point D(-4, 5,3) and A ya, + (x + z)z äy, express the D and A in: %3D

Q: 3. Three loads A, B and C are connected in series to a 110-volt source. Load B takes 1100W, load C t...

A:

Q: 5. Draw a circuit that will produce a total resistance of 10 ohms using ten 10-ohm resistors.

A:

Q: A D.C motor has a speed of (900 r.p.m) when connected to a (460 V) supply. Find the approximate valu...

A:

Q: Given the point D(−4, 5, 3) and A = yax + (x + z)z ay, express the D and A in Spherical Coordinate S...

A:

Q: Find the following a) RT b) IT 10Ω 10Ω 12 V 8Ω

A:

Q: Q6 A 250 V shunt motor on no-load runs at 1000 r.p.m. and takes 5 A. the total armature and shunt fi...

A: Note: We are authorized to answer the first question since the exact one wasn’t specified. Please su...

Q: (b) Design a proportional integral derivative (PID) controller for the following function shown in F...

A: The Proportional-Integral-Derivative Controller or PID controller is a electronic device which is us...

Q: What is fc for the filter in the below circuit? R= 106 Q, C = 14 µF, and Vin = 8 V The result should...

A:

Q: The region in which 4 <r< 5, 0< 0 < 35°, 0.6m < Ø< 1.2n contains the volume charge density of p, = 1...

A: The solution is given below 

Q: Determine ID (in mA) for the network. + 8 V 1.2 k2 4.7 k2 Si -6 V

A:

Q: Question 2 The circuit shown in Fig. 1 is a multistage operational amplifier. Given output voltage V...

A:

Q: Three single phase transformer are balanced delta delta each rated 120 kVA supplying a 3 phase load ...

A: The transformer has a primary and a secondary side. It converts electrical power to electrical power...

Q: Three 20 ohms non inductive resistors are connected in star across a three phase supply, the line cu...

A: Star connection Phase current equal to line currents  Phase voltage is 0.577 time line voltage  De...

Q: Three similar choke coils are connected in star to a 3 phase supply. If the line current are 15 A, t...

A:

Q: linear, lumped-parameter electrical RLC is shown in Figure Q1a below. Let C = 1F, R = 22, L = 1H. Ze...

A: We need to find transfer function for given circuit

Q: Two identical devices are connected in the circuit shown in Fig.1. Note the configuration of A and B...

A: We have to find the D element values and then solve the given circuit to find power delivered by dep...

Q: equal to the power taken by the 4-ohm resistor. 2. A 20-ohm resistance is connected in parallel with...

A: The solution is given below

Q: i need the answer quickly

A:

Q: A single phase transformer is rat 2,424 V / 206 V. 60 Hz The eau

A:

Q: Q3 A 4-pole, 500 V shunt motor has 720 wave-connected conductors in the armature.The full-load armat...

A: NOTE: As per our company guidelines we are supposed to answer only one question. Kindly repost other...

Q: Q6. A 4-pole wave-wound armature rotating at 400 rpm is required to generate 300 V. The effective fl...

A: Given, Number of pole, P = 4 Rotating speed, N = 400 rpm Wave wound, so number of parallel path, A =...

Q: In which mode will a diode generally not conduct electricity? a. Bidirectional Biased b. None of t...

A: Diode is two terminals passive semiconductor device  Two sides are known as p and n side 

Q: Q10 A 240 v, 4-pole shunt motor running at 1000 r.p.m. gives 15 h.p. with an armature current of 50 ...

A:

Q: 5. Determine whether the points of equilibrium P, and P, in Fig. 2.21(a) and Pg and P, in Fig. 2.21(...

A: Stability means that when ever there is small disturbance drive trys to come to equilibrium point

Q: Use cascading to design a Butterworth active low pass filter with the following specifications: Amax...

A: According to the question, we need to design, Butterworth active low pass filter for the given speci...

Q: ea'anced three-phase sys:..n has a distribution wire witi impedance 2+ jó per phase. system supplies...

