PRACTICE PROBLEM 11.3 8/45° V 392 www |1Ω In the circuit of Fig. 11.4, calculate the average power absorbed by the resistor and inductor. Find the average power supplied by the voltage source. Answer: 9.6 W, 0 W, 9.6 W.

PRACTICE PROBLEM 11.3 8/45° V 392 www |1Ω In the circuit of Fig. 11.4, calculate the average power absorbed by the resistor and inductor. Find the average power supplied by the voltage source. Answer: 9.6 W, 0 W, 9.6 W.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A filter with a positive phase shift is non-causal, i.e. it looks into the future. This is not…

A: The filter in an electronic circuit is used to remove the undesired part of the frequency band from…

Q: Explain the principles of servomotors and discuss their different types. Support your answer using a…

Q: 9. Which of the following is correct about the power consumed by R₁ and R₂ connected in series if…

A: The solution is provided in the following section.

Q: Q.8 Current through 2 Ω resistor in the network shown is: SV (+ ΤΩ ΤΩ www www 1.Q ΙΩ Μ ΖΩ

A: Given data, Circuit diagram is given as,

Q: 3. In the given circuit, the switch is closed for a long time. At t=0, the switch is opened. Find…

Q: find the time domain solution of state equation TOSTI 2 * - [ - 2 - ³ ] x + [ ² ] e ²² X -2-5 ;…

A: Given: State space equations along with input. We have to find out state transition matrix, state…

Q: 1. Determine i(t) in the given circuit, the switch had been open for a long time and then closed at…

Q: 3) Draw the schematics of a HVDC and of a HVDC light, compare the systems evidencing advantages and…

A: HVDC means high voltage direct current is a method of electrical power transmission which uses…

Q: Find the probability that a closed path will exist between terminals A and B.

A: Given:

Q: Question 2 a) Ali has bought stopwatch but it able to count the timing from 1s until 13 s only.…

A: 2a) Given, Sequence of counting for stop watch is 1s to 13s only. Counter design using JK…

Q: H.W Ans & >15 Find Ver? R ਪ੍ਰਤੀ Love 8

Q: onducting bar of length moves to the right at a constant speed v on two frictionless rails in a…

A: The given diagram is shown below: When the conducting rod moves on the rail, the magnetic field of…

Q: When a pentavalent impurity is added to a pure semiconductor, it becomes.

A: The correct option along with the explanation is provided in the following section.

Q: Use K-map to obtain the minimized sum of products form of the function f (x,y,z,w) = SEGMA…

Q: A low pass filter is a. Passes the frequencies lower than the specified cut off frequency b. Rejects…

A: The solution is provided in the following section.

Q: estion 4, Given the equation below: i. Show the simplified Boolean equation below by using the K-Map…

Q: If the Zener diode in the figure has a knee voltage of 0.7 V and a Zener voltage of 3 V, find the…

Q: An analog video signal has maximum frequency of 6 MHz. We want to send this analog video signal in…

A: Given an analog video signal has, Maximum frequency, fm=6 MHz Required data rate, Rb=216 Mbps

Q: Fig. 1 shows a resistive circuit with one DC voltage source and one DC current source. Apply…

A: Given: To determine the current I1 using superposition.

Q: Which of the following elements of electrical engineering cannot be analyzed using Ohm's law? a)…

A: This question belongs to circuit theory . It is based on the concept of ohm's law. Have a look at…

Q: In the circuit below, what is the reading of the voltmeter (round off to the nearest whole number)?…

Q: c) Calculate the required capacitor value for a frequency of 550k H z and find its time period. The…

A: Given:

Q: In (Figure 1) suppose that V, 37 V and R = 152. Figure 502 ww 70 4₁ ΤΩ ww V₂ www R i₂ 1 of 1 3ი ▼…

A: Given, Vs=37 VR=15 Ω

Q: Pr 10 V, 1.52 16V, 152 MA 12.52 8V, 1.0 B 3. 12V, 1A+

A: Given data, Circuit diagram is given as,

Q: . Two wires A and B are both made of the same conductor material. The length of wire A is three…

Q: 6. Determine the power factor of a RLC series circuit with R=5ohm, X₁=8ohm and Xc=12ohm.

A: Given data, R= 5 Ω, XL=8 Ω, Xc=12 Ω

Q: Using nodal analysis, find V₁ and V₂ when R₁ – 20 Ω. 2 Ω ww 10 ΩΣ V₁ w R1 6 Α 4ΩΣ V₂ 13 A

A: Given, R1=20 Ω

Q: No energy is stored in the circuit at the time that the switch is closed. a. Find Vo(s). b. Use the…

Q: Convolve the x(n) with h(n) * x(n) * and h(n) are given by, x(n) = (1, 2, 3) h(n) = (1, 2, 1)

Q: In pulse amplitude modulation, ■. Amplitude of the pulse train is varied . Width of the pulse train…

A: The solution along with the explanation is provided in the following section.

Q: A 330 kV power system contains three substations A, B and C having fault levels of 20 GVA each. The…

A: Given data, Voltage V= 330 kV Power P=20 GVA =20×103 kVA Given circuit,

Q: A3-phase, 220 KV, 50 Hz transmission line consists of 1.2 cm radius conductors spaced 2m at The…

Q: 5. From the figure, calculate the average voltage. V 10 -10 5 сл 10 ω!

Q: Find the inverse z-transform of, 1 X(z) = 1-1.52¹ +0.52-2 ROC : [2] > 1.

