…

Q: In cylindrical coordinates, V = 0 at p = 2 m and V = 60 V at p = 5 m due to charge 10 distribution p…

A:

Q: 2. Determine (a) currents 1₁, 12, 13, and 14 and (b) the voltage across the current source. +12V 6…

A:

Q: Determine whether the element involved is a resistor, capacitor, or inductor for the following pairs…

A: It is given that: a. v=185sin2513t-110°V , i=2sin2513t-20° A;b. v=380sin377t-150°V , i=5sin377t-240°…

Q: QA) a. Sketch the output v. and determine the dc level of the output for network of Fig. 1. b.…

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.