A: It is given that: Distributor wire impedance=2+j6 ΩFor Y connected-load:S1=400 KVAcosϕ1=0.8 laggingF...

Q: For an op-amp having a slew rate of SR = 4 V/us, what is the maximum closed-loop voltage gain that c...

A:

Q: Exercise: A second-order system is underdamped with a damping ratio of 0.4 and a natural frequency o...

A:

Q: A three phase bank of three 75-kVA single phase transfogmers steps the three-phase primary feeder vo...

A: Three-Phase System: The three-phase system is a cost-effective means to transmit large amounts of po...

Q: 2. A conductor 150 cm long carries current of 20 A and produced a flux density of 0.05 T. Find the p...

A: We need to find out the power for given circuit.

Q: Selve tie chfferstiat egartier by luplace troms f リーフ=シツ)=!, fio) =t 24 Sulve ジナジ+7ソ=e 9(0) = 0-16, ...

A:

Q: me Corrent i(t) for figures belowpassume endition are Zero. Ccoos ñ UCt-[ 78 sint o <tST

A:

Q: 240 k2 10 k2 V; (0.02 V, w = 300 x 103) -Vo +

A: We need to find out maximum frequency that can be used .

Q: ) Consider the voltage of a baseband signal varies over the range-1V to 9V. This signal is sampled a...

A: Please find the detailed solution in below images

Q: Which of the following devices can decrease the power dissipated across a transmission line to minim...

A: Transmission line: This is made of the conductors used to transfer the electric power from one subst...

Q: FIND THE THEVENIN'S EQUIVALENT CIRCUIT OF THE NETWORK BELOW. 42 15/0 A 151,

A:

Q: 3. For the power amplifier circuit in Figure A: a) Calculate the power input and power output if the...

A: A power amplifier (PA) is a device that transforms a low-power signal into a higher-power signal. Au...

Q: 44-45) Using the circuit below: IR R 220 2 Iz Vz= 20 V IZM = 60 mA V; RL1.2 kQ VL 44) Determine the ...

A:

Q: A Phase modulator has a carrier signal of ec = √34 cos 2pi(735x103)t and a phase deviation constant ...

A: According to the question, we need to calculate the amplitude of the message signal.

Q: Find the coefficient of coupling

A:

Q: 1) Explain the concept of positive and negative feedback And derive the formula of closed loop volta...

A: Feedback can either be negative or positive. In negative feedback, a portion of output signal is sub...

Q: Q4 A 440 V shunt motor has armature resistance of 0.8 S2 and field resistance of 200 2. Determine th...

A: as per our guidelines we are supposed to answer?️ only one question. Kindly repost other questions a...

Q: 4)-What is HRC Fuse : Working & Its Applications. please answer not by hand

A: HRC Fuse: High rupturing capacity fuse or HRC fuse are fuses that carry a short circuit current for ...

Q: SOLVE THE FOLLOWING PROBLEMS COMPLETELY The series combination of a 4-ohm resistor and a variable r...

A:

Q: If a JFET has IDSS = 10 mA and VP = 2 V, then RDS  equals

A: The solution is given below

Q: ) Show the truth table of 2 X 4 line decoder and draw its logic diagram with all outputs as a Boolea...

A: According to bartleby question answer rule I have to solve one question only because both different ...

Q: 9A 100 h.p.. 500 v shunt motor ha

A:

Q: Find the channel bandwidth requiring transmission a TDM binary signal consisting of 24 voice signals...

A: In below solution there are two answers. i) with inter symbol interference (ISI) in which channel ba...

Q: How many address lines are required for a 512G x 64 ROM chip

A: Address line: This is used to send or transfer the address of either memory or I/O device from the p...

Q: In a 400 V, 50 c/s transformer, the total iron loss is 2500 W. When the supplied p.d. is 220 V at 25...

A:

Magnetic Moment

The magnetic moment is defined as the alignment of a magnet and its strength when the magnet is creating a magnetic field. There are number of examples of the magnetic moment, few are a current carrying conductor in the form of coil, elements at microscopic levels like electrons and many more.