Pipeline that carries C3H8 propane gas at a pressure of 10 bar(abs) and a temperature of 30°C with a mass flow rate of 2kg/s. Gas has a density of 17.5 kg/m^3. If the pipeline uses a 12 inch schedule 60 pipe. What is the speed of gas flowing in the pipe in m/second?

Q: : Compressed propane (C3H3) has been suggested as a source of economic power for vehicles. Suppose t...

A: Given: The stoichiometric equation for the above process is C3H8+5O2→3CO2+4H2O Molecular weight of ...

Q: 11. Parallel reactions in CSTR The following reactions take place in a CSTR: A > 3/2 B ; A –2 > 1/2 ...

A: Given: B is the desired product, and the rate of reaction for the given parallel reactions would be ...

Q: When Ca(OH)2 is dissolved in water, it is known that the enthalpy of solution (AHsoln) is -16.2 kJ/m...

A: Given data: Enthalpy of solution = -16.2 kJ/mol Mass of calcium hydroxide = 54 g Volume of water = 5...

Q: proper 101owing pressure as PV- 3, where P is in bar, Vis in m'. If the pressure increase from 1.5 b...

A: we have to calculate work done   

Q: Values of the specific internal energy of bromine at three conditions are listed here. State T(K) P(...

A:

Q: Exercise (Given the equation) 1, A + 2B →c

A: Given equation, A+2B→C (a) rate of reaction of different components is given by, (-rA)=-1VdNAdt(-rB)...

Q: A gas stream containing acetone is to be passed through an equilibrium stage so that the acetone can...

A:

Q: a. Convert 3 weeks to milliseconds b. Convert 554 m*/(day.kg) to cm*/(min.g) c. Convert 921 kg/m3 to...

A: We have to convert all those things

Q: 4. Consider the voltaic cell which is based on the cell reaction: Zn(s) + Cutaa) Zna + Cus) Under st...

A:

Q: 8. The rate constant for the reaction A forming B has the following temperature dependence correlati...

A:

Q: Determine the weights of raw materials needed to prepare 75g samples for the given recipe of glass 2...

A: Molecular mass of- Na2O = (23 x 2) + 16 = 62B2O3 = ( 10.8 x 2 ) + ( 16 x 3 ) = 69.6SiO2 = 28 + ( 16 ...

Q: The pressure in a chemical reactor is measured by an electronic sensor/transmitter with an output ra...

A: A set of devices that are mechanical or electronic used to regulate a process variable to its desire...

Q: Q3: A. The frictionless piston shown in Figure below has a mass of 20 kg. Heat is added until the te...

A:

Q: As reported the production of nylon intermediates. The separation and purification section for cyclo...

A: The relative volatility is obtain ed from partial pressure and liquid compositions of components pre...

Q: A pure saturated hydrocarbon is burnt with excess air. Orsat analysis of the stack gas shows 7.9% CO...

A:

Q: Q1/A) If the thermometer is used as a measuring device in a control system. What is the degree ve/10...

A: The change in mercury level is modeled to be a first-order differential equation. The energy balance...

Q: Carbon dioxide at 200 kPa, 10°C flows at 1 kg/s in a 0.25-m2 cross-sectional area pipe. Find the vel...

A: Given data: Pressure of CO2 = 200 kPa T = 10 0C Mass flow rate = 1 kg/s Cross-sectional area of pipe...

Q: 1. A liquid process stream containing benzene and toluene leaves an extraction unit and flows into a...

A: following values are given in the question cross-sectional area  at the inlet (A1)=0.179 m2 cross-se...

Q: One hundred tons per hour of a feed containing 20 wt% Na2CO3 and the balance insoluble solids is to ...

A: Given, The flow rate of the feed is F = 100 tons/hr The weight% of Na2CO3 is 20% The weight% of inso...

Q: The feed to an ammonia synthesis reactor contains 25 mole % nitrogen and the balance hydrogen. The f...

A:

Q: PROBLEM 2: The vapor pressures of 1-chlorotetradecane at several temperatures are tabu- lated here: ...

A: Given T(x) 98.5 131.8 148.2 166.2 199.8 215.5 ∑x=960 P(y) 1 5 10 20 60 100 ∑y=196 xy 98.5 659...

Q: 7. Consider a steam power plant operating on the simple ideal Rankine cycle. The steam enters the tu...

A: Given: P1= P4 = 4 MPa  P2 = P3 = 100 KPa  State:1 From P1 = 4 MPa and T = 400 C  we get ,  H1 =   32...

Q: Acetylene (C2H2) may be formed from methane (CH4) by pyrolyzing-decomposing at high temperature acco...

A: Given data: Temperature of liquid methane = 25 0C Temperature of vapor methane = 650 0C % conversion...

Q: Electrophoretic separation at 1 point pH= 8.5 of a sample of proteins: 1 (100 KD), 2 (200 KD), 3 (30...

A: Answer:      option two is the correct answer

Q: -A compound effuses through a porous cylinder 2 times faster than hydrogen . What is it's molar mass...

