P23: Variation of activity coefficient of n-butanol with mole fraction in the the water (1) – n-butanol (2) system is given below:

Q: The equation of state of a gas is PV = RT (1-0.0062 P²). Calculate the fugacity coefficient at press...

A:

Q: Propanal (CH3CH2CHO) is used in the pharmaceutical industry to make essential ingredients, organic c...

A: (i) Reaction Kinetics is limited by irreversible reaction CH2CH2 + CO +H2→CH3CH2CHO selectivity = 90...

Q: 11.3-16 An equimolar mixture of ethanol and ethyl acetate is maintained at 75°C and 10 bar. The pres...

A:

Q: An evaporator-crystallizer is to produce 13,000 kg dry salt/h from a feed solution having 20% NaCI. ...

A: Refer to the figure shown below for the given evaporator-crystallizer system:

Q: 10 kg of saturated solution of a highly soluble component A at 80°C is cooled to 30°C .Calculate the...

A:

Q: Water is flowing through an orifice meter at a rate of 0.096 m³/sec. The diameter of the pipe is 250...

A:

Q: How is the unit for dissolved oxygen is mg/L using this formula? Show the factor-label method. Given...

A: Given:V1= 10 mLV2= 50 mLV3= 4 mLV4= 50 mLN= 0.0250 N  

Q: A mild steel tank of wall thickness 10 mm contains water at 90 °C. The thermal conductivity of mild ...

A: The system consists of three different resistances to the flow of heat. The first resistance is the ...

Q: Avapor mixture containing 50.0 mole % benzene and 50.0 mole % toluene at 1 atm is oooled isobaricall...

A: Under chemical potential gradient the transfer of components is mass transfer. The components move t...

Q: A continuous single-effect evaporator is to be fed with 5000 kg/hr of solution containing 1 wt% solu...

A:

Q: Q1/ A Petroleum cut has the following ASTM D86 distillation data:- Volume% distilled Temperature "C ...

A: given to calculate watson constant K K=(MeABP)13SGMeABP=VABP-∆VABP=T10+T30+T50+T70+T905

Q: Calculate the molality of a 4.21 M ethanol (C₂H5OH) solution whose density is 0.9479 g/mL.

A: Given : Molarity of solution =4.21 M density = 0.9479 gml WE have to find out Molality of solution. ...

Q: Process Flow of Sludge Treatment in any industrial plant

A: Mixed sludge is goes to dissolved air flotation tank which is received from secondary wastewater tre...

Q: 7. How many significant figures are there in each number or calculated value? 1) 6.0109 g x 3 = 2) 4...

A:

Q: 3-10 Determine the atmospheric pressure at a location where the barometric reading is 750 mmHg. Take...

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: The following reactions are being carried out in a fluidized CSTR at T 650 K and P 5 atm. A B+C B+F-...

A:

Q: (a)What is micro injection molding? (b) Give me product examples are manufactured by micro injectio...

A: Answering: (a)What is micro injection molding? (b) Give me product examples are manufactured by micr...

Q: A Simple Dankine cyele works hetweenpressure. 3400 kp9and beakpa,the initia/condition of Steam belng...

A: Given data  Pressure (P1) = 3400 Kpa = 34 bar  Pressure (P2) = 1000 Kpa = 10 bar

Q: 1L14 For a particular binary liquid solution at constant T and P, the molar enthalpies of mixnures a...

A:

Q: Calculate the power to move a load of 850 tons/h of a granular material on a conveyor belt, 1 m wide...

A: Given data: Flow rate of granular load = 850 tons/h Width of conveyor belt = 1 m Length of conveyer ...

Q: A simple Rankine cycle works betw een pressures 46 bar and 10 Kpa, the initial condition of steam be...

A:

Q: isothermal pulse ‘test on a piece of reaction equipment gave the following result: The output concen...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: A simple Rankine cycle works betw een pressures 46 bar and 10 Kpa, the initial condition of steam be...

A: Given data  P1 =46 bar  P2=10 Kpa = 0.1 bar

Q: a. What are the effects of the presence for sulfur compounds in crude oil?

A: (Kindly repost the other questions as separate question) Sulfur compunds are highly effects in crude...

Q: Fuel oil has a partial analysis of 7.6% S and 2.8% N. Burning 1 kg of fuel oil with  15.34 m3 air at...

A:

Q: Q2:A sandstone core sample (Vb 49 cm3, Vp 8.8 cm3, fluid mass 15.2 g) contains both oil and water (p...

A: Given, The density of oil, ρo = 0.82 g/cm3 The density of water, ρw = 1 g/cm3 Mass of the sandstone,...

