Please round to the nearest One (i.e., 1). PLEASE DO NOT USE COMMA(S) ON YOUR ANSWER!! Moist unit weight of soil, gamma = 101 pcf Saturated unit weight of soil, gammaşat = 116 pcf Cohesion of soil, c = 0 psf The factor of safety, FS = 3 The internal friction angle of soil is 35 degrees B = 4 ft, Df = 6 ft, h = 5 ft A strip footing is shown below. Determine the followings: Unit weight of soil = y Qali Groundwater table Ysat 1. Ultimate bearing capacity, qu = psf 2. Allowable bearing capacity, qa = psf

Please round to the nearest One (i.e., 1). PLEASE DO NOT USE COMMA(S) ON YOUR ANSWER!! Moist unit weight of soil, gamma = 101 pcf Saturated unit weight of soil, gammaşat = 116 pcf Cohesion of soil, c = 0 psf The factor of safety, FS = 3 The internal friction angle of soil is 35 degrees B = 4 ft, Df = 6 ft, h = 5 ft A strip footing is shown below. Determine the followings: Unit weight of soil = y Qali Groundwater table Ysat 1. Ultimate bearing capacity, qu = psf 2. Allowable bearing capacity, qa = psf

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Calculate % Sand using the following values; a. Weight of soil= 50 gb. HR reading at 40 sec.= 25c. Temp at 40 sec= 25 oCd. HR at 2 hrs= 16e. Temp at 2 hrs= 26 oC
Q- What will be the time required (in minute) in falling the head from 45 cm to 30 cm in a variable head permeability test, if the coefficient of permeability of the soil is known to be 6.89 x 106 m/sec. The length and cross-sectional area of the soil sample is 60 cm and 210 cm² respectively. The area of stand pipe is 6.5 cm².
3. For a given soil show that a. G₁ √ sat Yw Wsat (Ysat - Yw)
5:43 a sinav.gelisim.edu.tr AA SOIL MECHANICS (CEN311) - Final Exam Select the correct statement. Uniformity coefficient does strength and stability affect A uniform soil has less strength and stability than a non-uniform soil 00 Uniformity coetficient of a poorly graded soil is more than that of a well graded soil A uniform soil has more strength and stability than a non-uniform soil Leave blank
A balloon type apparatus is sued to determine an in-place unit weight for a soil. The volume of the test hole determined by reading the water level graduations on the apparatus cylinder before and after digging the test hole is 0.000708 m3. The weight of the soil obtained from test hole is 1410 g. The soil sample was dries on a tield stone and weighs 1237 g. (a.) Compute the water content. (b.) Compute the in-place dry unit weight of the tested soil in kN/m3. (c.) Determine the percentage of compaction for the test result if the soil is part of a compacted earth fill whose maximum unit weight obtained from the laboratory compaction tests) is 18.57 kN/m3.
dys.mu MSKÜ-LMS 016 ŞB: 1 ÖRGÜN Soil Mechanics Mühendislik Fakültesi Mac Atterberg limits of a soil sample are given: LL:55% and PL:25%. Give the name of the soil typle considering the chart given below? Remember PI=LL-PL 60 U-line PI - 0.9 (LL -8) 50 Z 40 CH or OH A-line PI0.73 (LL - 20) 30 CL OH 20 or OL MH CL- ML 10 ML& OL 10 20 30 40 50 60 70 80 90 100 Liquid limit (%) O a. CL or OL O b. CH OR OH O c. OH or ML O d. GL or ML O e. M ail E AR .ill lenovo Plasticity index (%)
A balloon type apparatus is sued to determine an in-place unit weight for a soil. The volume of the test hole determined by reading the water level graduations on the apparatus cylinder before and after digging the test hole is 0.000708 m3. The weight of the soil obtained from test hole is 1410 g. The soil sample was dries on a tield stone and weighs 1237 g. (a.) Compute the water content (5 points). (b.) Compute the in-place dry unit weight of the tested soil in kN/m3. (5 points) (c.) Determine the percentage of compaction for the test result if the soil is part of a compacted earth fill whose maximum unit weight obtained from the laboratory compaction tests) is 18.57 kN/m3.
14 17 Example 5.9 For the setup shown, Find total head (h:), Elevation head (he) and Pressure head (hp) for the soil the setup shown. 5 m 5 m Datum H ... 5 m k, = 10k2 %3D Soil 1 Sol 2 A B D E 4 m 4 m 6 m 3 m
Problem The saturated soil specimen shown below has a permeability of 0.005 cm/sec, a porosity of 38%, and a cross-sectional area of 22 cm². Two standpipes are placed at points A and B as shown below. The specimen has reached a steady state condition after flushing it with water for 1 hr. Datum ttttt h₁ = 100 cm 50 cm L = 50 cm B 40 cm h₂ = 80 cm Determine: 1. 2. Elevation head (in cm) at points A and B. Pore water pressure (in kPa) at points A and B. 3. Discharge velocity (in cm/sec) through the sample. 4. 5. What is the quantity of flow through the sample in cm³/day? What is the magnitude of the seepage velocity (in cm/sec)? OUT
Q1 along points A,B,C,D 5m A 5m Soil A 5m Soil B 2m 3m 3m Datum I kA = 10 kg
i li. lIn. N 0:0A مطلوب For a soil sample brought from a site, the dry unit wight is 16.65 kN/m3 and its specific gravity is 2.65. If the water occupies 50% of :the volumn of voids. Calculate نقطتان )2( the water content of the sample is 15.20% 11.17% none 10.0% نقطتان )2( * the void ratio 0.592 0.952 none 0.659 نقطتان )2( * the total unit weight in kN/m3
Soil sample has a saturated unit wt. of 20kN/m3 and internal friction angle of 30°. Compute the slope angle for a factor of safety of 1.5. Use unit wt. of water as 9.81kN/m3.