Q: 6. Explain following with examples and diagrams. a. Load curve b. Plant capacity factor c. Mean time…

Q: What is universal charge? How does missionary electrification conducted and where does its budget…

A: Electricity is an basic form of energy. The electricity is produced by conversion of the primary…

Q: In the figure, q = 5.00 nC. What is the electric potential at x = 10 cm? 9 y O 45 V O 450 V 4500 V O…

A: Given that Charge q= 5 nC Distance, x=10 cm Calculate electric potential, V=?

Q: 2. Using Thevenin's theorem and Norton's theorem, find the current I, through the 202 resistor in…

Q: 1. Two resistors, each of magnitude R1 = 100Ω and R2 = 200Ω If the two resistors are connected to a…

Q: Determine whether the following assumptions are correct, and briefly support your answer based on…

A: The given circuit is as shown below with labeled diode current directions.

Q: Find V, and the power absorbed by the dependent source in the given circuit. Assume / = 21 A. 1092…

A: Given circuit:

Q: The Nodal method of circuit analysis is based on A KVL and Ohm's law B KCL and Ohm's law C KCL and…

Q: 2. Simplify the block diagram below. R(s) S²-45+4 S-2 S³ apples S+2 S²+45+4+ S²-4 C(s)

A: Given: Consider the following system: To find: Simplify the block diagram.

Q: B(jo) Determine gain margin and phase margin of the system shown above if the loop gain magnitude…

A: Given: 0

Q: A DAC has a 10v range and 8 bits of resolution. What is the step size?

A: Given: A DAC has Voltage range, Vrange=10 V Number of bits, n=8

Q: Refer to attached schematic diagram. Solve for Total Resistance, REQ If a supply voltage of 10 V is…

Q: The figure shows the electric field of a dipole. At what point is the electric potential zero? OA OB…

A: The electric potential due to an electric dipole is zero at every point on the equatorial line of…

Q: A balanced Y-connected load absorbs in total 3 kW at a power factor of 0.6 lagging. If the line…

A: Given: A balance Y-connected load has PL=3 kWcosθ=0.6VL=500 V

Q: V₂= ↓↓ 2 Ω ww 2 A 2 Ω + V X 402 ww 0.5V 18 V + Utilizing a matrix and making the necessary…

Q: 1. Positive clipper with positive bias 2. Positive clipper with negative bias 3. Positive clamper…

A: Positive clipper with positive bias : A Clipper circuit in which the diode is attached in series to…

Question

PRACTICE PROBLEM 11.3
8/45° V
392
www
jlQ
In the circuit of Fig. 11.4, calculate the average power absorbed by the
resistor and inductor. Find the average power supplied by the voltage
source.
Answer: 9.6 W, 0 W, 9.6 W.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

NEED ASAP please solve this problem,Maximum Average Power Transfer. Please show full and complete solution Note: Answer from the book for Pmax is lower than 50W
11. A 45 – microfarad is connected to a 118 – volt 60 – cycle source. Calculate (a) thecapacitive reactance, (b) the current, (c) the maximum power delivered to thecapacitor or returned to the source, (d) the average power. Write equations for (e) thecurrent and (f) the power.
A generator is supplying a load of 700 kW at a power factor of 0.9 lagging. If the power factor is raised to unity, how many more kilowatts can alternator supply for the same kVA loading?
It is desired to correct the 2,400-kVa 0.65 lagging power factor load in a plantto unity by the installation of a synchronous condenser. Calculate the kilovoltampere rating of the latter. Ans.: 1824 kVA
11. A 45 – microfarad is connected to a 118 – volt 60 – cycle source. Calculate (a) the capacitive reactance, (b) the current, (c) the maximum power delivered to thecapacitor or returned to the source, (d) the average power. Write equations for (e) thecurrent and (f) the power.
An industrial load uses 310-kVA at 0.6 pf lagging. A synchronous motor is added to the system to improve the power factor. The power required by the synchronous motor is 31-kW. (i)What is the complex power required by the load (P + jQ)[kVA] If the motor is added to the load to bring the power factor up to 0.9 pf lagging, then: (ii)What is the complex power now required by the load (at the new pf) (P+ jQ)[kVA] (iii)This means that the motor has a reactive power of (-Qm)[kVAR] and is operating at: (iv) a power factor of:
Two alternators operating in parallel supply the following loads: A = 400W, unity pf; B=1000kW, 0.707 pf lagging C = 600 kW, 0.9 leading pf. One machine supplies 800kW at 0.866 lagging power factor. What is the power factor of the other machine?
1. a) Find the average power, the reactive power, and the apparentpower supplied by the voltage source in the circuit if vg=40 cos 106t V.2. b) Check your answer in (a) by showing Pdev=ΣPabs.3. c) Check your answer in (a) by showing Qdev=ΣQabs.
A group of small appliances on a 60 Hz system requires 20 kva at 0.85 lagging power factor when operated at 120 Vrms. The impedance of the wire supplying the appliances is (0.01 + j0.08) Ω. The voltage at the load end of the wire is 125 Vrms. Determine: a) the power loss in the wire, b) the capacitor in microfarad needed to improve the power factor to unity.
It is desired to correct the 2,400-kVa 0.65 lagging power factor load in a plant to unity by the installation of a synchronous condenser. Calculate the kilovoltampere rating of the latter. Ans.: 1824 kVA show all necessities
An alternator is supplying a load of 300 kW at a power factor of 0.6 lagging. If the power factor is raised to unity, how many more kW can alternate supply ?
The three-phase average power rating of the central processing unit (CPU) on a mainframe digital computer is 20,000 W. The three-phase line supplying the computer has a line voltage rating of 144 V (rms). The line current is 88 A (rms). The computer absorbs magnetizing VARs. Calculate the total magnetizing reactive power (in VAR) absorbed by the CPU.