A: Diffusion is phenomenon of transport of concentration in gas  from higher ;levels to lower levels. I...

Q: A sample of C5H1005 of mass 0.727 g was placed in a calorimeter at constant volume and then ignited ...

A:

Q: 10kg of water at 20C converted to ice at -10C and constant atmospheric pressure . The specific heat ...

A: Given Mass of water=10kg Converted from 20C to(-10)C  P=Constant Specific heat capacities of water,...

Q: Calculate the total work done for the path (a b c) of (3 mole) of ideal gas b V CE20 786 I mole K1 T...

A: given Details: ideal gas n=3 mole Ta=600 KTb=300 KTc=492 Kand CV=20.786 J.mole-1.K-1

Q: What is the capital cost of a plant that produces 250,000 tons per year of ethanol (fuel grade) cons...

A: Given: plant capacity(Q) =250,000 per year required to find capital cost using Bridgewater's method?...

Q: 3. Determine the molecular mass and identity of a +2 metal, X, that plates 46.3g of X in 6.75 hours ...

A: Given: Plating mass of X is 46.3 g in 6.75 hours at a current of 2 A 1 Ampere is equal to 1 Coulombs...

Q: o:I m3 of an ideal gas f 360 k and I bar is compressed adiabatıcally to8 bar. It is then cooled at c...

A: The ratio of heat capacities is considered. From this value and volumes, we will obtain the temperat...

Q: stion 7 A sample of gas has a mass of 0.486 grams. What is the molar mass of the gas if it occupies ...

A: This problem is based on gas law and mole concept. Data given :  Mass of the gas given = 0.486 g. Vo...

Q: A certain polyatomic gas stored at a 160-L rigid tank and 16 atm is heated at constant volume from 3...

A: Given: Gas is polyatomic Constant volume = 160 L Temperature changes = 35 C to 55 C Determine change...

Q: Example 4.z If 10 g of N, reacts with 10 g of H, and NH, is formed in the reactor, (a) which species...

A: given Details: Mass of N2=10 g Mass of H2=10 g molar mass of N2=28 g/mol molar mass of H2=2 g/mol th...

Q: A building has to be maintaind at 21 C (dry bulb) and 50% relative humidity when the outside conditi...

A:

Q: Let’s assume that the reaction, which in this case happens to be an elementary reaction, A → B + C o...

A: Given reaction is- A →B+ C Rate constant, k=0.1 sec-1 Initial concentration = CA0 Final concentratio...

Q: Sugarcane is produced by dissolving the sugar in the sugarcane in water, filtering the solution, hea...

A: The solubility chart is constructed from given data. The material balance of water of the total syst...

Q: Q1: Air at 1.02 bar and 22°C initially occupying a cylinder of 0.015m3, is compressed reversibly and...

A: Given: Initial  pressure  p1=1.02 bar Initial temperature T1=22+23.15=295 K Initial volume V1=0.015 ...

Q: The feed to a reactors contains 100kmol C,H4 and 100kmol 02. a) which is limiting reactant? C2H4 b) ...

A: Given that, 2C2H4 + O2 → 2C2H4O The number of moles of C2H4 in the feed nC2H4,F = 100 kmol The numbe...

Q: Sugarcane is produced by dissolving the sugar in the sugarcane in water, filtering the solution, hea...

A: Given: The ratio of sugar to water in feed is 1:3. Basis: 25 kg sugar and 75 kg of water entering th...

Q: Laboratory works were carried out to measure the composition of vapor and liquid of chloroform (1) a...

A:

Q: Determine the elongation of the square hollow bar when it is subjected to the axial force P3 100 kN....

A: Given, P = 100kN, A =0.052-0.042=0.9×10-3 m2 σ1=PA=100×10000.9×10-3=111.11 MPa From the stress–strai...

Q: Saturated steam at 2.6 kgf/cm2 flows through a steel pipe in the NPS 8” - sch 40 standard. The pipe ...

A: Given: The outer diameter of the NPS 8" Schedule 40 pipe is 2.2 mm, thus, its radius would be rp = 1...

Q: Starting with Sulfur powder as raw material, give a flowsheet for production of sulfuric acid deploy...

A: Sulfuric acid boiling point 340C so sulfuric acid is in liquid state. Sulfuric acid is widely used i...

Q: Consider two closed systems A and B. System A contains 2000KJ of thermal energy at 20°C whereas syst...

A: Here , two closed systems are there. A and B .

Q: The irreversible reaction, A + B → C, in liquid phase is carried out in a non-isothermal 200 L batch...

A:

Q: Please explain What is Reversible Adiabatic Compression?

A:

Q: QUESTION 4 a) List two (2) types of nucleophilic substitution reaction for alkyl halide. b) State th...

A:

Q: 04: True or False (10 Mark) 1. Solid waste comprises all the waste arising from human and animal act...

A: As Per Bartleby multiple sub-parts or True/false question Guidelines, we are supposed to answer only...

Q: A) For the following control system below, is it under damping ? if yes, rmine the (Mp, tr, tp, ts)....

A: