PLease explain each Vairable/value and tell me what they mean or represent, no need to tell the constants only non constants please

Q: If we can hear sounds whose amplitude goes from 1 to 1 million in steps of one. With how many bits c...

A: As per our guidelines we are supposed to answer only first question. Kindly repost the other questio...

Q: Given an analog filter Ha(s) = designed from H«(s) by many-one mapping method, assuming sampling per...

A:

Q: Refer to the voltage divider circuit shown in Fig. 9-3. The source voltage is 100Vde and the ammeter...

A:

Q: If the cross sectional area of the conductor increases, then the resistance of the conductor A5 From...

A:

Q: Determine Vhf in the circuit in polar form. Write the angle only in four decimal places. 80260°V 3+j...

A:

Q: If the thickness of the insulating material in the problem with code COFFEE is increased by 30%, wha...

A: Insulation of wire is required to insulate the wire when it is in operating condition. It is essenti...

Q: 4. Petroleum industry includes %3D upstream" which includes all the following processes except .... ...

A:

Q: Given the state diagram below, derive the state equation using J-K F/F 0/0 1/0 1/0 00 01 1/1 0/0 1/0...

A:

Q: R3 R2 R1 R5 R4 Rg R6 R7 b

A:

Q: silicon Zener diode

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is revers...

Q: 2. The electric power which a transmission line can transmit is proportional to the product of its d...

A:

Q: Question 2: Wny does the phase difference between la (main winding current) and ly (auxilary winding...

A: Since you have posted multiple different question. we will solve the first question for you. To get ...

Q: R1 L1 mi 12mH 30 R2 420 V1 250Vrms 60HZ 0° L2 70MH e SOURCE-> +,

A:

Q: ketch the transfer curve for a p -channel device with IDSS = 4 mA and VP = 3 Vsfer curve for a p -ch...

A: It is given that: IDSS=4 mAVP=3 V  

Q: The op amp shown in FigureP13.15 is ideal, except that the extreme output voltages that it can produ...

A: This question belongs to analog electronics . It is based on the concept of virtual ground in ideal ...

Q: an FM broadcast transmitter, the carrier signal is being deviated between 103.505MHz and 103.495MHz,...

A: We need to analyse the given frequency modulation signal .

Q: A polarity test is performed upon a 7,620/230-Volt transformer. If the input voltage is 220 Volts, ...

A: In the given question, we have a transformer having the voltages as; Primary voltage, VP=7620V Secon...

Q: A single phase line has an impedance of 0.4+j2.7 ohms. The line feeds two -single phase loads that a...

A:

Q: 52 E, 48V R1 R2 20 2 10 2

A: In the given circuit 10Ω and 20Ω are in parallel and their equivalent is given as: R12=10×2010+20=6....

Q: 5. Consider the transfer function given by: 66 G(s) (s² + 6s + 66) Find the peak overshoot of the sy...

A: We are authorized to answer only 1 question at a time since you have not mentioned which qoestion yo...

Q: Problem #2) In circuit below, a 0.2um technology NMOS is used for which tox-2nm, un-350 cm?/V's, Vro...

A:

Q: A 50 cycle alternating current has a maximum instantaneous value of 42.42 amp. It crosses the zero a...

A: We need to find out expression for given current and time for given value of current

Q: With suitable illustrations explain the principle of operation and working of Moving Iron instrument...

A: Moving iron instruments In moving iron instruments, deflecting torque is proportional to the square ...

Q: The Frequency response of an LTI system is H(w) = The impulse response of the 1+w2" system is h(t). ...

A:

Q: A7 In Solar power generation, sunlight is converted to direct current using cells

A: The solution is given below 

Q: In The Potentiometer Experiment: In order to achieve high accuracy, the slide wire of a potentiomete...

A: Generally the slide wire of a potentiometer should be as long as possible ,  in order to have the hi...

Q: (For Nos. 1 and 2): For the circuit shown below, assume all charges and currents are zero at t=0. L=...

A: In this question,  Find the current in the resistance R1 using the Laplace transform.  Find the curr...

Q: Problem 3: Kyp Typ X1 X2 Кур Kịp Tip 1 Tip Typ

A: The given vehicle speed control example block diagram is shown below:

Q: What is the mass of an electron?

A: Mass of an electron.   

Q: The time period of a sine wave is 0.05 seconds. The frequency of the sine wave is а. 20 Hz O b. 40 H...

A: Frequency and time period has inverse relationship F= 1/T  In Hz Where F= frequency in Hz T= Time pe...

Q: Z^2 = 21 - 20j, What are the possible values of Z in rectangular form?    +/- ( 5 + 2j)   +/- ( 3 + ...

A:

Q: Design a combinational circuit with three inputs, x , y , and z , and three outputs, A, B , and C . ...

A: Given, Inputs are x,y and z. Outputs are A,B and C. When the binary input is 0, 1, 2, or 3, the bina...

Q: Figure below shows a 4-bit digital-to-analogue converter of type R-2R ladder. Given the converter ha...

A: In a 4 bit digital to analog converter like above we can firstly find the equivalent source voltage ...

Q: Question # 01: Apply the knowledge gained from the ac analysis of BJT to construct the AC equivalent...

A: Solve the first question, unless the student has asked for a specific question to be solved, subject...

Q: 12 V + 0.1 µF Si R2 56 k2 v. 2 V -12 V f = 1 kHz

A:

Q: Refer to the given circuit below. Determine the equivalent resistance across terminals a and b if R1...

A:

Q: al Calculate the currents of the branches and determine v1, v2. b/ Find the power of sources,

A:

Q: Label the terminals of the transformers in Figure 3 according to their proper polarity markings.  ...

A:

Q: 2. A pair of automotive headlamps is connected to a 12 V battery via the arrangement shown in figure...

A: Given circuit,

Q: Determine IR (in mA). Rs 220 2 IR Vz = 10 V Pz. 20 V VL = 400 mW Zmax 470 N.

A: This question belongs to analog electronics . It is based on the concept of zener diode as a voltage...

Q: = A cos (2*pi*T-2*pi*tau(t)) Find the value of Amplitude and Tau. Hint : Phasor addition ...

A:  The solution is given below 

Q: iii) Consider a system described by: ÿ + 3ỹ + 2ý = u Derive the state-space representation of the sy...

A:

Q: Q3) A (480/4800) V, 10 kVA transformer has a series equivalent impedance in per-unit as (0.0087+1 0....

A:

Q: I loved the film. It was fantastic

A: It is given that: I loved the film. It was________________.      

Q: For R1=R1=3 kΩkΩ, R2=R2=4 kΩkΩ, R3=R3=2 kΩkΩ, and a source E=E=219 VV, find the total resistance of ...

A:

Q: CONTROL SYSTEMS ACTIVITY ON FIRST ORDER SYSTEMS 400 1. Given the transfer function of a first order ...

A: We need to find out the time constant , rise time , settling time and we need to draw transient resp...

Q: 3) Switching Impulse (SI) Voltage used to test the withstand ofHV equipm against natural lightning: ...

A: Since two different questions are present, as per the guidelines, in the following section, only the...

Q: Show Work Here: R 1.5 Amp 2. Calculate the missing values for the circuit below: Show Work Here: Amp...

A:

Q: A two-branch parallel circuit has branch impedances Z= 2 – j5 ohms and Zz=1+j ohms. Determine the co...

A: The solution is given below 

Q: The figure shows a copper strip of width W = 19.1 cm that has been bent to form a shape that consist...

A: Answer is as follows-