Please send the answer by typing only. I don't want handwritten.  The subject is ( Electronic Circuits ) Q8) Why is FET preferred as a Buffer Amplifier?

Q: Question Completion Status: QUESTION 11 What is the number of signal levels required to achieve a…

A:

Q: List basic elements of a digital control system and show the block diagram representation of such a…

A:

Q: 6. Describe the operation of an OTE instruction.

A: OTE :  This is a instruction which is used in the PLC .       PLC : Programmable Logic Controllers.

Q: the question is "if we need to send an ECG data. determine a minimum and maximum data rate require…

A: In modern times, data or information is usually sent via digital format. The digital format is…

Q: 2. With neat diagram explain the construction and working principle of Encoder.

A:

Q: 8 Draw the block diagram of a Phase Locked Loop used as an Integer N frequency synthesizer. If the…

A: PLL:  It's full form is Phase Locked Loop It is one of the vital blocks in linear systems.  It is…

Q: Q8/Chose the correct data input for 2-1 multiplexer that used to Design the switching network F F(A,…

A: SOLUTION  GIVEN-->        F(A,B,C,D,E)=∑(0,1,3,5,8,9,12,15,17,21,24…

Q: Home Work If the enable pulse frequency in Figure below were halved, determine the binary numbers…

A: Given waveform: To find: If the enable pulses frequency was halved, determine the binary numbers…

Q: Q2] A digitizing system specifies 55 dB of dynamic range. Howmany bit rate required to satisfy the…

A: Dynamic range  Dynamic range = 20 log102n55 = 20 log102n= 2.752n=562.341n≅10

Q: Based on example related on relay + switch as shown during lecture session, state the configuration…

A:

Q: The subject is Digital System Please send the answer by typing ONLY. I don't want any handwritten.…

A: In this question we will write applications of encoder and decoder circuits...

Q: Draw the circuit and explain the operation of electronic PID controller using operational amplifier

A:

Q: Assuming a stable system. What type is the system? Assuming that the amplitude of the input is…

A: In this question,  We need to check the type of the system? In the second part, Assuming that the…

Q: hat is the possible disturbance of the PID Controlled automatic water heater?

A: PID controller: PID controller as the name suggests it is the combination of all the controller…

Q: What is associate and Direct mapping of Cache.

A: Cache is faster SRAM memory closer to processor. ROM has read operation only no write operation. RAM…

Q: What is counter? What is its purpose? Design an asynchronous counter that counts from 0 to 32 ?

A: In this question we will write about counter and it's purposes.. Note:- due to bartleby policy, I am…

Q: Include memory elements and combinational circuit Integrated circuit O Sequential network…

A: Given: Combinational circuit

Q: Write an 8088/8086 assembly program that counts the length of a null terminated string that starts…

A: Microprocessor Programming : The "jargon" of directions which a specific microchip chip has is…

Q: Give the value of the 8088 reset vector

A: The RESET input of the 8088 microprocessors provides a hardware means for initializing the…

Q: What is differential PSK?

A: Differential PSK

Q: What is the minimum necessary speed?         Six computer workstations are connected to a…

A: Multiplexing is a process or sending multiple signal over a single data channel. Time Division…

Q: 3 (a) A PCM system uses an uniform quantizer followed by a 7-bit binary encoder. The bi rate of the…

A: 3. (a) It is given that: No. of bits=n=7Bit rate=50 Mbps

Q: What is it important to use a three-state buffer?

A:

Q: Q8/Chose the correct data input for 2-1 multiplexer that used to Design the switching network F F(A,…

A:

Q: 1) a) What is the difference between run-time and settling time? B) Define overshoot in response of…

A:

Q: Identify the type of signal processor element? a. Variable manipulation b. Variable controlling c.…

A:

Q: Which pins are used to control the generation of the READY signal in 8284?

A: 8284 is a clock generator comes under the category of IC which is produced by Intel to give the…

Q: Investigate as a test of a page, the problems that would arise when implementing the kinematics…

A: By incorporating the notions of nonintegral order derivatives and integrals, fractional-order…

Q: 2. With neat diagram explain the construction and working principle of Encoder

A: Fig: Diagram of encoder

Q: compute the voltage labeled ??

A: It is given that:

Q: Determine the Memory, Causality and Stability properties of the syste

A:

Q: How to measure the quality of the output signal in ADC? A. Signal-to-noise ratio B. Quantization…

A: The Signal to quantization noise ratio reflects the relationship between the maximum nominal signal…

Q: . Write the difference between the MOSFET and IGBT?

A: IGBT MOSFET Stands for Insulated Gate Bipolar Transistor Stands for Metal Oxide Semiconductor…

Q: 2- Discuss the advantages and disadvantages of the counter-type ADC. 3- Is the conversion time of…

A: Question 2 Advantages of counter-type ADC:   (1) It is a one-bit quantizer. (2) In counter-type ADC…

Q: Derive the output SNR of AM envelop detector. Also calculate its figure of merit.

A: Let Si, So be the input and output of signal power. And  Let Ni,No be the input and output of noise…

Q: What Is Electronic Data Interchange (EDI)—Pioneering External?

A: ELECTRONIC DATA INTERCHANGE (EDI): The desktop-to-desktop or computer to computer interchange of…

Q: 4- If the input signal is 100KHZ, can we make sampling for this signal when it applied to the analog…

A: It is given that input signal is of frequency of 100 KHz and needs to be fed to analog pin of…

Q: Q 2(a) Give three classifications of stability and give an example of each type. Q 2(b) How is…

A: Given :   Here in the question they want to know the classification of the stability of a system.…

Q: Advantages and Disadvantages of LQG control ?

A:

Q: a) Sketch a generic HR diagram, including labels for the

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Explain the Analog to digital conversion in digital signal processing with each step elaborated

A: There are three main things involved in ADC conversion process. First sampled the signal and then…

Q: Explain what are Encoder sensors and how does it work

A: Encoder sensors -  Encoder sensors are a form of mechanical motion sensor that converts a motion…

Q: Assume that you have an 8-bit ADC with Vref = 5 Volts. If the input voltage is 3.5 Volts, what is…

A:

Q: Discuss the method and process in digital communication that said  Analog information sources can be…

A: According to the question we have to discuss the method and process in digital communication that…

Q: A system with motor is using an absolute position encoder with the last reading of 10011011. If it…

A: According to the question,

Q: What is Grey Coding?

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Q8/Chose the correct data input for 2-1 multiplexer that used to Design the switching network F F(A,…

A: Please comment if you need any clarification. If you find my answer useful please put thumbs up.…

Q: Q1.A) If an 8-bit SAR ADC is used to digitize 8V full scale signal, what will be the digital o/p for…

A: Number of bits n = 8 Analog input is given Vin=5.76 v Reference signal is given, Vref=8 V