Problem 1 ( show your solution ) The annual load of a substation is given by the following data (from January to December): 8 MW, 4 MW, 6MW, 2 MW, 6 MW, 12 MW, 16 MW, 14 MW, 10 MW, 4 MW, 6 MW, and 8 MW. Determine the average load

Problem 1 ( show your solution ) The annual load of a substation is given by the following data (from January to December): 8 MW, 4 MW, 6MW, 2 MW, 6 MW, 12 MW, 16 MW, 14 MW, 10 MW, 4 MW, 6 MW, and 8 MW. Determine the average load

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.15MCQ

See similar textbooks

Related questions

Q: Q1) For the circuit in fig.1 the section bus-bars A and B are linked by a bus-bar reactor rated at…

Q: 1. A resistor, in series with a 138-microfarad capacitor, is connected to a 60-cycle source. If the…

A: (A): The current through the circuit is: I=VXCI=11512π*60*138*10-6I=5.97A (B): The power across…

Q: (b) A wattmeter is designed to give a full scale deflection with a current coil (ic) and voltage…

Q: 6. A string of four suspension insulators is connected across a 285 kV line. The self-capacitance of…

Q: 1. Thyristor-Controlled Series Capacitor (TCSC) for power factor improvement 2. What are the…

Q: The electrical power supply system of a particular country is made of the following. Draw a single…

A: Draw and represent the symbol used in the single line diagram.

Q: Q 5. Three equal impedances, each consisting of R and L in series, are connected in star and are…

A: Given supply line voltage is 400V. Supply frequency is 50 Hz. The power to the load is measured…

Q: Pressure Coil of wattmeter should be connected in series with the Line Select one: O True False

A: According to the question we have to discuss about the pressure coil of wattmeter.

Q: A small installation consists of the following loads connected in parallel across a single-phase…

A: When the devices are connected in parallel, the potential difference across all the elements is…

Q: Each line of a 3-phase system is suspended by a string of 3 similar insulators. Find the string…

Q: A single phase a.c. distributor AB 300 meters long is fed from end A and is loaded as under :(i) 100…

Q: Given the following wye-connected resistances: Ra = 11 Ω, Rb = 4 Ω, and Rc = 11 Ω, calculate the…

Q: A single phase a.c. distributor AB 300 meters long is fed from end A and is loaded as under :(i) 100…

A: Since distribution lines are very near to the consumer, it is important to calculate voltage drop in…

Q: Example 8.3. Each line of a 3-phase system is suspended by a string of 3 similar insulators. If he…

A: The solution can be achieved as follows.

Q: Electric Machine-check image, all question there. Consider the above equivalent circuit of IM. A…

A: Given Data: R1=0.294Ω , R2=0.144 Ω, X1=0.203 Ω, X2=0.409 Ω, 2Xm=10.25 Ω

Q: Solve the following problems and include your complete solution. A. A wattmeter with its current…

A: Wattmeter is a device it monitor the power consumption and manage the energy saving. it is commonly…

Q: (ii) A string of suspension insulators consists of three units if the voltage across the line unit…

Q: a 3 units suspension insulator, the voltage across the top and middle units are 30% and 32%…

A: Total voltage= sum of Voltage across the units. Using KCL we will find capacitance ratio. String…

Q: The example of a nearly equivalent uniformly distributed load on feeder is domestic load on a 3-…

A: uniformly distributed loads mean a large number of loads of the same wattage connected to the…

Q: Four industrial centers are located at the corners of a square of 26 km side. The loads are 4000 kW,…

A: The industrial centers are located at the corners of the given square. The best location of the…

Q: Problem solving 1. A building has 21 housing units. Each housing unit has the following circuit…

A: Electrical demand factor can be explained as the Maximum demand of system divided by total connected…

Q: Consider a house that has a 120V mains with mains frequency of 60hz and a service current of 100A,…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 6. A string of four suspension insulators is connected across a 285 kV line. The self-capacitance of…

A: The solution can be achieved as follows.

Q: 9. A three-phase overhead transmission line is being supported by three-disc suspension insulators;…

Q: (1) Name and explain any two methods for improving string efficiency. ( (i) A string of suspension…

Q: Four industrial centers are located at the corners of a square of 26 km side. The loads are 4000 kW,…

A: Given information: The length of the side of the square is 26 km. If A, B, C and D represent the…

Q: Cost of a 600 kW wind turbine is $ 550000. Other initial costs including that for installation and…

A: Given Power PR =600 kW capacity factor =CF =0.25 number of years n=20 interest rate I=5% =0.05 land…

Q: Assume that a 5 MW distribution substation experiences an annual peak load of 3500 kW. The total…

Q: A house away from the national grid requires electricity supplement. What is the best solution from…

A: As given, a house is situated away from the national grid, it is un-economical if the electricity is…

Q: 3) A resistor, in series with a 138µf capacitor is connected to a 60cycle source. If the voltage…

Q: 2.1 Two power stations, A and B, are synchronized at 66 kV. They are inter-connected by a…

Q: A construction crane is required to lift a load of 5000 kg from ground to a height of 60m in 30s.…

A: Given data -Weight of the load is,Lw=5000kgHeight from the ground is,h=60mThe diameter of the drum…

Q: A substation is supplying four towns whose peak loads are 10 MW, 5 MW, 8 MW, and 7 MW. The diversity…

Q: In Distribution Substations, the Voltage is stepped up for distribution via the Distribution Lines.…

A: 1) In distribution substations, the high voltage from the transmission lines is stepped down to a…

Q: Two power stations, A and B, are synchronized at 66 kV. They are inter-connected by a…

A: We have given the problem Two power stations, A and B, are synchronized at 66 kV. They are…

Q: The electrical power supply system of a particular country is made of the following. Draw a single…

A: Draw and represent the symbol used in the single line diagram.

