Part A Find the value of L so that vo (t) equals 0.5v, (0+) when t = 3.6 ms. Take R = 2002. Express your answer with the appropriate units. L = Value Submit Units www. Previous Answers Request Answer ? Com X Incorrect; Try Again; 3 attempts remaining

Q: Find total load power Provide answer asap. I will rate Positively

A: Since the given circuit is balance we can analysis the 3phase circuit on phase basis. Now we draw…

Q: Assume the switch is closed at t = 0, and for t < 0, iz(t) = 0. a. Find a differential equation…

A: The differential equations for the circuit can be obtained by applying kirchhoff's current law to…

Q: 10 225-2²+ 25V 22 {4_2 .50V Get I prop and V Drop for 101 and 42 Solve the circuit using Nodal…

A:

Q: The matching box presents an impedance of 50 ohms to the 50 ohms cable and an impedance of 115 ohm…

A: Given: The matching box shows an impedance of 50 ohms to the 50 ohms cable and an impedance of 115…

Q: A 3-kg object is moving along the x-axis. The position of the object is given by x=51-212 Question:…

A: Mass of the object =3kg Position of the object, x=5t-2t2

Q: 5. If the series winding of a DC machine is suddenly switched on to be supplied by a 220V battery,…

A: Note: A series DC Machine can be modeled at series RL circuit in transient state  Steady state…

Q: The input offset current is the difference in the two bias currents when the output voltage is O 1V…

A:

Q: For the circuit shown in the Figure find the node voltages v, and v, using r 492 www 2 V 22 22

A: Circuit is given as:

Q: 1. Using Series-Parallel concept, Find the following for the given circuit. The value of the power…

A: Given

Q: 3V + 2 ΚΩ Μ 7 mA Ho Μ ΙΚΩ Μ 5 ΚΩ

A: I have written this solution as handwritten solution. Hope you find the solution clear.

Q: QUESTION 1 Solve for Ip in mA. Use complete diode model. Assume forward resistance of 5ohms. +VD. +…

A: here we have to find the current ID in mA.

Q: a) Determine the peak output voltage for the rectifier shown in the Figure. b) Assume practical…

A: Given data:- RMS Voltage VRMS=12 V Input Voltage Vin=120 V Load Resistance RL=10 kΩ

Q: Explain different types of electrical loads with necessary diagram and examples.

A: Electrical loads- The term "electric load" refers to a gadget that uses electricity. In other terms,…

Q: 6. If a 100V DC battery supplies a resistor and an uncharged capacitor, determine the voltage across…

A:

Q: Determine the exact system matrix, , in terms of the sample period, T. associated with a Zero-Order…

A:

Q: find: Vac Vca Iab provide soln ty

A: In this question We need to determine the voltage Vac  and Vca  and current Iab  as shown the…

Q: For R1-33, R2-41, R3-62, R4-28, R5-11, R6-78, R7-70, R8-72, R9-19, R10-74 and I1=0.07 A in the…

A:

Q: The Fourier transform of the function f(t)= $(t+1) + 8(t-1) is: Select one: OP(w)=2sin(w) O F(w) = O…

A: Given data, Function is given ft=δt+1+δt-1.

Q: For R1=45, R2=85, R3=35, R4=25 and R5=10, Calculate the equivalent resistance at terminals a-b fo…

A: Calculation of equivalent resistance of the given circuit across a-b. Given:  R1=45Ω, R2=85ΩR3=35Ω,…

Q: A balanced A-connected load is fed by a three-phase supply for which phase b is open circuited as…

A: Given- A balanced ∆ connected load is fed by a 3-phase supply. Ia=8∠0° AIb=0Ic=8∠180° A.   To find-…

Q: Using the information provided, determine the resistance R1 and the current through R1 for the…

A: We need to find out unknown resistance and current through that resistance .

Q: One phase of a 3-phase alternator consist of 12 coils in series. Each coil has an rms voltage of 10V…

A: It is given that: β=10°m=10Es=10 V

Q: 1.) Find the distance from a transmit antenna (gain = 27 dB) with 10 Watt input power at which the…

A: Note: Since you have asked multiple questions, As per the Bartleby guideline, I am solving the first…

Q: A 20 pC charge is uniformly distributed over conductive sphere of radius 6cm, the electric field…

A: Given data, Charge is given as, Q=20 pC The radius of the sphere, R = 6 cm.

