Prob. 1. Derive Vout/Vin if Vin is a sinusoidal function with a frequency of w, what is the cut-off frequency? 10 nF NC Vin Vo R1 10k R2 1k we

Q: write about: Band Stop Filter Characteristics  200 words do not write in handwritten and DO NOT…

A: As we know that a filter is used in system because they eliminate unwanted frequency from system…

Q: 1- Design a 4×1 Mux. Using enable Pin line at low active? 2- Design a 8x1 Mux. Using enable Pin line…

A: The multiplexer is used to convert n input into one output line. The number of select line is based…

Q: In a PWM, given that the duty cycle is 80% what is the voltage output?

A: Given, In a PWM, duty cycle  = 80%

Q: A current of 2A in the ay direction is in a filament parallel to the ay direction and passing…

A:

Q: In a PWM, what should be the duty cycle to get a voltage output of 4.5 V

A: It is given that: Output Voltage=Vout=4.5 V

Q: Obtain the timing diagram for the Master-Slave flip flop with appropriate assumptions for the…

A:

Q: H.W.3: Determine the h parameters for the circuit in Fig. FE 6Ω ww 10Ω

A: Types of parameters Z Parameters Y parameters ABCD parameters h parameters g parameters h…

Q: A double beam oscilloscope displays 2 sine waveforms A and B. The time/cm switch is on 100 us/cm and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: * The different between a triac and a diac is A diac has a t wo gate terminal, but a triac does not.…

A: For the given Questions we have to select correct option or identify the True or False condition,…

Q: Q: For the circuit shown in Fig(1) the switch has been closed for long time and opend at t=0, Find :…

A:

Q: (d) Derive an equation for the cutoff spatial frequency in the Modulation Transfer Function of a…

A:

Q: 2) The circuit below shows a circuit for a differential amplifier with an active load. Here Q1 and…

A:

Q: H.W.3: Determine the h parameters for the circuit in Fig. www 42 102

A:

Q: 3. Find the total resistance of this circuit. * R4 10 ko R1 R2 R3 15 ka 20 ka 25 ka • 16.383 ko •…

A:

Q: Design a common emitter amplifier for a Vout of+-6.3V. Vcc is set to 9V. At x=1, Av=12.6 V/V and the…

A: We need to design a common emitter amplifier for a Vout of ±6.3V and Av=12.6 V/V.  Also, Rout must…

Q: Q1: In a 3-phase, 4-wire system, the currents in R, Y and B lines under abnormal conditions of…

A:

Q: A MVA, 20 KV, three-phašė ģenēřātor has a subtransient reactance of 20%. The generator supplies a…

A: Solution- For generator, S = 300 MVA V = 20KV X = 20% For motor 1, S = 200 MVA V = 13.2 KV X= 20%…

Q: Design a single stage CE VDB amplifier with an open circuit voltage gain of 45 dB. Also, use 2N3904…

A: We need to design a single-stage CE amplifier with an open circuit voltage gain of 45 dB using a…

Q: 5.13. (a) If the energy band gaps for InP, InAs, and InSb are given by Eg = 1.34 (InP), 0.36 (InAs),…

A: The energy bandgap is the minimum energy necessary to move electrons from the valence band to the…

Q: 8.46 Find V, in the network in Fig. P8.46, if V; = 4 /0° V. 10 Vị 2n ww

A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per…

Q: What is the minimum sampling rate needed to sample the signal x(t) = 3 sin²(27(15)t)

A: Given, The signal is xt=3sin22π15t

Q: | The waveforms shown in figure (1) are the trigger and the output waveforms of a monostable…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 2.20 Use the Smith chart to find th accompanying figure: (a) The SWR on the line. (b) The reflection…

A:

Q: Q2: Using Z-transform propeties, determine X(z) and write ROC for each of the followings: a) x(n) =n…

A: As per our guidelines we are supposed to be answer the first  question only. Kindly repost the other…

Q: given magnetic vector potential A= 6*X^3*Y^2 ax+ 2*x*Y^4 ay +3*Z az find magnetic flux through the *…

A:

Q: (b) Given the function Z (A+B(C+D+ E)+FG.Using static combinational CMOS logic circuit technique,…

A:

Q: 6Ω i(t) t =0 45 V (+ 15 V all (+1

A:

Q: R. O, jaA 0:30A 402 202. R.

A: Please refer the attached images for the complete answer..

Q: In the ideal transformer circuit of Fig. 13.38, find V, and the complex power supplied by the…

A:

Q: entrade Schidu

A:

Q: Estimate the shape of magnitude response of H(z). Take b=0.5. 2) What is the type of system…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: Sketch the transfer characteristics of the device. Superimpose the network equation on the same…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 8 kN 5 kN 500 N 800 N 1200 2 300 03 200 0 18 V 6 kn 7 kn 27 V (a) (b) 50 Ω 90 Ω 80 N 35 N 10 Ω 3 15…

A:

Q: Convert 1010.011, to base 10 Convert 0.274110 to base 8 Convert AE3.2C16 to base 8 Convert 18610 to…

A:

Q: - Find the value of the base resistor that will cause the transistor saturation. 760 2 RE B = 250…

A:

Q: Given the bellow Arduino command: analogWrite( 8, 200); What is the duty cycle?             What…

A: analogWrite function will write an analog value to the pin mentioned inside the function. The first…

Q: Describe some of the factors that have contributed to the delays in undersea cable maintenance.

A: The underground cables play a major role in the internet flow in many of the country's.They are a…

Q: 8- Design equation F(A,B,C,D) =E(1,3,4,11,12,13,14,15) using a suitable Multiplexer?

A: It is given that: FA,B,C,D=∑1,3,4,11,12,13,14,15

Q: Find y[n]=x[n]*h[n] for all integer values of n x[n] 2 1 -2 -1 + 1 2 3 4 5 h[n] -2 -1 + 1 2 3 4 5 6…

A: We need to find out output for given input and impulse sequence .

Q: Find the current flowing through the 8 kn resistor. Find the current flowing through the 2kn and 4k2…

A:

Q: 8.50 If I, = 4 /0° A in the network in Fig. P8.50, find I,. w ww 12/0'V -1a

A:

Q: j30 -j22 5/90° V j42 2.

A:

Q: 5.01 102 10.V 15V 2.0V

A: Given data, Circuit diagram is given as,

Q: Q3/ Twenty-four voice signals are sampled uniformly and then have to be time division multiplexed.…

A: We need to find out bandwidth and sampling rate for given signal

Q: 8.45 If V, = 4 /0 V, find I, in Fig. PS.45. Figure P8 E

A:

Q: The open-circuit characteristic of a DC generator is also called as characteristics. O internal…

A: There are two types of characteristics of DC generator: No load saturation characteristics Internal…

Q: 3- What is the function of the digital circuit shown below? Describe its operation briefly and find…

A:

Q: the line x=0 y=0 0<x<10 m carries a current of 2A along z. Calculate H at the points (5,0,0)…

A:

Q: 6. Based on this chart, what material was used to manufacture a wire if its resistance is 4.46…

A: This question belongs to circuit theory . It is based on the concept of relation between resistance…

Q: impedance and output impedance and current gain. 12 Ohm Lfon)-6mA th. Vaston)-10V 10 UF 40kOhn TRORM…

A:

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.