P3: Given z(t) = 10 cos(2000xt +0.5 sin(20xt)) a) Sketch the magnitude spectrum, X(w)| showing only the positive frequencies b) Determine the bandwidth of the signal c) If the signal is passed through an ideal bandpass filter with center frequency of 2km [rad/s) and bandwidth 60x [rad/s]. Find the power of the signal at the output of the filter.

P3: Given z(t) = 10 cos(2000xt +0.5 sin(20xt)) a) Sketch the magnitude spectrum, X(w)| showing only the positive frequencies b) Determine the bandwidth of the signal c) If the signal is passed through an ideal bandpass filter with center frequency of 2km [rad/s) and bandwidth 60x [rad/s]. Find the power of the signal at the output of the filter.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Suppose that the modulating signal m (t) is sinusoid of the formm (t) = 10 COS ( 2π103t) and the carrier signal C(t) is sinusoid of the form C(t) = 4 COS ( 2π106t + Ɵ)1.Determine the DSBSC ( double side band suppressed carrier) AM signal in frequency domain2. Draw the magnitude spectrum of a DSBSC AM3. Determine the bandwidth of the wave
An FM radio broadcast used a modulator with a frequency deviation sensitivity of 5KHz/V, a 2Vp – 10 kHz modulating signal, and a 10Vp – 88MHz carrier Signal , determine : (a) Actual minimum bandwidth from the Bessel function table in kHz (b) Appropriate minimum bandwidth using Carson’s rule in kHz (c) Percent Modulation (d) The FM modulated waveform carrier and significant sideband components amplitudes; NOTE: Use this format in providing your answers to this problem: VJ0=x.xx v,VJ1=x.xx v,VJn=x.xx v; where VJO is the modulated carrier amplitude, VJ1-VJn is the amplitudes in significant sideband components and the number of sidebands (n) depending on your computation. (e) The unmodulated carrier power (W) for the FM modulator assumes that the load resistance is 50 Ω f) The corresponding FM modulated waveform carrier and significant sideband components power and its total power in mW. Note: Use this format in providing your answers to this problem: PJ0=xxx.xx mW,PJ1=xxx.xx…
Suppose that the modulating signal m (t) is sinusoid of the formm (t) = 10 COS ( 2π(10^3)t) and the carrier signal C(t) is sinusoid ofthe form C(t) = 4 COS ( 2π(10^6)t + Ɵ) 4. Determine the lower side band signal in time domain5. Draw the magnitude spectrum of low side band width6. Determine the upper side band signal in time domain
Suppose that the modulating signal m (t) is sinusoid of the formm (t) = 10 COS ( 2π(10^3)t) and the carrier signal C(t) is sinusoid ofthe form C(t) = 4 COS ( 2π(10^6)t + Ɵ) 1. Determine the DSBSC ( double side band suppressed carrier) AM signal infrequency domain2. Draw the magnitude spectrum of a DSBSC AM3. Determine the bandwidth of the wave
Suppose that the modulating signal m (t) is sinusoid of the formm (t) = 10 COS ( 2π103t) and the carrier signal C(t) is sinusoid of the form C(t) = 4 COS ( 2π106t + Ɵ)1. Determine the lower side band signal in time domain2. Draw the magnitude spectrum of low side band width
a. In an RC circuit supplied with AC power, a 500 ohm resistor is used to create a system with a crossover frequency wc =440 rad/s. What capacitance is the capacitor in this circuit? b. If an inductor is to be added to this circuit to make the resonant frequency equal to the crossover frequency, then what inductance must this inductor have? c. If, near a particular time t1, the instantaneous voltage drop over the resistor is given by v(t1)=0.65V cos(440t), then what is i(t1) (the function of instantaneous current with respect to time) for its capacitor? d. What would the Irms value be based on the sinusoidal function you found in part c? (Pick off Ipeak from the function, then plug in to rms equation) Since this is multi-part, answers to later parts will be graded based on your answers to previous parts when necessary.
a) In an RC circuit supplied with AC power, a 500 ohm resistor is used to create a system with a crossover frequency wc =440 rad/s. What capacitance is the capacitor in this circuit? b. If an inductor is to be added to this circuit to make the resonant frequency equal to the crossover frequency, then what inductance must this inductor have? c. If, near a particular time t1, the instantaneous voltage drop over the resistor is given by v(t1)=0.65V cos(440t), then what is i(t1) (the function of instantaneous current with respect to time) for its capacitor? d. What would the Irms value be based on the sinusoidal function you found in part c? (Pick off Ipeak from the function, then plug in to rms equation)
-MCQ- When the lower sideband components of the Double Sideband (DSB) signal whose spectrum is given in the figure are suppressed with a filter, when the signal obtained by suppressing it with a filter is multiplied by cos(ωct) in the time domain, which of the following signals is the result? a) 0.5 cos(2ωc + ωm)t + cosωct b) 0.25 cos(2ωc - ωm)t – 0.5 cosωct c) 0.5 cos(2ωc - ωm)t + 0.25 cosωct d) 0.5 cos(2ωc + ωm)t + 0.5 cosωct
Which of the following signals is formed when the lower sideband component of the Double Sideband (DSB) signal whose spectrum is given in the figure is suppressed? a) 2 cos(ωc + ωm)t b)2 cos(ωc - ωm)t c)0.5 cos(ωc + ωm)t d)cos(ωc - ωm)t
19. Determine the analytical expression for the magnitude frequency response and phase frequency response for a system G(S)=1/((S+2)) and draw the plot between them.
A series RLC Circuit, shown in the Figure, is energized by a 100 V/4 kHz AC supply.The capacitance of the circuit is adjusted until resonance occurs, producing a qualityfactor of 50. Given that the impedance at the half-power points is 70.71 ohms, determine a. the power dissipated at resonance b. the inductance at resonance c. the lower -3dB frequency and the magnitude of the current at the upper -3dB frequency
An interview is held with a student about the importance of education for thirty minutes at a radio station. It was later amplitude modulated & transmitted to receivers on the school campus.The expression below describes the transmitted signal a(z) a(z)= Acos(16πz) where A=3cos(10πz) a. In an expression form, express a(z) as a sum of sinusoids & determine the frequency components of the signal a(z)b. To adequately & fully recover the signal at the receiver, determine the rate at which the signal should be sampled.c. Determine the discrete signal,a[n] that was transmitted in a reduced form & the angular frequency assuming the signal a(z) is sampled at ten Hertz.