Q: II) Design a CS amplifier using E-MOSFET with voltage divider biasing Given: The voltage gain 20dB,…

A: The requirements of the design as given in the question are; Voltage gain = 20 dB VGS= 6 V VDD= 15…

Q: The transfer function of phase lead compensator is given by G(s) = 1+0.25s 1+0.025s frequency at…

A: Given- Transfer function of phase lead compensator- Gs=1+0.25s1+0.025s To Find- The value of…

Q: Implement and find simulation result of the following function using decoder F= ABC+AB.

A: In this question we implement the given function using decoder

Q: A inverting op amp circuit is shown. a. Find vo. b. What is the current in? c. What are the voltages…

A: here we have to find the output voltage and voltage at inverting and non inverting terminal of the…

Q: 1b) Find the currents and voltages in the circuit 30 V Α 8Ω α με 3Ω και ΕΩ

A: In this question we need to find the current and voltage of the given circuit. In parallel voltage…

Q: 1a) Determine vo and i in the circuit 492 www 12 V 652 ww 2% 4V

A:

Q: first order control system and response. closed loop feedback control first order system with the…

A:

Q: Find the average value of each voltage in Figure hr mm. SV (a) ov+ 100 V 20 V +25 V I'm pro 10 V -15…

A: Given data Four waveforms are given in the problem with different shapes and different peak Values.…

Q: A 10, 100 kVA, 11,000/2200 V, 60 Hz transformer has the following parameters. RHV = 6.0 LHV = 0.08 H…

A:

Q: Q3) Using step and ramp functions, write equations that describes waveforms shown 4 2 N

A: In this question We need to represent the given signal to unit and ramp function.  We know u(t) is…

Q: Obtain the kirchoffs Law (equation) for the circuit shown. -j14 + w 101-40°V V 42 12/10° V 6er vw…

A:

Q: If Is = 3.84A E 7 Is 12 = 240mA Determine the following E or VT = 11 = 13 = R1 = www R₁ R2 = 500 1₁…

A: In this question We need to determine the unknown parameters.  We know As per ohms law, current in…

Q: 1. A three-phase Y-connected alternator delivers 0.90 power factor load at 460 volts. If the…

A:

Q: a' is also called the O a. Conjunction b. Disjunction c. Complement O d. None of the above of a.

A: Complement  :  In digital circuit complement of any function is the inverse of that function it…

Q: C 19 k 1K0 P What is the Feedback voltage gain (B) of the above arrangement? Select one: O 0.05 O…

A: Here we have to find the feedback voltage gain.

Q: 4: Consider the finite-state machine logic implementation in Fig. 2. 1. Determine the next-state and…

A:

Q: A spring-mass-damper system has transfer function as follow: TF = (35²+45+k) Spring constant is…

A:

Q: QUESTION. Use loop analysis to calculate the power supplied by the 20 V source. 20 Ω · 5Ω 5Ω Ο 20 10…

A:

Q: Obtain the power factor and the apparent power of a load whose impedance is Z = 60 + j400 when the…

A:

Q: Q5) For the following circuit, find the Thevenin and Norton equivalents at terminals a-b: 14 14 V +…

A:

Q: A germanium diode draws 32 mA with the forward bias 0.27 V. IfT-300 K calculate the reverse…

A: Given data, Diode current is given as, ID=32 mA Forward bias voltage is given as,VD=0.27 V…

Q: Consider the circuit below. What is the total peak secondary peak voltage? D₁ 110Vrms 4:1 D₂ RL…

A:

Q: For each of the following systems, determine whether the system is (1) stable, (2) causal, (3)…

A: Given: Four discrete time Systems, To do: We have to determine whether the systems are stable,…

Q: How did you find the angles? Also my computer says the answer to (a.) is incorrect.

A: The angles can be calculated using rectangular to polar conversion i.e., x+jy=x2+y2∠tan-1yx

Q: Find the appropriate conductor size for a THHN copper wire with 75 deg Celsius temperature capacity…

A: Note: For THHN wire rated at 75 degree Celsius, National Electric Code table should be followed…

Q: QUESTION 6 Solve for the rms output voltage of figure b when Vin = -50V. Use ideal diode condition.…

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.