Q: a. Explain briefly the concept of colligative properties b. As you boil a relatively concentrated sa...

A: To  a. Briefly explain colligative properties b. As you boil a relatively concentrated saline (i.e. ...

Q: If the flow rate of the stack gases is 100 kgmol/hr, Determine: 1. Sketch the process. Label all str...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for yo...

Q: Air (MW =28.8 g/mol) is compressed steadıly by a compressor from 100 kPa and 20°C to 1260 kPa and 30...

A: The power input is calculated from energy balance. The efficiency is ratio of heat loss and power in...

Q: An engine is using hydrocarbon for fuel at a barometric pressure of 540 mmHg absolute. The air is pr...

A: Given that, The pressure of fuel = 540 mm Hg The temperature of air Tair = 20oF = 266.483 K The pres...

Q: If one mole of ethane, C2H6, is burned completely with 20 moles of air, what is the complete composi...

A: The burning of fuel in the presence of an oxidant is termed combustion. Here, the fuel is ethane and...

Q: (4) calculate the volume of a drilling mud prepared from water and bentonite only (bent %=8%), to wh...

A: Given,The density of mud, ρ = 10 ppg = 10 lbgal×119.826 kg/m31 lb/gal = 1198.26  kg/m3The volume of ...

Q: How the solids are stored in an industry? Provide advantages and disadvantages of each method.

A: Solids are stored in an industry Bin's, Hopper and Silo's.  SILO STORAGE A silo is a shape for stori...

Q: Use the R-K equation of state to estimate the partial fugac- ity coefficients of propane and benzene...

A: Here we have to find the partial fugacity coefficient From the example we can say that a vapor mixtu...

Q: A petroleum cut has the following TBP Distillation data: Volume % distillate 10 30 50 70 90 95 Tempe...

A:

Q: The time to reach a particular conversion of a certain gaseous-phase reaction if given by the ff equ...

A: Simpson rule is used for conversion and reactor sizing. The design of reactor is based on this rule....

Q: Define the crystal defects types with plotting ( drawing ) each type .

A:

Q: We wish to produce B in the reaction A Bin a continuous reactor at a volumetric flow rate of 4 L/min...

A: Given data: Volumetric flow rate = 4 L/min Initial concentration = 2 mol/L k1 = 0.8 min–1 k2 = 0.05 ...

Q: A cylinder of diameter 10 cm rotates concentrically inside another hollow cylinder of inner diameter...

A: Given: Diameter of cylinder is 10cm (0.1 m) Diameter of outer cylinder is 10.1 cm (0.101 m) Length (...

Q: Employing the Kammerlingh Onnes equation of state, find the compressibility factors of CO at -500C a...

A: Given that  CO substance  T =-50 C  We have to find Z at different pressure 

Q: (d) The figure below shows the operation of a reciprocating positive displacement pump. Explain in y...

A:    

Q: In the nitric acid manufacture, 100 m'/h of ammonia at 290 K and 1 bar is mixed with air and passed ...

A:

Q: Peat gas analyses 22% methane, 12% ethane, 15.8% carbon monoxide, 7% nitrogen and 43.2% oxygen. 100 ...

A: Given: Component % CH4 22 C2H6 12 CO 15.8 N2 7 O2 43.2 Total  100  

Q: 10 Calculate pH of a 0,45 M ammonia solution if the ionization percent is 2.2 %a A. 2.00 B. 1.31 C. ...

A:

Q: 2. To prevent the presence of air, noble gases are placed over highly reactive chemicals to act as i...

A: given: mass of helium=5.50 g mass of krypton=35 g molecular weight of helium=4.0 g/mol molecular wei...

Q: Q2 / Solve the following differential equation (xy2 – 2y³)dx + (3 – 2xy²)dy = 0 %3D -

A: The differential equation given is, (xy2-2y3)dx+(3-2xy2)dy=0 The above equation is of the form: Mdx+...

Q: 3-IC What is the difference berween gage pressure and absolute peessure?

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned...

Q: Q 1: If 100 kg of a solution of acetic acid (C) and water (A) containing 25% acid is to be extracted...

A: a) The equilibrium data at 20°C are given in the table. The graph of the wt fraction of acetic acid ...

Q: f(t) Select the correct response: es – s 1 s2 none of these e-s – 1 – s? s2 e-s + 1 1 s2 s3 e-8 – 1 ...

A: At first we will try to find the equation of the line 

Q: Consider a reaction A → R processed in 5 CSTR's placed in series. Overall time constant is 10 minute...

A: given: A→R t=10 minutes k=0.2 min-1 C0=1 mole/m3 CN=?