Q: 1500 kvA, 3Φ star-connected alternator, 50 Hz,2300 V alternator has a resistance between each pair…

A: To calculate synchronous reactance and voltage regulation

Q: Q1) For the circuit in fig.1 the section bus-bars A and B are linked by a bus-bar reactor rated at…

Q: Electric Machine-check image, all question there. Consider the above equivalent circuit of IM. A…

A: 3-Phase Induction Motor- When a three-phase stator displaced by 120 degrees (in space of 120…

Q: Assume that a 5 MW distribution substation experiences an annual peak load of 3500 kW. The total…

A: In this question we need to find a annual load factor of the given substation .

Q: SOLVING: Determine the total current of the circuit and the required current rating based on 80%…

A: b) According to the NEC, 1. Maximum power consumes by a lighting device is 100W. 2. Power consume by…

Q: (ii) A string of suspension insulators consists of three units if the voltage across the line unit…

A: A string of suspension insulators consists of three units if the voltage across the line unit is VL…

Q: A resistor, in series with a 138-microfarad capacitor, is connected to a 60-cycle source. If the…

A: A resistor, in series with a 138-microfarad capacitor, Frequency=60Hz The voltage drop across the…

Q: 2.1 Two power stations, A and B, are synchronized at 66 kV. They are inter-connected by a…

Q: A string of four suspension insulators is connected across a 285 kV line. The self-capasjtance of…

Q: Provide three remedies useful to mitigate the poor load forecasting situation.

A: Load Forecasting It is an important parameter in Power Network to take a decision for the design,…

Q: A single phase a.c. distributor AB 300 meters long is fed from end A and is loaded as under : • 100…

Q: If R=10 ohms and L=0.05 henry are connected in series and energized by a 25 cycle sinusoidal…

A: Impedance = R +j(2×pi×frequency×inductance). Current in impedance Z = (voltage across impedance)…

Q: The single line diagram for a sample power system is as given in Fig.1. Draw a per unit reactance…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the unit load per square foot for dwelling units? See Table 220.12. __________
A 60Hz, single-phase source with V=27730 volts is applied to a circuit element. (a) Determine the instantaneous source voltage. Also determine the phasor and instantaneous currents entering the positive terminal if the circuit element is (b) a 20 resistor. (C) a 10mH inductor, and (d) a capacitor with 25 reactance.
Fill in the blanks 1. Grounding is connecting …….. of electrical equipment to earth. 2. When a …………………………….… fault occurs on an ungrounded neutral system, the potential of the healthy phases rise to the line voltage. 3. The method of reactance grounding is not used because of ……………………… appearing under fault conditions. 4. The cosine of the angle between the ………………………………………. and the ………………………………...…… is called the sending end power factor. 5. The AC power delivered to a load is equal to ………........
Four industrial centers are located at the corners of a square of 26 km side. The loads are 4000 kW, 6000 kW, 2000 kW and 7000 kW respectively. Determine the best location of the substation for feeding these loads. The reference point of load is 6000 kW.
A 210V, 50 Hz, single phase radial distribution system, the resistance of the wire is 0.0008 ohm/m supply and return. Two loads are connected and it consumes 10 and 10 A respectively and are fed from the cable at distance of 15 and 15 respectively. Calculate the voltage available across load 1 and 2
A balanced Star connected load operates at a voltage of 460V , 0.8 Power factor lagging and each phase takes a power of 8KW. Consider it as 3 - phase 3 - wire system Calculate the total impedance . Calculate the value of Resistance and Inductive Reactance per phase .
Assume the load on the substation bus drops to 240 kW and 600 magnetizing kVAR. Also assume the capacitors remain connected to the substation. 1. a) What is the magnitude of the line-to-line voltage at the generating plant that is required to maintain a line-to-line voltage of 13.8 kV at the substation? 2. b) Will this power plant voltage level cause problems for other customers?
A power transmission line of 33kV (maximum) carries a maximum current of 1200A is connecting the two areas. A PMMC voltmeter of (0-600V) range and a PMMC ammeter of (0-25A) range are to be used for measurement of voltage and currents of the transmission line. 1.Design and draw a circuit with suitable instrument transformers for the measurement. Use sample values for winding turns. 2.On a particular day, the readings shown by the meters were 17.5A and 440V. Calculate the actual voltage and current in the transmission line.
There are a number of differences between three-phase and single-phase feeding of a 78 kW system. explain which system is more advantageous by examining the % e voltage drops.
We have a 240/120V single-phase three-wire feeder circuit that powers the following loads: a 5 hp, 230V single-phase motor; a load of outlets in discontinuous operation, distributed in 37.5 A for each ungrounded conductor; a load of devices working continuously and distributed in 30 A for each ungrounded conductor; a lighting circuit that works continuously and distributed in 40 A for each conductor not grounded; a heating load of 10 kW at 240 V; a 1 hp 120V single phase motor and a 2 hp 120V single phase motor. Size the feeder conductors and the main OCPD.Size the grounded conductor
Assume that a 5 MW distribution substation experiences an annual peak load of 3500 kW. The total annual energy supplied to the primary feeder circuits is 17,000 MWh. Find the annual load factor. SUBJECT: DISTRIBUTION SYSTEM
A 4.5-kVA, 240 volt electric clothes dryer contributes _____ amperes to the neutral load , when calculating the service by the standard method